Fluid catalytic cracking active alumina

Catalytic Pyrolysis. This should not be confused with fluid catalytic cracking, which is used in petroleum refining (see Catalysts, regeneration). Catalytic pyrolysis is aimed at producing primarily ethylene. There are many patents and research articles covering the last 20 years (84—89). Catalytic research until 1988 has been summarized (86). Almost all catalysts produce higher amounts of CO and CO2 than normally obtained with conventional pyrolysis. This indicates that the water gas reaction is also very active with these catalysts, and usually this leads to some deterioration of the olefin yield. Significant amounts of coke have been found in these catalysts, and thus there is a further reduction in olefin yield with on-stream time. Most of these catalysts are based on low surface area alumina catalysts (86). A notable exception is the catalyst developed in the former USSR (89). This catalyst primarily contains vanadium as the active material on pumice (89), and is claimed to produce low levels of carbon oxides. 

An important example are alumina-supported Co—Mo and Ni—Mo sulfides, which constitute the active phases in catalysts for hydrotreating of middle distillates (403). It appears that in such catalysts, mostly pseudoboehmite-derived Y-AI2O3 is used as the support. According to fiter-ature data, catalysts for fluid catalytic cracking (FCC) gasoline desulfurization, which is performed at 260—340 °C and 5—30 atm, may contain 5—11 wt% molybdenum and 2-3 wt% cobalt supported on AI2O3 with a surface area of220—240 w (405). Catalysts for diesel fuel desulfurization to low-sulfur... 

MTBE is produced by reacting methanol with isobutene. Isobutene is contained in the C4 stream from steam crackers and from fluid catalytic cracking m the crude oil-refining process. However, isobutene has been in short supply in many locations. The use of raw materials other than isobutene for MTBE production has been actively sought. Figure 2 describes the reaction network for MTBE production. Isobutene can be made by dehydration of i-butyl alcohol, isomerization of -butenes [73], and isomerization and dehydrogenation of n-butane [74, 75]. t-Butanol can also react with methanol to form MTBE over acid alumina, silica, clay, or zeolite in one step [7678]. t-Butanol is readily available by oxidation of isobutane or, in the future, from syngas. The C4 fraction from the methanol-to-olefins process may be used for MTBE production, and the C5 fraction may be used to make TAME. It is also conceivable that these... 

---