Honing stone

Honing Honing stone roughing finishing surface finish roundness 4 0.0005... 

Structural bonding. Tough structural bonds can be achieved with some anaerobic adhesives for bonding components such as ferrite magnets, honing stones, identification tags, and decorative inserts. 

The cross hatch angle a is defined as the angle The contact pressure of the honing stones between the cutting speeds -i- and —with against the workpiece is realized by the axial... 

The honing pressure p results from the distribution of the normal force on the contact surface of the honing stones ... 

The resultant force is calculated by the magnitude of the sum vector of axial, tangential, and with the honing stone length 1 and width bh. In normal force. general the honing stone length should be about... 

Furthermore, it could be shown that the temperature increase of fhe tool may represent a limiting criterion for the process design particularly at high material removal rates. The amount of heaf induced info fhe maferial at constant removal mechanisms is hereby not defined by fhe maferial removal rate, but by the effect induced into the active zone. If fhe heaf removal is improved or if a higher heat-resisfant fixing is used for fhe honing stones on the tool, it can be presumed that the material removal can be further increased. 

In addition, soft-bound honing stones quickly adjust to the contour shape without breaking them. The selection of honing stones depends on the material. Soft-bound stones are used in annealed steels and hard-bound stones are used in hardened steels. The most common honing stones are the aluminum oxide stones, oxide ceramic grinding files, or SiC stones. Qualities should be preferred, which are used with suspension. 

FIGURE 4.67 Using a honing stone in processing an outer radius... 

Interruptions on the workpiece surface, for example key seats and holes, reduce the quality of finish. Can be offset by increasing rotary speed of honing stone. 

---