Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Frictional coefficients theory

In liquid solution. Brownian motion theory provides the relation between diffiision and friction coefficient... [Pg.849]

The various physical methods in use at present involve measurements, respectively, of osmotic pressure, light scattering, sedimentation equilibrium, sedimentation velocity in conjunction with diffusion, or solution viscosity. All except the last mentioned are absolute methods. Each requires extrapolation to infinite dilution for rigorous fulfillment of the requirements of theory. These various physical methods depend basically on evaluation of the thermodynamic properties of the solution (i.e., the change in free energy due to the presence of polymer molecules) or of the kinetic behavior (i.e., frictional coefficient or viscosity increment), or of a combination of the two. Polymer solutions usually exhibit deviations from their limiting infinite dilution behavior at remarkably low concentrations. Hence one is obliged not only to conduct the experiments at low concentrations but also to extrapolate to infinite dilution from measurements made at the lowest experimentally feasible concentrations. [Pg.267]

Like the analogous parameter P in the theory of the frictional coefficient, 4> is seen to be independent of the characteristics of the given chain molecule beyond the requirement that its spatial form be that characteristic of a randomly coiled chain molecule. [Pg.611]

Theory presented earlier in this chapter led to the expectation that the frictional coefficient /o for a polymer molecule at infinite dilution should be proportional to its linear dimension. This result, embodied in Eq. (18) where P is regarded as a universal parameter which is the analog of of the viscosity treatment, is reminiscent of Stokes law for spheres. Recasting this equation by analogy with the formulation of Eqs. (26) and (27) for the intrinsic viscosity, we obtain ... [Pg.626]

The friction coefficient of a large B particle with radius ct in a fluid with viscosity r is well known and is given by the Stokes law, Q, = 67tT CT for stick boundary conditions or ( = 4jit ct for slip boundary conditions. For smaller particles, kinetic and mode coupling theories, as well as considerations based on microscopic boundary layers, show that the friction coefficient can be written approximately in terms of microscopic and hydrodynamic contributions as ( 1 = (,(H 1 + (,/( 1. The physical basis of this form can be understood as follows for a B particle with radius ct a hydrodynamic description of the solvent should... [Pg.117]

Numerous turbulent mass-transfer relationships are given in Eqs. (39)-(50), Table VII. Although the most important ones in practical applications are those for channels and tubes, several other configurations also have been investigated because of their hydrodynamic interest. Generally, it is not possible to predict mass-transfer rates quantitatively by recourse to turbulent flow theory. An exception to this is for the region of developing mass transfer, where a Leveque-type correlation between the mass-transfer coefficient and friction coefficient/can be established ... [Pg.269]

In addition to the Rouse model, the Hess theory contains two further parameters the critical monomer number Nc and the relative strength of the entanglement friction A (0)/ . Furthermore, the change in the monomeric friction coefficient with molecular mass has to be taken into account. Using results for (M) from viscosity data [47], Fig. 16 displays the results of the data fitting, varying only the two model parameters Nc and A (0)/ for the samples with the molecular masses Mw = 3600 and Mw = 6500 g/mol. [Pg.32]

Another microscopic approach to the viscosity problem was developed by Gierer and Wirtz (1953) and it is worthwhile describing the main aspects of this theory, which is of interest because it takes account of the finite thickness of the solvent layers and the existence of holes in the solvent (free volume). The Stokes-Einstein law can be modified using a microscopic friction coefficient ci micro... [Pg.228]

The theoretical prediction of these properties for branched molecules has to take into account the peculiar aspects of these chains. It is possible to obtain these properties as the low gradient Hmits of non-equilibrium averages, calculated from dynamic models. The basic approach to the dynamics of flexible chains is given by the Rouse or the Rouse-Zimm theories [12,13,15,21]. How-ever,both the friction coefficient and the intrinsic viscosity can also be evaluated from equilibrium averages that involve the forces acting on each one of the units. This description is known as the Kirkwood-Riseman (KR) theory [15,71 ]. Thus, the translational friction coefficient, fl, relates the force applied to the center of masses of the molecule and its velocity... [Pg.56]

Historically, one of the central research areas in physical chemistry has been the study of transport phenomena in electrolyte solutions. A triumph of nonequilibrium statistical mechanics has been the Debye—Hiickel—Onsager—Falkenhagen theory, where ions are treated as Brownian particles in a continuum dielectric solvent interacting through Cou-lombic forces. Because the ions are under continuous motion, the frictional force on a given ion is proportional to its velocity. The proportionality constant is the friction coefficient and has been intensely studied, both experimentally and theoretically, for almost 100... [Pg.407]

The first microscopic theory for ionic friction in polar solvents was proposed by Wolynes, " in which the ion—solvent interactions were partitioned into short-range repulsive and long-range attractive components. The friction coefficient in the Wolynes model is simplified into the following two terms ... [Pg.407]

