High design features

The precious metal or metal oxide imparts high intrinsic activity, the carrier provides a stable, high surface area for catalyst dispersion, and the mechanical support gives a high geometric surface area for physical support and engineering design features (20). Only the correct combination of these... 

Membrane System Design Features For the rate process of permeation to occur, there must be a driving force. For gas separations, that force is partial pressure (or fugacity). Since the ratio of the component fluxes determines the separation, the partial pressure of each component at each point is important. There are three ways of driving the process Either high partial pressure on the feed side (achieved by high total pressure), or low partial pressure on the permeate side, which may be achieved either by vacuum or by introduc-... 

Appropriate design features may include feed-forward temperature control, high temperature alarms, high-temperature cutouts to stop feed flow and open a vent to atmospheric or closed system, adequate temperature monitoring through catalyst beds, etc. 

This study (NUREG/CR-2497) applies PSA techniques using operating experience to identify the high-risk features of plant design and operation. The operating experience base is derived from die licensee event repoits (LERs) to find multiple events that, when coupled with postulated events, lead to plant conditions that could eventually result in severe core damage. 

There are many design features and styles of safety relief valves, such as flanged ends, screwed ends, valves fitted internally for corrosive service, high temperature service, cryogenic service/low temperatures, with bonnet or without, nozzle entrance or orifice entrance, and resistance to discharge piping strains on body. Yet most of these variations have little, if anything to do with the actual performance to relieve overpressure in a system/vessel. 

Expansion turbines are related in many design features to the centrifugal compressor. The key exception being that the turbine receives a high pressure gas for expansion and power recovery to a lower pressure and is usually accompanied by the recovery of the energy from the expansion. For example, applications can be (1) air separation plants (2) natural gas expansion and liquefaction (for gas let-down in pipeline transmission to replace throttle valves where no... 

On-site treatment in batch reactors using refinery and wood-preserving waste added to soil resulted in highly variable loss of PAHs over a year (Aprill et al. 1990). An extensive study (Ellis et al. 1991) examined a number of design features, and the relative merits of on-site and off-site treatments of a... 

---