Heating, ventilating and

Carrier, Cherne, Grant, and Roberts, Modern Air Conditioning, Heating, and Ventilating, 3d ed., p. 531, Pitman, New York, 1959. 

Correct storage requirements, procedures (e.g., first in, first out) and conditions such as temperature control issues including insulation, cooling, heating and ventilation need to be determined and implemented. 

Repin, N. N. 1938. Method of ventilation design for chemical industry. Heating and Ventilating, nos. 4-5. 

Shilkrot, E. O. 1993. Determination of design loads on room heating and ventilation systems using the method of zone-by-zone balances. ASHRAE Transactions, vol. 99, no. 1. 

Bogoslovski, V. N. 1976. Heating and Ventilation. Part 2 Ventilation (in Russian). Stroizdat, Moscow. 

Frean, D. H., and N. S. Billington. 1955. The ventilating air jets, journal of the Institution of Heating and Ventilating Engineers, December. 

Baharev, V. A., and V. N. Troyanovsky. 1958. The Basis of Heating and Ventilating Systems with the Concentrated Air Supply Design and Calculation. Profiz.dat, Moscow. 

Sadovskaya, N. N. 1950. Studies of air circulation in the. spaces with heating and ventilating by concentrated air jet supply. Ph.D. thesis. VNIIOT VtsSPS, Leningrad. 

Holmes, M. J., and E. Sachariewicz. 1973. The Effect of Ceiling Beams and Light fittings on Ventilating Jets. Heating and Ventilating Research Association Laboratory Report No. 79. Bracknell, UK. 

Maksimov, G.. A., and V. V. Der ugin. 1972. Air Movement in Heated and Ventilated Spaces. LLSI, Leningrad. 

TsNUProrazdanii. 1984. Recommendations on Heating and Ventilating Systems Design with Directing Nozzles. Central Research Institute for Industrial Buildings, Moscow. 

Once the information on the industrial processes and space requirements, the indoor climate requirements for workers, machinery, and products, and a lot for the factory have been obtained, then the architectural design of the industrial enclosure can be accomplished, A complete factory or industrial building may consist of several enclosures where industrial processes are run. One heating and ventilation plant may service several enclosures, or there may be a separate system for each enclosure. 

Hensen J. L. M. On the thermal interaction of building structure and heating and ventilating system. Thesis, Technical University of Eindhoven, The Netherlands, 1991. 

Olmstead, P. J., Selecting Centrifugal Pumps, Heating and Ventilating, Feb.. 1946. 

By permission, John M. Kane, Operation, Application and Effectiveness of Dust Collection Equipment, Heating and Ventilating. Aug. 1952, Ref. (10)... 

Figure 12-142. ASHVE Friction chart for air in duct. (Used by permission Heating, Ventilating and Air Conditioning Guide, 1949. American Society of Heating and Ventilating Engineers, reprinted with permission Air Movement and Control Association International, Inc. All rights reserved.)...

Ductwork Specification DW142, HVCA (Heating and Ventilation Contractors Association). 

DiAMANT, R. M. E., Insulation Deskbook, Heating and Ventilating Pnblications, Croydon, 1977... 

Conrses in Contract Management are rnn by the Heating and Ventilating Contractors Association, Eondon. 

A big advantage of such systems is however that heating and ventilation can be done at the same time. 

This may be high, since in most of the processing areas large amounts of heat will be released from the equipment and the temperature in the warehouse need not exceed 50°F. Over the whole year the power requirement for heating and ventilating will be around 90 kw. 

Giphshman, I. N., and V. M. Levinson, 1966, Disturbances in Flow Stability in the Pendent Superheater of the TPP-110 Boiler, Teploenergetika 73(5) 45-49 (Translated by the Heating and Ventilating Research Association, Pergamon Press, Oxford, England). (6)... 

In areas where the highest indoor Rn-222 concentrations were measured, the source term was studied at the site. Houses with high concentration were inspected visually, especially the basement, and the heating and ventilation system was discussed with the householders. Field measurements of Rn-222 exhalation rates were perfored near the houses and at furture building sites in the municipality. 

---