High-temperature proton exchange

Song, Y, Wei, Y, Xu, H., Williams, M., Liu, Y., Bonville, L. J., Kunz, H. R., and Fenton, J. M. Improvement in high-temperature proton exchange membrane fuel cells cathode performance with ammonium carbonate. Journal of Power Sources 2005 141 250-257. [Pg.105]

Korishko YN, Fedorov VA, Feoktistova OY (2000) LiNbOS Optical waveguide fabrication by high-temperature proton exchange. J Lightwave Technol 18 562-568... [Pg.52]

Figure 9.12 depicts the profiles of feed-side H2 concentrations on the dry and wet bases. As depicted in this figure, the membrane reactor could enhance H2 concentration from 45.30% to 54.95% (on dry basis), that is, from 41% to 49.32% (on wet basis). In this case, the H2 recovery calculated from the model was 97.38%. With the advancement of the high-temperature proton exchange membrane fuel cell (120-160 °C), it is expected that the constraint of CO concentration can be relaxed to about 50 ppm in the near future. Then, the required hollow-fiber number could be reduced significantly to 39,000 based on the modeling results. [Pg.400]

Das SK, Reis A, Berry KJ (2009) Experimental evaluation of CO poisoning on the performance of a high temperature proton exchange membrane fuel cells. J Power Sources 193 691-698... [Pg.100]

Quinfeng L, Jensen JO, Savinell RF, Bjerrum NJ (2009) High temperature proton exchange membranes based on polybenzimidazoles for fuel cells. Prog Polym Sci 34 339 77... [Pg.100]

L. Paturzo, A. Basile, A. lulianelh, J. C. Jansen, I. Gatto, and E. Passalacqua. High temperature proton exchange membrane fuel cell using a sulfonated membrane obtained via H2SO4 heatment of PEEK-WC. Catal. Today, 104 (2-4) 213-218, June 2005. [Pg.236]

Bose S, Kuila T, Thi XLN, Kim NH, Lau KT, Lee JH (2011) Polymer membranes for high temperature proton exchange membrane fuel cell recent advances and challenges. Prog Polym... [Pg.98]

He R, Li Q, Jensen JO, Bjerrum NJ (2007) Eloping phosphoric acid in polybenzimidazole membranes for high temperature proton exchange membrane fuel cell. J Polym Sci Pol Chem... [Pg.225]

Badami AS, Roy A, Lee HS, Li Y, McGrath JE. Morphological investigations of disulfonated poly(arylene ether sulfone)-fe-naphthalene dianhydride-based polyimide multiblock copolymers as potential high temperature proton exchange membranes. J Membr Sci 2009 328 (l-2) 156-64. [Pg.205]

So SY, Yoon YJ, Kim TH, Yoon K, Hong YT. Sulfonated poly(arylene ether sulfone)/functionalized silicate hybrid proton conductors for high-temperature proton exchange membrane fuel cells. J Membr Sci 2011 381(l-2) 204-10. [Pg.206]

Afi, S.T., Leabek, J., Nielsen, L.P., Mathiasen, C., Moller, P. and Kaer, S.K. 2010. Thin film thermocouples for in situ membrane electrode assembly temperature measurements in a polybenzimidazole-based high temperature proton exchange unit cell. [Pg.204]

Figure 4. Lifetime lest of a FBI cell under continuous operation at a constant voltage 0.5V and different temperatures with hydrogen and oxygen at ambient pressure. The membrane was fabrieated from linear polymer with an average molecular weight of about 25.000 g mol. Reprinted from Q. Li, J. O. Jensen, R. F. Savinell and N. J. Bjerrum, High temperature proton exchange membranes based on polybenzimidazoles for fuel eells. Progress in Polymer Science, 34 (2009) 449-477. Copyright (2009) with permission from Elsevier.

C.H. Shen, S.L.C. Hsu, Synthesis of novel cross-linked polybenzimidazole membranes for high temperature proton exchange membrane fuel cells, J. Membr. Sci. 443 (1) (2013) 138-143. [Pg.266]

Jiao, K. and Li, X. (2010) A three-dimensional non-isothermal model of high temperature proton exchange membrane fuel cells with phosphoric acid doped polybenzimidazole membranes. Fuel Cells, 10, 351. [Pg.836]

Puffer RH Jr, Rock SJ (2009) Recent advances in high temperature proton exchange membrane fuel cell manufacturing. J Fuel Cell Sci Technol 6(4) 041013/l-041013/7... [Pg.430]

Development of high-temperature proton exchange membranes and catalysts for HT-PEMFCs are equally important in terms of the long-term sustainability of fuel cell technology and commercialization. Based on a review of the literature as well as our understanding, we would like to suggest several future research topics for high-temperature catalyst development ... [Pg.878]

Liao J, Li QF, Rudbeck HC et al (2011) Oxidative degradation of polybenzimidazole membranes as electrolytes for high temperature proton exchange membrane fuel cells. Fuel Cells 11 745-755... [Pg.88]

Mao L, Mishra AK, Kim NH et al (2012) Poly (2,5-benzimidazole)-silica nanoetnnposite mcanhranes for high temperature proton exchange mcanhrane fuel cell. J Membr Sci 411 12 91-98... [Pg.88]

Plackett D, Siu A, Li Q et al (2011) High-temperature proton exchange membranes based on polybenzimidazole and clay composites for fuel cells. J Membr Sci 383 78-87... [Pg.88]

Wang S, Zhang G, Han M et al (2011) Novel epoxy-based cross-linked polybenzimidazole for high temperature proton exchange membrane fnel cells. Int J Hydrogen Energy 36 8412-8421... [Pg.88]

Aili D, Li Q, Christensen E et al (2011) Crosslinking of polybenzimidazole membranes by divinylsulfone post-treatment for high-temperature proton exchange membrane fuel cell applications. Polym Int 60 1201-1207... [Pg.88]

Noye P, Li QF, Pan C et al (2008) Cross-linked polybenzimidazole membranes for high temperature proton exchange membrane fuel cells with dichloromethyl phosphoric acid as a cross-linker. Polym Adv Technol 19 1270-1275... [Pg.88]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...