Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Hydroperoxides isolation

The phenylhydrazones of benzaldehyde and its homologues, (or of acetone) are readily autoxidised in solution and rearrange to give the azo-hydroperoxides, isolable as solids which may explode after a short time on standing, though not on friction or impact [1], Contact with flame or with cone, sulfuric or nitric acids also initiates explosion [2]. [Pg.1192]

Furodysinin hydroperoxide, isolation, 134-5 Fused bicycUc 1,2-dioxanes, synthesis, 196, 197... [Pg.1463]

Since the metal-alkene association preceding the peroxymetalation reaction in mechanism (B) is a pure Lewis acid/Lewis base interaction, it would be expected that compounds having alkylperoxy groups bonded to a Lewis acid center should be active for the epoxidation of alkenes. This is indeed found for boron compounds, which are active as catalysts for the epoxidation of alkenes by alkyl hydroperoxides.Isolated boron tris(alkyl peroxides), B(OOR)3, have been shown to epoxidize alkenes stoichiometrically, presumably through alkylperoxyboration of the double bond (equation 76). "... [Pg.345]

The hydroperoxide isolated after epoxidation shows optical activity. However, the polarimetric data measured were difficult to reproduce and, moreover, the rotation data for the pure hydroperoxide enantiomer are not known because, as yet, it has not been isolated. Therefore, we determined the ratio of hydroperoxide enantiomers according to a method we have recently elaborated. In the case of prenol the e.e. is only indicated, on geraniol it is a little bit higher and using cinnamyl alcohol it reaches about 12% both in the stoichiometric and in the catalytic modification of the reaction. Of course, these results are not applicable for preparative purposes and, therefore, we intend to continue these investigations... [Pg.74]

Unsaturated lipids produce qualitatively similar products when thermally oxidized or autoxidized at low temperatures. These include a series of aldehydes, ketones, acids, esters, alcohols, hydrocarbons, lactones, cyclic compounds, dimers and polymers. However, quantitative pattern of the decomposition products formed at high temperatures is different from that of autoxidation, varying widely depending on the nature of the substrate and parameters of heat treatment (Nawar, 1985 Pokorny, 1989). Unsaturated fatty acids are much more susceptible to oxidation than their saturated analogs. According to Frankel (1980), at 25 to 80 °C, relative proportions of isomeric hydroperoxides isolated from each substrate varies with the oxidation temperature, however, their qualitative pattern remains the same. At oxidation temperatures higher than 80°C, isolation and quantitation of hydroperoxide intermediates is difficult due to their extreme heat sensitivity. Furthermore, the primary decomposition products are unstable and rapidly undergo further oxidative decomposition. As the oxidative process continues, a variety of possible reaction mecha-... [Pg.147]

A number of chemiluminescent reactions may proceed through unstable dioxetane intermediates (12,43). For example, the classical chemiluminescent reactions of lophine [484-47-9] (18), lucigenin [2315-97-7] (20), and transannular peroxide decomposition. Classical chemiluminescence from lophine (18), where R = CgH, is derived from its reaction with oxygen in aqueous alkaline dimethyl sulfoxide or by reaction with hydrogen peroxide and a cooxidant such as sodium hypochlorite or potassium ferricyanide (44). The hydroperoxide (19) has been isolated and independentiy emits light in basic ethanol (45). [Pg.265]

Long before 1,2-dioxetanones were isolated, they were proposed as key intermediates in bioluminescence (58—60). This idea led to the discovery of a number of new chemiluminescent reactions. For example, (23) reacts with to give (25). The hydroperoxide (24) has been isolated and is... [Pg.266]

Hydroxyall l Hydroperoxides. These compounds, represented by (1, X = OH, R = H), may be isolated as discreet compounds only with certain stmctural restrictions, eg, that one or both of R and R are hydrogen, ie, they are derived from aldehydes, or that R or R contain electron-withdrawing substituents, ie, they are derived from ketones bearing a-halogen substituents. Other hydroxyalkyl hydroperoxides may exist in equihbrium mixtures of ketone and hydrogen peroxide. [Pg.112]

Alkoxyall l All l Peroxides. / /f-Butyl tetrahydropyran-2-yl peroxide [28627 6-5] (1), where R = tert — butyl, X = OR", R = H, R and R" = 1, 4 butanediyl, has been isolated. This is one of many examples of alkoxyalkyl alkyl peroxides which may be prepared by reaction of hydroperoxides with vinyl ethers (139) ... [Pg.114]

The avermectins also possess a number of aUyflc positions that are susceptible to oxidative modification. In particular the 8a-methylene group, which is both aUyflc and alpha to an ether oxygen, is susceptible to radical oxidation. The primary product is the 8a-hydroperoxide, which has been isolated occasionally as an impurity of an avermectin B reaction (such as the catalytic hydrogenation of avermectin B with Wilkinson s rhodium chloride-triphenylphosphine catalyst to obtain ivermectin). An 8a-hydroxy derivative can also be detected occasionally as a metaboUte (42) or as an impurity arising presumably by air oxidation. An 8a-oxo-derivative can be obtained by oxidizing 5-0-protected avermectins with pyridinium dichromate (43). This also can arise by treating the 8a-hydroperoxide with base. [Pg.283]

A recent communication described the cleavage of 17a-hydroperoxy-20-keto steroids with base to give 17-ketoandrostanes in good yield. Since such hydroperoxides are now accessible from 20-ketopregnanes in one step vide infra), this constitutes a convenient two-step degradation process. In practice, the intermediate hydroperoxide need not be isolated. Other enolizable... [Pg.156]

