Fluorocarbons grades available

Fluorocarbons. There are eight types of common fluorocarbons. They differ primarily by the concentration and arrangement of fluorine atoms along their molecular chain. Chemical types, suppliers, and trade names are given in Table 16.10. Like other plastics, each type of fluorocarbon is available in several different grades. They differ principally in the way they are processed and formed, and their properties vary over the useful temperature range. 

Fluorocarbons are available for commercial and industrial use in various grades with essentially the same composition from one producer to another. Purities of most fluorocarbon products are a minimum of 99 volume percent. For special applications very high purity grades are available. 

Extruded Articles. In extmded article compounding, the most important parameters are scorch safety and flow characteristics (53). The bisphenol cure system again offers the best scorch resistance of the available fluorocarbon elastomer cure systems. Good flow characteristics can be achieved through proper selection of gum viscosities. Also, the addition of process aids to the formulation can enhance the flow characteristics. Typical formulations for extmsion grade fluorocarbon elastomers are given iu Table 7. 

Solid fluorocarbon elastomers are commercially available as pure gum polymers or precompounded grades usually with curing system included. Only a nucleophilic curing system is used in these compounds. Examples of commonly used curing systems are listed in Table 5.6.34... 

Acetal translucent crystalline polymer is one of the stiffest TPs available. It provides excellent hardness and heat resistance, even in the presence of solvents and alkalies. Its low moisture sensitivity and good electrical properties permit direct competition with die-cast metal in a variety of applications. In addition, acetal has extremely high creep resistance and low permeability. Acetal is also available as a copolymer (Hoechst Celanese Corp. s Celcon) for improved processability. The homopolymer (DuPont s Delrin) has a very low coefficient of friction and its resistance to abrasion is second only to nylon 6/6. Acetals are frequently blended with fibers such as glass or fluorocarbon to enhance stiffness and friction properties. Acetal is not particularly weather-resistant, but grades are available with UV stabilizers for improved outdoor performance. Acetal, whether homopolymer or copolymer, is not used to any significant degree in forming structural foams. 

Carbon dioxide is, by far, the most attractive SCF for many reasons It is inexpensive and abundant at high purity (food grade) worldwide and it is nonflammable, non-toxic, and environment friendly moreover, its critical temperature T = 31 °C) permits operations at near-ambient temperature which avoids product alteration and its critical pressure (= 74 bar) leads to acceptable operation pressure, generally between 100 and 350 bar. In fact, supercritical carbon dioxide behaves as a rather weak nonpolar solvent, but its solvent power and polarity can be significantly increased by adding a polar cosolvent that is chosen among alcohols, esters, and ketones. Ethanol is often preferred because it is not hazardous to the environment, not very toxic, and available pure at low cost. Hydro fluorocarbons (HFCs) are very costly and their specific properties rarely justify their use in the replacement of carbon dioxide. 

---