Impact strength additives

Struktol TR-016 again provided the highest increase of Izod impact strength. Addition of 2 wt% of this additive gave an Izod impact change from 106.8 to 181.6 J/m. Flexural modulus increased from 2.89 to 3.1 GPa. 

Acryhc modifiers for cement impact strength and adhesion to substrates are discussed in reference 211. Both water-soluble acryhc and acryhc emulsion polymers are used in the ceramic industry as temporary binders, deflocculants, and additive components in ceramic bodies and glazes (212) (see Ceramcs). 

DMPPO—polystyrene blends, because of the inherent flame resistance of the DMPPO component (oxygen index ca 29.5), can be made flame retardant without the use of halogenated additives that tend to lower impact strength and melt stabiUty in other polymers. Approximately one-half of total Noryl sales volume is in flame-retarded grades, ie, VO or VI in a 1.6-mm section (UL-94). 

Poly(vinyl chloride). PVC is one of the most important and versatile commodity polymers (Table 4). It is inherently flame retardant and chemically resistant and has found numerous and varied appHcations, principally because of its low price and capacity for being modified. Without modification, processibiUty, heat stabiUty, impact strength, and appearance all are poor. Thermal stabilizers, lubricants, plasticizers, impact modifiers, and other additives transform PVC into a very versatile polymer (257,258). 

The effects of release additives on bulk properties must also be carefully considered, particularly with integral additives to plastics. Eor example, partial solubiHty usually confers some plastici2ing effect. This may improve impact strength but could reduce the heat distortion temperature. Some release additives such as metallic soaps have secondary antioxidant and heat-stabiH2er benefits. Such effects are exploited in multipurpose formulations. 

The low temperature impact strength of stmctural steels was found to be significantly improved with the additions of 0.022—0.008% Te. The low (—40° C) temperature impact strength of a steel annealed at blue brittie temperature of 350°C did not show any embrittlement effect with the addition of. 002% Te (76). 

The carbon blacks used in plastics are usually different from the carbon blacks used in mbber. The effect of carbon black is detrimental to the physical properties of plastics such as impact strength and melt flow. Electroconductive grades of carbon black have much higher surface areas than conventional carbon blacks. The higher surface areas result in a three-dimensional conductive pathway through the polymer at much lower additive levels of the carbon black. The additive concentrations of electroconductive carbon blacks is usually j to that of a regular carbon black (132). 

Modifications of epichlorohydrin elastomers by radical-induced graft polymeri2ation have been reported. Incorporated monomers include styrene and acrylonitrile, styrene, maleic anhydride, vinyl acetate, methyl methacrylate, and vinyHdene chloride (81), acryHc acid (82), and vinyl chloride (81,83,84). When the vinyl chloride-modified epichlorohydrin polymers were used as additives to PVC, impact strength was improved (83,84). 

Polymers with differing morphologies respond differentiy to fillers (qv) and reinforcements. In crystalline resins, heat distortion temperature (HDT) increases as the aspect ratio and amount of filler and reinforcement are increased. In fact, glass reinforcement can result in the HDT approaching the melting point. Amorphous polymers are much less affected. Addition of fillers, however, intermpts amorphous polymer molecules physical interactions, and certain properties, such as impact strength, are reduced. 

---