The intermediate hydroperoxide is sufficiently stable to be isolated, and reduction with any one of a number of reagents (zinc-acetic acid is preferred) then gives the 17a-hydroxy-20-keto compound. [Pg.198]

The phenomenon that early transition metals in combination with alkyl hydroperoxides could participate in olefin epoxidation was discovered in the early 1970s [30, 31]. While m-CPBA was known to oxidize more reactive isolated olefins, it was discovered that allylic alcohols were oxidized to the corresponding epoxides at the same rate or even faster than a simple double bond when Vv or MoVI catalysts were employed in the reaction [Eq. (2)] [30]. [Pg.192]

The deprotonated flavin in the complex is readily attacked by molecular oxygen at C4a, giving 4a-hydroperoxide of the flavin-luciferase complex (intermediate A). This complex is an unusually stable intermediate, with a lifetime of tens of seconds at 20°C and hours at subzero temperatures, allowing its isolation and characterization (Hastings et al., 1973 Tu, 1979 Balny and Hastings, 1975 Vervoort et al., 1986 Kurfuerst et al., 1987 Lee et al., 1988). [Pg.38]

The last step is hydrolysis of the unstable hemiacetal. Alkoxycarbocation intermediates (73, R=alkyl) have been isolated in superacid solution at low temperatures, and their structures proved by The protonated hydroperoxides... [Pg.1419]

Younes, M. and Strubelt, O. (1990). The role of iron and glutathione in t-butyl hydroperoxide-induced damage towards isolated perfused rat livers. J. Appl. Toxicol. 10, 319-324. [Pg.174]

Organic peroxides such as cumene hydroperoxide and t-butyl hydroperoxide have extensively been used as experimental agents. They provoke lipid peroxidation in hepatocytes, probably by the generation of alkoxyl and peroxyl radical intermediates after reaction with cytochrome P450. Other cytotoxic mechanisms are probably involved including protein thiol and non-protein thiol oxidation and deranged calcium homeostasis (Jewell et al., 1986). In fact, the addition of cumene hydroperoxide to isolated bUe duct cells, devoid of cytochrome P450 activity, still results in cell death but lipid peroxidation is not detectable (Parola et al., 1990). [Pg.241]

Results of the cyclohexane oxidation tests are shown in Table 41.4. Mono-oxygenated products are cyclohexanone, cyclohexanol and cyclohexyl hydroperoxide. Cu and Cr were very active, but subsequent tests showed considerable leaching for both metals, whereas Co-Si-TUD-1 did not show ai r leaching. Tests with different Co loadings indicate that the lowest Co concentration has the best conversion and ketone selectivity. Isolated cobalt species are most efficient for the conversion of cyclohexane, as agglomeration of Co reduces... [Pg.374]

Peroxide ring closures were effected by stirring the 2,3-dibromocycloalkyl hydroperoxides with silver trifluoroacetate, and the bromo-substituted bicyclic peroxides were isolated by silica chromatography at —25 °C. Yields (based on 2-cycloalkenyl hydroperoxide) of 56 and 38% were achieved respectively for the [3.2.1]- and [4.2.11-compounds, but only 16% of the [2.2.1]- and 13% of the [5.2.1]-peroxide was obtained. The main reason for the low yield of the [2.2.1]-peroxide was that substitution by trifluoroacetate, which competes with the desired dioxabicyclization, is particularly prevalent with the 5-membered ring. [Pg.138]

As the first isolable intermediate in the bioconversion of arachidonic acid into prostaglandins and thromboxanes (Eq. 3), PGG2 is a bicyclic peroxide of immense biological importance. It is difficult to obtain pure from natural sources and the presence of the 15-hydroperoxide group adds a further dimension of chemical lability to that associated with the 9,11-peroxide bridge. The chemical synthesis of PGG2 is thus a landmark in prostaglandin chemistry. It also represents a pinnacle of success for the silver-salt route to bicyclic peroxides. [Pg.144]

The complex formation between hydroperoxides and HALS derivatives proposed for the preceding reaction was recently postulated by two different groups of investigators. First, Carlsson determined a complex formation constant for +00H and a nitroxide on the basis of ESR measurements—. Secondly, Sedlar and his coworkers were able to isolate solid HALS-hydroperoxide complexes and characterize them by IR measurements. The accelerated thermal decomposition of hydroperoxides observed by us likewise points to complex formation. It is moreover known that amines accelerate the thermal decomposition of hydroperoxides-. Thus Denisov for example made use of this effect to calculate complex formation constants for tert.-butyl hydroperoxide and pyridineitZ.. [Pg.86]


See other pages where Hydroperoxides isolation is mentioned: [Pg.494]    [Pg.512]    [Pg.494]    [Pg.512]    [Pg.204]    [Pg.437]    [Pg.98]    [Pg.111]    [Pg.112]    [Pg.73]    [Pg.286]    [Pg.195]    [Pg.920]    [Pg.1055]    [Pg.1418]    [Pg.1524]    [Pg.1528]    [Pg.108]    [Pg.25]    [Pg.31]    [Pg.46]    [Pg.1130]    [Pg.1138]    [Pg.14]    [Pg.18]    [Pg.20]    [Pg.253]   
See also in sourсe #XX -- [ Pg.308 ]




SEARCH



© 2024 chempedia.info