Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Flooring tension

An ischiorectal fossa abscess has been reported after pelvic floor injections of botulinum toxin used to treat pelvic floor tension myalgia [24 ]. The authors conclude that physicians need to be aware of this possible complication and consider alternate injection techniques and antiseptic preparation before injection. [Pg.175]

S" = clear height above foam or froth (equals tray spacing minus foam height above tray floor), ft p = viscosity of liquid, centipoise a = surface tension of liquid, dynes/cm We = entrainment (based on assumed allowance) lbs liquid/ (ft free plate area) (hr) hf = height of top of foam above tray floor, in. [Pg.170]

A suitable apparatus for jacking the reel off the floor and holding it so that it can turn on its axis is desirable. Tension should be maintained on the wire rope as it leaves the reel by restricting the reel movement. A timber or plank provides satisfactory brake action. When winding the wire rope onto the drum, sufficient tension should be kept on the rope to assure tight winding. [Pg.584]

Set tests are made in either tension or compression and for their prime use, quality control, the choice of mode can be made according to the convenience of the test piece available. If intended to simulate service conditions, e.g. indentation of flooring, the most relevant mode of deformation would be used. Tests can be carried out in which the test piece is subjected to either constant stress or constant strain but, as the latter is by far the most widely used, the illustration of set measurement given in Figure 11.3 is based on constant strain in the compression mode. [Pg.211]

At 9 55, I experienced a mild sense of ataxia as I walked along the hall. I gradually developed a sense of strangeness, and I felt stimulated and mildly drunk. Subsequently I felt muscle tension all over my body, but especially in the back and around the nape of the neck. My stomach felt queasy, as if with suppressed excitement, and I felt tenseness in the back of the throat. The floor seemed to be revolving in the room to some extent, and I seemed to lose sensation, in the... [Pg.45]

Depending on factors such as watershed slope, depth of water table, antecedent soil moisture, and barriers to precipitation and throughfall infiltration, DOM from the forest floor and organic soil horizon can contribute a large flux of allochthonous DOM to surface waters. Soil solution for DOM analysis is typically collected with zero-tension lysimeters placed at the boundary between organic soil and mineral soil. [Pg.38]

Plio-Quatemary magmatism in Italy occurs along a NW-SE trending ex-tensional zone on the Tyrrhenian border of the Italian peninsula, in western Sicily, in the Sicily Channel, on the Tyrrhenian Sea floor and in Sardinia. Geochronological data for the main magmatic centres (Fig. 1.1 Table 1.1) show that there is a general decrease in age from Tuscany and Sardinia towards the south-east, where volcanism is presently active. [Pg.1]

As an example, consider a clean floor tile with a surface tension of 32 mN m-1 and the same tile that has been soiled (27 mN m 1). This is an example of a very realistic possibility. One can observe clearly that the contact angle increases dramatically once the surface tension of the liquid (for example, floor polish with surfactant) increases above that of the substrate. Shown also in Figure 6.55 are bars that span typical surface tension expected... [Pg.229]

Mark the crises, ending with the climax. Cut out each of these episodes, however short. Lay the pieces out in their current order on a table or the floor, and then begin to shuffle them about. What happens when Event C comes before Event A Or Event B comes just before the climax And so forth. Essentially, what you are trying to do is build an arc of increasing tension that rises to a satisfying climax and ends in resolution. [Pg.82]

Even though no surface-tension effect was apparent in Table I, runs with different channel widths indicate that the shape of the meniscus may have a measurable, though small, influence on the measured surface speed. For example, in Figure 4 a comparison is shown for operation with the lower edges of the channel in physical contact with the moving floor. Data for two channel widths are compared with the predictions of Equation 18. To nondimensionalize the plot, particle speed w is expressed in ratio to... [Pg.332]

We were immediately made acquainted with the fact that of all the countries of the Middle East the Hashemite Kingdom of Transjordan is the most complicated in its entrance and exit formalities. No less than twenty people were jammed into the little passport office, and each of them had to have his papers examined by one man, and then by another, while careful entries were made in a huge book. Everyone there except ourselves was Arab. They stared at us, some with unfriendly eyes, others indifferently. I heard one man mutter, "Yehudi which means Jews. The crowd stirred and muttered. Somebody spat on the floor near my foot. I took my passport out of my pocket and held it so that those nearest me could see the American coat of arms on its green cover. There was another mutter of words, which I did not understand, but the tension relaxed. We got up to the desk of the passport officer and, after being put through the usual routine, we were free to proceed. [Pg.138]

In practical terms, the use of poly (vinyl chloride) in the manufacture of plastic raincoats provides a good illustration of the effect of crystallite cross-linking. The polymer is plasticized, nntil is below ambient, to make the material flexible, and one might expect that if the coat was hung on a hook (i.e., subjected to a tensile load), it would evenmally flow onto the floor after prolonged tension. This is not so the material behaves as though it was a chemically cross-linked elastomer because it contains a sufficient number of crystallites to act as restraining points and prevent flow. [Pg.422]

Under the increase of loads, there are three independent tension cracks firstly arise on the left side wall. As further increase of the loading, cracks continually propagate, converge and coalesce leading to the penetrating cracks on both sidewalls and the floor until complete failure of the roadway. [Pg.203]


See other pages where Flooring tension is mentioned: [Pg.191]    [Pg.191]    [Pg.336]    [Pg.248]    [Pg.396]    [Pg.913]    [Pg.681]    [Pg.504]    [Pg.216]    [Pg.321]    [Pg.89]    [Pg.1248]    [Pg.212]    [Pg.336]    [Pg.440]    [Pg.58]    [Pg.196]    [Pg.70]    [Pg.309]    [Pg.83]    [Pg.336]    [Pg.635]    [Pg.34]    [Pg.499]    [Pg.359]    [Pg.1120]    [Pg.452]    [Pg.169]    [Pg.494]    [Pg.320]    [Pg.515]    [Pg.298]    [Pg.136]    [Pg.749]    [Pg.1183]    [Pg.154]    [Pg.164]    [Pg.189]   
See also in sourсe #XX -- [ Pg.298 ]




SEARCH



Flooring

Floors/flooring

© 2024 chempedia.info