Homoallylic amine

The carbopalladation is extended to homoallylic amines and sulfides[466. Treatment of 4-dimethylamino-l-butene (518) with diethyl malonate and Li2PdCl4 in THF at room temperature leads to the oily carbopalladated complex 519, hydrogenation of which affords diethyl 4-(dimethylamino) butylmalonate (520) in an overall yield of 91%. Similarly, isopropyl 3-butenyl sulfide (521) is carbopalladated with methyl cyclopentanonecarboxylate and Li2PdCl4. Reduction of the complex affords the alkylated keto ester 522 in 96% yield. Thus functionalization of alkenes is possible by this method. 

Scheme 1). Introduction of a jt bond into the molecular structure of 1 furnishes homoallylic amine 2 and satisfies the structural prerequisite for an aza-Prins transform.4 Thus, disconnection of the bond between C-2 and C-3 affords intermediate 3 as a viable precursor. In the forward sense, a cation ji-type cyclization, or aza-Prins reaction, could achieve the formation of the C2-C3 bond and complete the assembly of the complex pentacyclic skeleton of the target molecule (1). Reduction of the residual n bond in 2, hydro-genolysis of the benzyl ether, and adjustment of the oxidation state at the side-chain terminus would then complete the synthesis of 1. 

The addition of allylboronates 1 to the chiral oxime 2 results in the formation of a hydroxyl-amine. This is a general method for the subsequent reductive generation of primary homoallyl-amines, but with poor diastereoselectivity in the case of 3 and 4. A diastereomeric ratio of 90 10 is achieved in the addition reaction, using the chiral allylboronate 59 (double stcrcodifferenti-ation). 

Iminium ions, generated in aqueous solution from secondary amines and formaldehyde, undergo a Barbier-type allylation mediated by tin, aluminum, and zinc. The reaction is catalyzed by copper and produces tertiary homoallylamines in up to 85% yield.67 The imines generated in situ from 2-pyridinecarboxaldehyde/2-quinolinecarboxaldehyde and aryl amines undergo indium-mediated Barbier allylation in aqueous media to provide homoallylic amines.68 Crotyl and cinnamyl bromides... 

The reaction is also applicable to a wide structural variety of 1,3-dienes, as demonstrated by the reaction of 2-furfural-p-anisidine imine (Table 9). All dienes react with the aldimine regioselectively at the diene termini bearing the highest electron densities and provide bis-homoallyl amines with excellent 1,3-syn diastereoselectivity. No C4-adducts are formed in these reactions. 

In 2001, the preparation of allylytterbium bromide and the synthesis of homoallylic alcohols using allylytterbium bromide were reported.39 393 Ytterbium metal was found to be activated by a catalytic amount of Mel at 0 °C in THF to produce allylytterbium bromide 66 (Equation (11)). The allylation reaction of a wide range of aromatic aldehydes and ketones proceeded at ambient temperature or less in good to high yields (Table 2). Imines also reacted with allylytterbium bromide to afford homoallyl amines (Table 3). 

Alkenylzirconium reagents generated from alkynes and the Schwartz reagent react with aldimines under mild conditions in the presence of [RhCl(COD)]2 to give homoallylic amine derivatives (Equation (63)).418... 

Ytterbium triflate [Yb(OTf)3] combined with TMSG1 or TMSOTf are excellent reagents for the conversion of a-methyl styrene and tosyl-imines into homoallylic amides 32 (Equation (19)) (TMS = trimethylsilyl).29 These conditions produce the first examples of intermolecular imino-ene reactions with less reactive imines. Typically, glyoxalate imines are necessary. A comprehensive examination of the lanthanoid metal triflates was done and the activity was shown to directly correlate with the oxophilicity scale. The first report used preformed imines, and subsequently it was found that a three-component coupling reaction could be effected, bypassing the isolation of the intermediate imine.30 Particularly noteworthy was the successful participation of aliphatic aldehydes to yield homoallylic amines. 

Homoallylic amine formation resulting from a change in the mode of addition of reagents. 

Figure 4.12. A chair-like transition state favoring onti -homoallylic amines.

The synthesis of optically active compounds by the diastereoselective reaction of allyltitanium reagents with chiral electrophiles has also been reported. The reaction of allyltitanium reagents with chiral imines proceeds with excellent diastereoselectivity, as shown in Eq. 9.28, thus providing a new method for synthesizing optically active homoallylic amines with or without a P-substituent [51,52],... 

Asymmetric reactions have also been developed. The reactions of allyltitaniums with chiral aldimines derived from optically active 1-phenylethylamine afford optically active homoallylic amines with excellent diastereofacial selectivities. Thus, the Cram syn addition products are obtained highly predominantly when using crotyltitanium reagent 33, as exemplified in Scheme 13.30 [61]. 

Cyclic a-amino acids with an enamine pattern can be obtained upon enantioselective hydrogenation followed by a hydroformylation/cyclization sequence in a single-pot version Rh(I)-DuPHOS acts as a catalyst for both steps, the enantioselective hydrogenation of prochiral dienamides and the hydroformylation of the resulting homoallylic amines (Scheme 13) [52,53]. 

Homoallylic amines result from the reaction of aldimines, previously activated by boron trifluoride etherate, with allylic bromides in the presence of chromium(II) chloride, e.g. equation 68194. 

An electroreductive Barbier-type allyla-tion of imines (434) with allyl bromide (429) also occurs inaTHF-PbBr2/Bu4NBr-(Al/Pt) system to give homoallyl amine (436) (Scheme 151) [533]. The combination of Pb(II)/Pb(0) redox and a sacrificial metal anode in the electrolysis system plays a role as a mediator for both cathodic and anodic electron-transfer processes. The metals used in the anode must have a less positive anodic dissolution potential than the oxidation potentials of the organic materials in order to be present or to be formed in situ. In addition, the metal ion plays the role of a Lewis acid to form the iminium ion (437) by associating with imine (435) (Scheme 151). 

An allylboronate (21) reacts with imines in good yield to give homoallylic amines and 0 -methylene-y-lactams with high ee ... 

Several related reations are summarized in Scheme 4.13. When a nucleophilic OH or NH2 group exists at the proper position of the olefinic substrate, cyclohy-drocarbonylation provides a lactone or a lactam. Allyl alcohols" " and homoallyl amines are converted into y-lactones and 8-lactams in high enantiomeric excesses. Thiol is employable as a nucleophile for hydrocarbonylation of a C—C double bond. A successful catalytic carbonylation is reported for hydrothiocarbonylation. ... 

Iodine is known to catalyze the condensation of aldehydes, benzyl carbamate and allyltrimethylsilane to homoallylic amines. However, in this case the involvement of an in sitn prepared [MejSi] species was suggested to be the active catalyst [235], An iodine catalyzed acetalization of carbonyl compounds was reported, where the active catalyst was believed to be hydroiodic acid [236],... 

In order to further extend the generality of our method, a functionalized allylsilane was also reacted with sulfone It. Under the same optimized conditions, the corresponding homoallylic amine was obtained and subsequently subjected to... 

Scheme 5 Allylation of Alloc-derived sulfones and ring-closing metathesis of an Alloc-protected homoallylic amine...

The development of new methods for the synthesis of homoallylic amine derivatives is an important area of synthetic efforts. Homoallylic amines are extremely important compounds as biologically active molecules [1], The Lewis acid-mediated reactions of imines with allyl silanes are among the most efficient for... 

Table 8 Bismuth-mediated three-component allylation reaction synthesis of iV-protected homoallylic amines...

---