Fluorine-containing ketones

Besides the above-mentioned catalytic asymmetric hydrogenation method for preparing fluorine-containing compounds, other reactions such as asymmetric reduction of achiral fluorine-containing ketones are also feasible methods for preparing chiral fluorinated compounds. For example, the oxazabor-olidine system, which has been discussed in Chapter 6, can also be employed in the catalytic reduction of trifluoromethyl ketones. Scheme 8 40 depicts some examples.85... 

Asymmetric transformation of fluorine-containing ketones or esters into the corresponding optically active alcohols or acids by enzymes along with the discussion on the effect of fluorinated alkyl groups during the enzymatic optical resolution or diastereoselective reactions is described. 

Fluorine-containing ketones have proven to be one of the most successful types of catalyst for dioxirane-mediated epoxidation [27]. Demnark has shown that good to excellent enantioselectivities can be achieved with catalyst 9 for tra 5-olefins (Scheme 1.10). However, catalyst loadings are high (30 mol%) [28]. 

Crystallinity of these hexafluoroisopropylidene-unit-containing poly(ketone)s is low except for poly(sulfide ketone) (13). The water contact angle for the fluorine-containing poly(ketone) films is high, being 98° for poly(ether ketone) (11), from 2,2-bis(4-carboxyphenyl)-l,l, l,3,3,3-hexafluoropropane(15) and 96° for poly(sulfide ketone) (13) from 15, whereas it is 78° for poly(ether ketone) from 2,2-bis(4-carboxy-phenyl)propane (16) and 74° for the poly(sulfide ketone) from 16. This result indicates that the substitution of isopropylidene units of poly-(ketone)s with hexafluoroisopropylidene units has a remarkable effect on the surface properties of poly(ketone) films. 

In 1998, Yang and coworkers reported a series of (7 )-carvone derived ketones (63) containing a quaternary center at and various substituents at (Fig. 22) [119]. The ees of fran -stilbene oxide varied with different para and meta substituents when 63b was used as the catalyst. The major contribution for the observed ee difference is from the n-n electronic repulsion between the Cl atom of the catalyst and the phenyl group of the substrate. The substitution at also influences the epoxidation transition state via an electrostatic interaction between the polarized C -X bond and the phenyl ring on franx-stilbene (Table 6, entries 3-7, 10-14). In 2000, Solladie-Cavallo and coworkers reported a series of fluorinated carbocyclic ketones... 

Fluorine-containing Michael addition acceptors have been used as synthons, a portion of a molecule recognizably related to a simpler molecule, for the introduction of fluorine into the organic molecules Their reactions with enamines and ketones lead to a condensadon-cyclizabon process... 

Lithiated di- and monofluorinated enol carbamates 566844 847 and 567848 are fluorine-containing acyl anion equivalents, which allow the synthesis of a-fluorinated ketones. 

Fluorine-containing aldehydes, ketones and acid fluorides undergo photoinitiated cycloaddition reactions with fluorinated alkenes to give oxetanes.The addition of hexafluoroacetone... 

Fluorine-containing aldehydes, ketones and acid fluorides undergo photoinitiated cycloaddition reactions with fluorinated alkenes to give oxetanes.90 91 The addition of hexafluoroacetone (11) to fluoroalkenes can also be performed in the presence of the Lewis acid, aluminum chloride fluoride.92-1 22-1 23 Unlike the photochemical cycloaddition of hexafluoroacetone with trifluoroethene, the Lewis acid catalyzed addition is regioselective.92 Fluorooxetanes (c. g., 14) have also been synthesized by the addition of formaldehyde to fluoroalkenes in hydrogen fluoride.94 Examples of the formation of fluorooxetanes by [2 + 2]-cycloaddition reactions arc-given in Table 8. 

Compounds such as fluorinated /3-ketones have been used mainly for the extraction of lanthanides and actinides, as more effective ligands than fluorinated dithiocarbamates for complexation with f-block elements. In addition to complex formation, some analytes (e.g. tervalent lanthanides) require the presence of a small amount of water containing 5% methanol — which act as matrix and solvent modifier, respectively — for quantitative extraction [89]. Also, a synergistic effect on the SFE of actinides [90,91] and of lanthanides from cellulose [92] and acid solutions [93] was observed when using a mixture of tributylphosphate (TBT) and a fluorinated /3-diketone. The effect was ascribed to competition of TBT with the matrix for the unoccupied coordination sites of lanthanides and actinides. Thus, the formation of adducts with the complexes of these analytes with fluorinated /3-ketones in supercritical COj facilitates their removal from the solid matrix. 

The methods of synthesis for bis(perfluoroalkyl)furans are more developed. For example, 2-methyl-3,4-bis(trifluoromethyl)furan can be synthesized by the reaction of 2-methyl-furan-3,4-dicarboxylic with sulfur tetrafluoride. However, the main synthetic methods rely on the use of unsaturated fluorine-containing acyclic compounds. So, 3-trifluoromethylfurans 57 were prepared from p,p-bis(trifluoro-methyl)a,p-unsaturated ketones and tin(II) chloride. ... 

Target compound 238 is synthesized in 15 steps from readily available starting materials in 25% overall yield by utilizing Pd- and Mo-catalyzed asymmetric reactions to control the quaternary and tertiary stereogenic centers, respectively. The fluorine containing part is introduced at the final stage by the reaction of a ketone 239 with 5-(trifluoromethyl)-2-pyridinesulfonyl chloride 240" (Scheme 12.57). 

Y. Sakaguchi, A. Kaji, K. Kitamura, S. Takase, K. Omote, Y. Asako, K. Kimura, Polymer electrolyte membranes derived from novel fluorine-containing poly(arylene ether ketone)s by controlled post-sulfonation.Po/ymer2012,53(20), 4388-4398. 

---