Estrone Birch reduction

A carbonyl group cannot be protected as its ethylene ketal during the Birch reduction of an aromatic phenolic ether if one desires to regenerate the ketone and to retain the 1,4-dihydroaromatic system, since an enol ether is hydrolyzed by acid more rapidly than is an ethylene ketal. 1,4-Dihydro-estrone 3-methyl ether is usually prepared by the Birch reduction of estradiol 3-methyl ether followed by Oppenauer oxidation to reform the C-17 carbonyl function. However, the C-17 carbonyl group may be protected as its diethyl ketal and, following a Birch reduction of the A-ring, this ketal function may be hydrolyzed in preference to the 3-enol ether, provided carefully controlled conditions are employed. Conditions for such a selective hydrolysis are illustrated in Procedure 4. 

A. Birch Reduction of the Diethyl Ketal of Estrone 3-Methyl Ether in Annmonia-Methylcyclohexane-f-Amyl AlcohoP ... 

Estrone methyl ether (100 g, 0.35 mole) is mixed with 100 ml of absolute ethanol, 100 ml of benzene and 200 ml of triethyl orthoformate. Concentrated sulfuric acid (1.55 ml) is added and the mixture is stirred at room temperature for 2 hr. The mixture is then made alkaline by the addition of excess tetra-methylguanidine (ca. 4 ml) and the organic solvents are removed. The residue is dissolved in heptane and the solution is filtered through Celite to prevent emulsions in the following extraction. The solution is then washed threetimes with 500 ml of 10 % sodium hydroxide solution in methanol to remove excess triethyl orthoformate, which would interfere with the Birch reduction solvent system. The heptane solution is dried over sodium sulfate and the solvent is removed. The residue is satisfactory for the Birch reduction step. Infrared analysis shows that the material contains 1.3-1.5% of estrone methyl ether. The pure ketal may be obtained by crystallization from anhydrous ethanol, mp 99-100°. Acidification of the methanolic sodium hydroxide washes affords 10-12 g of recovered estrone methyl ether. 

The crude ketal from the Birch reduction is dissolved in a mixture of 700 ml ethyl acetate, 1260 ml absolute ethanol and 31.5 ml water. To this solution is added 198 ml of 0.01 Mp-toluenesulfonic acid in absolute ethanol. (Methanol cannot be substituted for the ethanol nor can denatured ethanol containing methanol be used. In the presence of methanol, the diethyl ketal forms the mixed methyl ethyl ketal at C-17 and this mixed ketal hydrolyzes at a much slower rate than does the diethyl ketal.) The mixture is stirred at room temperature under nitrogen for 10 min and 56 ml of 10% potassium bicarbonate solution is added to neutralize the toluenesulfonic acid. The organic solvents are removed in a rotary vacuum evaporator and water is added as the organic solvents distill. When all of the organic solvents have been distilled, the granular precipitate of 1,4-dihydroestrone 3- methyl ether is collected on a filter and washed well with cold water. The solid is sucked dry and is dissolved in 800 ml of methyl ethyl ketone. To this solution is added 1600 ml of 1 1 methanol-water mixture and the resulting mixture is cooled in an ice bath for 1 hr. The solid is collected, rinsed with cold methanol-water (1 1), air-dried, and finally dried in a vacuum oven at 60° yield, 71.5 g (81 % based on estrone methyl ether actually carried into the Birch reduction as the ketal) mp 139-141°, reported mp 141-141.5°. The material has an enol ether assay of 99%, a residual aromatics content of 0.6% and a 19-norandrost-5(10)-ene-3,17-dione content of 0.5% (from hydrolysis of the 3-enol ether). It contains less than 0.1 % of 17-ol and only a trace of ketal formed by addition of ethanol to the 3-enol ether. 

Birch reduction of the diethyl ketal of estrone 3-methyl ether in ammonia-methylcyclohexane-t-amyl alcohol,... 

Reaction of estrone methyl ether with methyl Grignard reagent followed by Birch reduction and hydrolysis of the intermediate enol ether affords the prototype orally active androgen in the 19-nor series, normethandrolone (69). ° (Note that here again the addition of the methyl group proceeded stereoselectively by approach from the least hindered side.) The preparation of the ethyl homolog starts by catalytic reduction of mestranol treatment of the intermediate, 70, under the conditions of the Birch reduction and subsequent hydrolysis of the intermediate enol ether yields norethandrolone (71). ... 

One of the important mechanisms by which orally administered steroids are inactivated involves the formation of water-soluble derivatives at the 17 position, a process that is greatly reduced in 17a-alkyl-17(3-hydroxy derivatives. Extensive use of the resulting orally active compounds has since revealed that 17 alkylation also leads to increased liver toxicity. Preparation of the first of these compounds, nor-methandrolone (32-3), starts by addition of methylmagnesium iodide to estrone methyl ether (9-1) to give the 17a methyl derivative. Birch reduction followed by acid hydrolysis leads to normethandrolone (32-3) [16]. 

Bamford-Stevens decomposition of tosylhy-drazones, 351 p-Benzoquinone, 308 Benzyl ether hydrogenolysis, 139 Benzyl thioenol ethers, 87 Birch reduction, 11, 49, 50 Birch reduction of estrone methyl ether diethyl ketal, 51... 

Birch reduction of phenols [1, 56, before references]. Although free phenols are regarded as generally not reducible under Birch conditions, Fried eta . 1 noted some reduction in the case of 2-hydroxy-7-methoxyfluorene (1). They then noted that if the concentration of lithium is increased from 1.5 to 4 M essentially complete reduction of the phenolic ring occurs. Thus estrone (4) furnishes (5) in 75% yield. 

Norethindrone 31a, the gestagenic component in the combination pill, is smoothly accessible from estrone-methylether by partial synthesis [71]. The reaction sequence begins with a dearomatization (Birch reduction) and ends with an ethynylation (Scheme 1-10), necessary for the oral applicability. Technical production of estrone 24 (or estradiol) from inexpensive steroids such as diosgenin or cholesterol by partial synthesis is also feasible. Pyrolytic aromatization (Inhoffen at Schering AG) assists the transition from the steroid to the 19-nor-steroid class (such as from androsta-1,4-dien-l 7/i-ol-3-one 32 to estradiol 33 [72]). 

The Birch reduction of estrone gave a 1 J p yield of estr-5 (lO)-ene-30 >lTP-diol. Surprisingly, this same compound was obtained as the major product from the photochemical sodium borohydride reduction of estrone. ... 

The use of anisoles (22) as synthetic equivalents to cyclohex-2-enones (Scheme 3) has been widespread since the original observations of Birch, and the literature is replete with examples over the past five decades, e.g. in the syntheses of steroids, terpenoids and alkaloids. The most thorough studies have been carried out within the context of the conversion of estrone derivatives to 19-norandrostane and pregnane derivatives and are instructive for the selection of reagents and reaction parameters for reductions of this general type. ... 

---