High flux tubes

Linde Div., Union Carbide Corp., bulletins related to high flux tubing. 

Jacobs, J. L., P. S. O Neill, and E. G. Ragi, Effective Use of High Flux Tubing in Two-Phase Heat Transfer, AlChE 86th National Meeting Session 83, Houston, April (1979). 

It was reported [95] that fouling on low-finned tubes in reboilers may occur at a reduced rate compared to plain tubes. Also, the use of porous enhancements (porous coatings, high flux tube) demonstrates strong resistance to fouling. 

Kev>erse Osmosis (RO) Membranes A type of membrane system for treating oily wastewater is currently undergoing commercialization by Bend Research, Inc. The system uses a tube-side feed module that yields high fluxes while being able to handle high-sohds-content waste streams (Ref. 25). Another type of reverse osmosis technique is being designed to yield ultrapurified HF recovered from... 

Soft ferrites are used for the manufacture of inductor cores (pot cores) for telecommunications, low-power transformers and high-flux transformers such as television line output transformers, and as television tube scanning yokes (Fig. 9.17). The more important material characteristics for these and other applications are now discussed with emphasis on the influence of composition and microstructure. The review paper by A. Broese van Groenou et al. [9] and the monograph by E.C. Snelling [10] are recommended to supplement the discussion. 

Coated wall annular reactors (Figure 12) are characterized by a thin film of photocatalyst located either on the outer side of inner tube or on the inner side of the outer tube. There are many reasons for preferring the inner side of the outer tube for the coating. The first reason has to do with the flux if is known that at high flux of lighf (>l-2 mW cm ) fhe quantum efficiency is proportional to 1 divided by the square root of fhe intensity. Hence, it is... 

---