Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Fabrication Drawings

A-B Source tests, if necessary. L-M Vendor prepares fabrication drawings. [Pg.2182]

Design drawings Detail or fabrication drawings Materials requirements including composition, quality standards, and minimum structural properties Fabrication requirements and standards, including dimensional tolerances, allowable defects, and minimum structural properties Requirements for prototype and quality control tests and procedures Shipping and handling... [Pg.9]

In general, any detail in the column that differs from the design and fabrication drawings may develop into a potential source of trouble. [Pg.272]

Prepare engineering drawings Design and fabrication drawings... [Pg.618]

Fabrication drawings of melting, settling, and pumping chamber coils. [Pg.124]

Fabrication drawings, and details of matching nozzles on furnace shell. Specifications and spare sets of spray nozzles (minimum and maximum flow of liquid sulfur)... [Pg.124]

Radiography of welded joints shall be as per approved fabrication drawing. [Pg.319]

GA and approved fabrication drawings with inlet and exit nozzles, their orientations, nozzles for safety valves, and vents. [Pg.319]

Purchasing only fabrication drawings and designs from consultants in order to develop the units in-house. There is a risk of getting untried designs from consultants... [Pg.17]

Fabrication drawings should contain comments by consultants and shop floor senior engineers for suggested changes or waiving off of requirements (some fittings or nozzles may not be required)... [Pg.81]

Permission should be obtained from statutory authorities for these changes. The final approved fabrication drawings must have signatures of all concerned parties... [Pg.81]

Discuss fabrication drawings for any last minute changes only minor changes not requiring statutory approvals) finalise for negotiations with vendor... [Pg.81]

Nozzle orientations must match the final layout ofplant. Orientations to be considered while fabrication drawings are made—without any violation of statutory instructions... [Pg.83]

Special custom items are defined and designed. Detailed schematics and assembly diagrams are drawn. Parts lists and specifications are finalized, and all necessary details worked out for these items. Mechanical fabrication drawings are prepared for consoles and other custom-built cabinetry. [Pg.2356]

Assembly drawing in HPGL format, sheet XX of XX Fabrication drawing in HPGL format, sheet XX of XX... [Pg.310]

See other pages where Fabrication Drawings is mentioned: [Pg.377]    [Pg.52]    [Pg.52]    [Pg.176]    [Pg.226]    [Pg.140]    [Pg.190]    [Pg.53]    [Pg.1026]    [Pg.1026]    [Pg.172]    [Pg.177]    [Pg.306]    [Pg.1030]    [Pg.1030]    [Pg.161]    [Pg.232]    [Pg.234]    [Pg.318]    [Pg.318]    [Pg.274]    [Pg.64]    [Pg.81]    [Pg.165]    [Pg.781]    [Pg.912]    [Pg.294]    [Pg.309]   


SEARCH



© 2024 chempedia.info