Feed and Solid Conveying Section

The feed section takes the product from the feeding system and conveys it to the plastification section. At the same time, there must be sufficient free volume to allow gas reflux, e. g., air or nitrogen, to escape from the process section upstream. If the throughput rate of the extruder is less than the input product flow, the product will back up in the feed hopper, indicating that the intake limit has been reached. Along with the known extruder data, such as the screw speed, the screw pitch, and the available volume in the screw channel, other influencing factors, such as the fill rate of the screw channel, the conveying efficiency, the bulk density, and other bulk characteristics of the product sometimes affect the 

Influence of the particle size of the bulk product on intake capacity 

The intake behavior is also substantially influenced by the resistance of the downstream plastification section. If discharged at atmospheric pressure, e.g., via screw feeders, the throughput rate is considerably higher than if the same feed section is succeeded by a plastification section (Fig. 11.4). For instance, if metering a product with a bulk density of 0.35 g/cm3 and a melt phase density of 0.7 g/cm3, it is clear that considerable quantities of gas will have to be extracted upstream through the intake hopper. 

no definitive rules describing the relationships between the geometrical and operating data of the extruder and the characteristics of the bulk product have yet been 

The solids conveying capability of the extruder is also determined by its geometrical design. For this, there are some basic rules supported by experimental and operating experience  

---