Combining the above descriptions leads to a picture that describes the experimentally observed concentration dependence of the polymer diffusion coefficient. At low concentrations the decrease of the translational diffusion coefficient is due to hydrodynamic interactions that increase the friction coefficient and thereby slow down the motion of the polymer chain. At high concentrations the system becomes an entangled network. The cooperative diffusion of the chains becomes a cooperative process, and the diffusion of the chains increases with increasing polymer concentration. This description requires two different expressions in the two concentration regimes. A microscopic, hydrodynamic theory should be capable of explaining the observed behavior at all concentrations. [Pg.47]

This chapter summarizes important data for intrinsic viscosity and translational friction coefficient of polypeptides. The first half of the chapter discusses the data obtained in helicogenic solvents and in helix-breaking solvents. It is actually a supplement to the review article by Benoit et al. (61), in which such data published by 1967 were surveyed critically. The second half of the chapter is concerned with the helix-coil transition region. The context here is largely descriptive because of the lack of relevant theory. [Pg.109]

The number of beads in the model macromolecule is n, and is the Stokes law friction coefficient of each bead. The are to be evaluated for each macromolecule in its own internal coordinate system, with origin at the molecular center of gravity and axes (k = 1,2,3) lying along the principal axes of the macromolecule. The coordinates of the ith bead in this frame of reference are (x ]),-, (x2)i, and (x3)f. The averaging indicated by < > is performed over all macromolecules in the system. Thus, < i + 2 + 3) is simply S2 for the macromolecules. The viscosity is therefore identical, for all free-draining models with the same molecular frictional coefficient n and the same radius of gyration, to the expression from the Rouse theory ... [Pg.35]

The terminal spectrum is furnished by cooperative motions which extend beyond slow points on chain in the equivalent system. The modulus associated with the terminal relaxations is vEkT, which is smaller by a factor of two than the value from a shifted Rouse spectrum. It is consistent with a front factor g = j given by some recent theories of rubber elasticity (Part 7). The terminal spectrum for E 1 has the Rouse spacings for all practical purposes, shifted along the time axis by an undetermined multiplying factor (essentially the slow point friction coefficient). Thus, the model does not predict the terminal spectrum narrowing which is observed experimentally. [Pg.90]

Thirion (239a) has suggested that the plateau and terminal regions are the result of diffuse interchain interactions in a viscoelastic medium. He obtains a modified Rouse spectrum by replacing the subchain frictional coefficient by a time dependent micro-memory function. The theory is partly phenomenological since the memory function is not specified. However, reasonable choices lead to forms for G (co) and G"(o>) which are similar to those observed experimentally. [Pg.93]

The loss of the B state population depends on both the dynamics of the vibrational relaxation and the strength of the coupling of the B state to the repulsive a/a states. In the simulations, the predissociation of the B state molecules is described with the help of the Landau-Zener theory. There, the coupling strength is given by the perturbation energy. Furthermore, the probability for predissociation also depends on the (classical) velocity v t) which relates this process to the vibrational relaxation dynamics of the B state. The theoretical model uses a friction coefficient a to describe the latter process. [Pg.558]

Thus the relaxation spectrum resulting from the average coordinates equation11 of our model has the same form as that of Rouse, of Kargin and Slonimiskii, or of Bueche. In order to relate the parameters of the model to those of the Rouse theory, the time scale factor a must somehow be connected to the frictional coefficient for a single subchain of a Rouse molecule. To achieve this comparison, we may23 study the translational diffusion coefficients as computed for the two models. [Pg.310]

In this respect, another insufficiency of Lodge s treatment is more serious, viz. the lack of specification of the relaxation times, which occur in his equations. In this connection, it is hoped that the present paper can contribute to a proper valuation of the ideas of Bueche (13), Ferry (14), and Peticolas (13). These authors adapted the dilute solution theory of Rouse (16) by introducing effective parameters, viz. an effective friction factor or an effective friction coefficient. The advantage of such a treatment is evident The set of relaxation times, explicitly given for the normal modes of motion of separate molecules in dilute solution, is also used for concentrated systems after the application of some modification. Experimental evidence for the validity of this procedure can, in principle, be obtained by comparing dynamic measurements, as obtained on dilute and concentrated systems. In the present report, flow birefringence measurements are used for the same purpose. [Pg.172]


See other pages where Frictional coefficients theory is mentioned: [Pg.439]    [Pg.855]    [Pg.87]    [Pg.438]    [Pg.153]    [Pg.275]    [Pg.589]    [Pg.688]    [Pg.244]    [Pg.610]    [Pg.617]    [Pg.527]    [Pg.94]    [Pg.254]    [Pg.111]    [Pg.59]    [Pg.202]    [Pg.173]    [Pg.178]    [Pg.208]    [Pg.407]    [Pg.407]    [Pg.408]    [Pg.47]    [Pg.79]    [Pg.88]    [Pg.88]    [Pg.152]    [Pg.393]    [Pg.106]    [Pg.30]   
See also in sourсe #XX -- [ Pg.606 , Pg.607 , Pg.608 , Pg.609 ]




SEARCH



Friction coefficient

Friction theory

Frictional coefficients

© 2024 chempedia.info