Ethyl radicals, addition

Addition of t-butyl radical was unsuccessful when 1-phenylethenyl sulfones (R = Ph) were used, yet the less sterically demanding ethyl radical addition proceeded smoothly under the standard radical conditions (entries 3 and 4). Interestingly, when bulky hydrogen atom donors, such as Ph3SnH and TTMS were used, longer reaction times were required, but the selectivity was the same as that obtained with BuaSnH. 

A limitation of the aforementioned methods is that they are unsuitable for the use of primary alkyl iodides. Under Et3B/02 initiation conditions, the desired radical is intended to be generated by iodine atom transfer to ethyl radicals, which is not favorable in the case of primary iodides. Thus ethyl radical addition competes with the desired radical when using triethylborane initiation along with primary iodides. In addition, generating radicals by hydrogen atom transfer from ethers or acetals has limited applicability. Because of the expanded synthetic potential of primary alkyl iodides as... 

Rate constants of ethyl radical addition to some monomers... 

Treatment of a-iodo ketone and aldehyde with an equimolar amount of Et3B yielded the Reformatsky type adduct in the absence of PhaSnH (Scheme 21), unlike ot-bromo ketone as shown in Scheme 15 [22], Ethyl radical abstracts iodine to pro-duee carbonylmethyl radical, which would be trapped by EtsB to give the corresponding boron enolate and regenerate an ethyl radical. The boron enolate reacts with aldehyde to afford the adduct. The three-component coupling reaction of tert-butyl iodide, methyl vinyl ketone and benzaldehyde proceeded to give the corresponding adduct 38, with contamination by the ethyl radical addition product 39. The order of stability of carbon-centered radical is carbonylmethyl radical > Bu > Pr > Ef > Me . 

Ethyl radical additions to various oleflns and acetylenes... 

Ethyl radical addition to various vinyl monomers. (Pressures not recorded.)... 

Examples of perfluoroalkyl iodide addition to the triple bond include free radical addition of perfluoropropyl iodide to 1 -heptyne [28] (equation 21), thermal and free radical-initiated addition of lodoperfluoroalkanesulfonyl fluorides to acetylene [29] (equation 22), thermal addition of perfluoropropyl iodide to hexa-fluoro 2 butyne [30] (equation 23), and palladium-catalyzed addition of per-fluorobutyl iodide to phenylacetylene [31] (equation 24) The E isomers predominate in these reactions Photochemical addition of tnfluoromethyl iodide to vinylacetylene gives predominantly the 1 4 adduct by addition to the double bond [32] Platinum catalyzed addition of perfluorooctyl iodide to l-hexyne in the presence of potassium carbonate, carbon monoxide, and ethanol gives ethyl () per fluorooctyl-a-butylpropenoate [JJ] (equation 25)... 

The first use of ionic liquids in free radical addition polymerization was as an extension to the doping of polymers with simple electrolytes for the preparation of ion-conducting polymers. Several groups have prepared polymers suitable for doping with ambient-temperature ionic liquids, with the aim of producing polymer electrolytes of high ionic conductance. Many of the prepared polymers are related to the ionic liquids employed for example, poly(l-butyl-4-vinylpyridinium bromide) and poly(l-ethyl-3-vinylimidazolium bis(trifluoromethanesulfonyl)imide [38 1]. 

Thus, even if /-amyloxy radicals (101) show similar specificity for addition 1 5-abstraction to /-butoxy radicals, abstraction will be of lesser importance.42"42 The reason is that most /-amyloxy radicals do not react directly with monomer. They undergo [3-scission and initiation is mainly by ethyl radicals. Ethyl radicals are much more selective and give addition rather than abstraction. This behavior has led to /-amyl peroxides and peroxyesters being promoted as superior to the corresponding /-butyl derivatives as polymerization initiators.423... 

Two of the many products of ethylene radiolysis—methane and propane—show no or only negligible variation with field strength. Methane is produced by a molecular elimination process, as evidenced by the inability of oxygen or nitric oxide to quench its formation even when these additives are present in 65 mole % concentration (34). Propane is completely eliminated by trace amounts of the above scavengers, suggesting methyl and ethyl radicals as precursors ... 

Kawabata, Tsuruta, and Furukawa (121) have reported a linear relationship between the logarithms of their Q values and the logarithms of the methyl affinities of Szwarc and co-workers (111, 123, 124). James and MacCallum (125) have found a linear relationship between the logarithms of the Qo values calculated from the definition of Zutty and Burkhart (122) and the logarithms of the rates of addition of ethyl radicals to various substituted ethylenes. Similar... 

