Fatigue energy release rate

Broeklehurst [37] has written an exhaustive review of the early work (prior to 1977) on fracture in polyerystalline graphite. Mueh of this work foeused on the fraeture behavior of nuclear graphites. In most investigations eonsidered, conventional fracture meehanies tests and analysis were performed for maeroseopie craeks. LEFM provided an adequate eriterion for failure. Additionally, results on work of fraeture, strain energy release rate, and fatigue eraek propagation were reported. 

Step 2. After a contact time t, the material is fractured or fatigued and the mechanical properties determined. The measured properties will be a function of the test configuration, rate of testing, temperature, etc., and include the critical strain energy release rate Gic, the critical stress intensity factor K[c, the critical... 

Fig. 23.11 (a) Contact radius for each cycle of the fatigue experiment, (b) Maximum and minimum values of the applied energy release rate for each cycle of the fatigue experiment. 

The fatigue behavior of the phenolic FRP-wood interface bond was investigated [7], using a TDCB specimen for constant strain energy release rate range AG. The load ratio effect... 

Trakas K, Kortschot MT. The relationship between critical strain energy release rate and fracture mode in multidirectional carbon-fiber/epoxy laminates. In Armanios EA, editor. Composite materials fatigue and fracture, vol. 1285. ASTM Special Technical Publication 1997. pp. 283—304. http //dx.doi.org/10.1520/ STP19933S. 

Based on the size of the impact-induced delaminations at the onset of delamination growth, Butler et al. [32] concluded that at the compressive fatigue strain limit of 3600 pe the corresponding strain energy release rate G for the delamination geometry could... 

The relationship between the applied stress intensity factor and the fatigue crack growth (FCG) rate of a defect is generally expressed as a power law [1]. In the case of polymers, adhesives and eomposites, the relationship is traditionally written as a function of the range of strain energy release rate (AG) as... 

---