Homogeneous phase behavior

Ternary Blends. Discussion of polymer blends is typically limited to those containing only two different components. Of course, inclusion of additional components may be useful in formulating commercial products. The recent Hterature describes the theoretical treatment and experimental studies of the phase behavior of ternary blends (10,21). The most commonly studied ternary mixtures are those where two of the binary pairs are miscible, but the third pair is not. There are limited regions where such ternary mixtures exhibit one phase. A few cases have been examined where all three binary pairs are miscible however, theoretically this does not always ensure homogeneous ternary mixtures (10,21). 

Exploitation of Homogeneous Azeotropes Homogeneous azeotropic distillation refers to a flowsheet structure in which azeotrope formation is exploited or avoided in order to accomplish the desired separation in one or more distillation columns. The azeotropes in the system either do not exhibit two-hquid-phase behavior or the hquid-phase behavior is not or cannot be exploited in the separation sequence. The structure of a particular sequence will depend on the geometry of the residue curve map or distillation region diagram for the feed mixture-entrainer system. Two approaches are possible ... 

Compounds lb and 2b were the Urst fluorinated ligands tested in Mn-catalyzed alkene epoxidation [5,6]. The biphasic Uquid system perfluorooc-tane/dichloromethane led to excellent activity and enantioselectivity (90% ee) in the epoxidation of indene with oxygen and pivalaldehyde (Scheme 1, Table 1). In addition, the fluorous solution of the catalyst was reused once and showed the same activity and selectivity. This represents a considerable improvement over the behavior in the homogeneous phase, where the used catalyst was bleached and reuse was impossible. Unfortunately, indene was the only suitable substrate for this system, which failed to epoxidize other alkenes (such as styrene or 1,2-dihydronaphthalene) with high enantioselectivity. The system was also strongly dependent on the oxidant and only 71% ee was obtained in the epoxidation of indene with mCPBA at - 50 °C. 

Molecular architecture modifies the phase behavior of block copolymers. In block copolymers, macrophase separation is prevented by the connectivity of the polymer chains. The transition from a homogeneous melt to a heteroge-... 

As discussed in previous chapters, the phase behavior with changing temperature and pressure may be strongly influenced by small concentration gradients in multi-component systems already. Therefore, experimental control should take this into account. It is a common practice to use reactors with glass or sapphire windows. The transition of an inhomogeneous multiphase system to a homogeneous one can be observed visually as cloud point (Sect. 2.2, with the pressure and temperature values being monitored. 

The hydrolysis of lipids rarely occurs in a single homogeneous phase, and the behavior of lipases at membrane-solvent and micelle-solvent interfaces has been discussed in detail by Verger and Jain et aP See Micellar Catalysis... 

Material transport is usually associated with thermal transport except in situations involving homogeneous phases which can be treated as ideal solutions (L4). For this reason it is necessary to consider the behavior of combined thermal and material transport in turbulent flow. The evaporation of liquids under macroscopic adiabatic conditions is a typical example of such a phenomenon. Under such circumstances the behavior in the boundary layer is similar to that found in the field of aerodynamics in a blowing boundary layer (S4). However, it is not... 

In the hatched two-phase region of limited miscibility, the system separates heterogeneously into water-rich and nicotine-rich layers. However, at temperatures below the lower consolute point (about 61°C) or above the upper consolute point (about 210°C), the components become miscible in all proportions, resulting in a uniform homogeneous phase. The molecular-level origins of this extraordinary behavior, as well as more general aspects of consolute behavior in other (typically, hydrogen-bonded) systems, remain deeply obscure. 

---