However, a comparison of the line shape of the observed spectra with spectra of methyl radicals (Fig. lib) clearly proves that the species present here are not methyl radicals. The EPR spectrum of a methyl radical is a quartet of lines. However, the observed spectrum, though dominated by a quartet structure, shows a couple of additional lines pointing to additional interactions of the unpaired electron. By comparing the observed line shape to other alkyl radicals it turned out that the present spectrum can be attributed to ethyl radicals. Figure 11c shows the EPR spectrum of ethyl radicals created in an ethylchloride matrix generated by photolysis for comparison [121]. 

The best known example is the electrosynthesis of tetraethyllead (TEL) Pb(C2Hj)4, which has been in wide use as an antiknock additive of gasoline, and still is in a number of countries. This substance is readily produced by reaction of ethyl radicals with the lead electrode ... 

This type of reaction is involved as an intermediate step in few synthetically useful reactions, in the formation of polysulfones by copolymerization of an olefin with SO 2, as well as in aerosol formation in polluted atmospheres. We will discuss later in some detail the most important chain reactions involving step 11. However, Good and Thynne determined the Arrhenius parameters for the addition of methyl and ethyl radicals to SO2 in gas phase, the rate constants being 5 x 10 and 4 x 10 s respectively at ambient... 

Scheme 10.17 illustrates allylation by reaction of radical intermediates with allyl stannanes. The first entry uses a carbohydrate-derived xanthate as the radical source. The addition in this case is highly stereoselective because the shape of the bicyclic ring system provides a steric bias. In Entry 2, a primary phenylthiocar-bonate ester is used as the radical source. In Entry 3, the allyl group is introduced at a rather congested carbon. The reaction is completely stereoselective, presumably because of steric features of the tricyclic system. In Entry 4, a primary selenide serves as the radical source. Entry 5 involves a tandem alkylation-allylation with triethylboron generating the ethyl radical that initiates the reaction. This reaction was done in the presence of a Lewis acid, but lanthanide salts also give good results. 

The prompt dissociation of the fast H atom in the pathway, for which character change and collapse of the 3s Rydberg orbital on the ethyl radical to the Is orbital of the H product are required,121-123 could be assisted by the conical intersection. Also, relaxation and internal conversion from the 3s state to the ground state ethyl can be facilitated by this conical intersection, in addition to other possible vibronic couplings in the A symmetry.39... 

I. Addition of C-Radicals to Nitrones Recently (525), the addition of alkyl radicals to chiral nitrones as a new method of asymmetrical synthesis of a-amino acids has been described. Addition of ethyl radicals to glycosyl nitrone (286) using Et3B as a source of ethyl radicals appears to proceed with a high stereo-control rate. 

Chain carriers are usually very reactive molecular fragments. Atomic species such as H and Cl, which are electrically neutral, are in fact the simplest examples of free radicals, which are characterized by having an impaired electron, in addition to being electrically neutral. More complex examples are the methyl and ethyl radicals, CH and QH, respectively. 

Intramolecular addition of trialkylboranes to imines and related compounds have been reported and the main results are part of review articles [94, 95]. Addition of ethyl radicals generated from Et3B to aldimines affords the desired addition product in fair to good yield but low diaster control (Scheme 40, Eq. 40a) [96]. Similar reactions with aldoxime ethers [97], aldehyde hydrazones [97], and N-sulfonylaldimines [98] are reported. Radical addition to ketimines has been recently reported (Eq. 40b) [99]. Addition of triethylborane to 2H-azirine-3-carboxylate derivatives is reported [100]. Very recently, Somfai has extended this reaction to the addition of different alkyl radicals generated from trialkylboranes to a chiral ester of 2ff-azirine-3-carboxylate under Lewis acid activation with CuCl (Eq. 40c) [101]. 

The methyl radical adds to the terminal carbon of propadiene (la) with a rate constant fc= 1 x 104 M-1 s-1 [27]. This elementary reaction requires an activation energy of 34 kj mol-1 based on an Arrhenius analysis of data recorded in the temperature range 100-210 °C. Comparable results were obtained for ethyl and isopropyl radical addition to substrate la (Table 11.3) [27]. 

Some stabilization energies are collected in Table 3. The presentation provides an easy overview of the stabilization in singly and doubly substituted methyl radicals. Values in parentheses for doubly substituted radicals represent the sum of the stabilization energies derived from mono-substituted radicals. By comparing the values calculated directly for the doubly substituted radical, information is obtained on antagonistic, additive or synergetic substituent effects. Apart from methyl and ethyl radicals, all other radicals are stabilized. Some points merit comment. 

Pringle reported that ethyl acrylate also reacts similarly [14]. The radical addition at 70 °C forms a mixture of primary PH2 (CH2CH2COOEt), secondary PH(CH2CH2COOEt)2 and tertiary phosphines. The tertiary phosphine component is not pure P(CH2CH2COOEt)3, but a mixture with telomers. However, Pt complex-catalyzed addition is very clean when PH3 is bubbled through a warmed solution of ethyl acrylate in the presence of 0.002 equiva-... 

---