Intercalated filler

In view of these findings, it is easy to imagine how the key stage of this in-situ approach is the immobilization of the aluminoxane cocatalyst within the clay carrier sheets. Therefore, a full complement of structural X-ray investigation and TEM analysis of the clay-MAO intermediate before the polymerization becomes crucial to have a right check of the filler intercalation extent in the polymer matrix. 

Since the possibility of direct melt intercalation was first demonstrated [11], melt intercalation has become a method of preparation of the intercalated polymer/ layered silicate nanocomposites (PLSNCs). This process involves annealing, statically or under shear, a mixture of the polymer and organically modified layered fillers (OMLFs) above the softening point of the polymer. During annealing, the polymer chains diffused from the bulk polymer melt into the nano-galleries between the layered fillers. 

Interlayer Structure of OMLFs and Intercalation 9.2.2.1 Nano-fillers... 

The effect of polymer-filler interaction on solvent swelling and dynamic mechanical properties of the sol-gel-derived acrylic rubber (ACM)/silica, epoxi-dized natural rubber (ENR)/silica, and polyvinyl alcohol (PVA)/silica hybrid nanocomposites was described by Bandyopadhyay et al. [27]. Theoretical delineation of the reinforcing mechanism of polymer-layered silicate nanocomposites has been attempted by some authors while studying the micromechanics of the intercalated or exfoliated PNCs [28-31]. Wu et al. [32] verified the modulus reinforcement of rubber/clay nanocomposites using composite theories based on Guth, Halpin-Tsai, and the modified Halpin-Tsai equations. On introduction of a modulus reduction factor (MRF) for the platelet-like fillers, the predicted moduli were found to be closer to the experimental measurements. 

In the literature, there are several reports that examine the role of conventional fillers like carbon black on the autohesive tack (uncured adhesion between a similar pair of elastomers) [225]. It has been shown that the incorporation of carbon black at very high concentration (>30 phr) can increase the autohesive tack of natural and butyl rubber [225]. Very recently, for the first time, Kumar et al. [164] reported the effect of NA nanoclay (at relatively very low concentration) on the autohesive tack of BIMS rubber by a 180° peel test. XRD and AFM show intercalated morphology of nanoclay in the BIMS rubber matrix. However, the autohesive tack strength dramatically increases with nanoclay concentration up to 8 phr, beyond which it apparently reaches a plateau at 16 phr of nanoclay concentration (see Fig. 36). For example, the tack strength of 16 phr of nanoclay-loaded sample is nearly 158% higher than the tack strength of neat BIMS rubber. The force versus, distance curves from the peel tests for selected samples are shown in Fig. 37. 

---