Ester in polymers

J. E., Synthesis and release of contraceptive steroids from bio-erodible poly(ortho esters), in Polymers in Medicine (E. Chielini and P. Giusti, eds.). Plenum Publishing, New York, 1983, pp. 169-178. 

PHOTO-REACnONS OF ARYL ESTERS IN POLYMER MATRICES... 

T.X. Neenan, et al., Photochemistry and thermochemistry of select 2,6-dinitrobenzyl esters in polymer matrices studies pertaining to chemical amplification and imaging. Macromolecules 1990, 23(1), 145-150. 

The bottle is then cooled in a dry ice-acetone bath, opened, and caiefiilly vented as the content warms to room temperature (precautions against exposure of personnel and the environment to the carcinogen vinyl chloride must be taken). The product is precipitated by the addition of methanol. The polymer is dried to constant weight under reduced pressure. Conversion is 57%, inherent viscosity 0.24 (in 0.2% solution in THF at 30°C). 47.3% ester in polymer. 

D. L. Miller, E. P. Samsel, and J. G. Cobler, Determination of acrylate and maleate esters in polymers by combined Zeisel and gas-chromatographic analysis, Anal. Chem., 33 (1961) 677—680. 

In addition, the C-O-C stretching of maleic acid ester in polymer blend was observed at 1152 cm The intensity of 3200-3500 cm (O-H stretching of PVA) and 1293 cm (O-H in-plane bending of PVA) dramatically decreased. This might be due to hydroxyl group from PVA crosslinked with maleic acid. 

The role of specific interactions in the plasticization of PVC has been proposed from work on specific interactions of esters in solvents (eg, hydrogenated chlorocarbons) (13), work on blends of polyesters with PVC (14—19), and work on plasticized PVC itself (20—23). Modes of iateraction between the carbonyl functionaHty of the plasticizer ester or polyester were proposed, mostly on the basis of results from Fourier transform infrared spectroscopy (ftir). Shifts in the absorption frequency of the carbonyl group of the plasticizer ester to lower wave number, indicative of a reduction in polarity (ie, some iateraction between this functionaHty and the polymer) have been reported (20—22). Work performed with dibutyl phthalate (22) suggests an optimum concentration at which such iateractions are maximized. Spectral shifts are in the range 3—8 cm . Similar shifts have also been reported in blends of PVC with polyesters (14—20), again showing a concentration dependence of the shift to lower wave number of the ester carbonyl absorption frequency. 

The thermoplastic or thermoset nature of the resin in the colorant—resin matrix is also important. For thermoplastics, the polymerisation reaction is completed, the materials are processed at or close to their melting points, and scrap may be reground and remolded, eg, polyethylene, propjiene, poly(vinyl chloride), acetal resins (qv), acryhcs, ABS, nylons, ceUulosics, and polystyrene (see Olefin polymers Vinyl polymers Acrylic ester polymers Polyamides Cellulose ESTERS Styrene polymers). In the case of thermoset resins, the chemical reaction is only partially complete when the colorants are added and is concluded when the resin is molded. The result is a nonmeltable cross-linked resin that caimot be reworked, eg, epoxy resins (qv), urea—formaldehyde, melamine—formaldehyde, phenoHcs, and thermoset polyesters (qv) (see Amino resins and plastics Phenolic resins). 

Plasticizers. Plasticizers are materials that soften and flexibilize inherently rigid, and even britde polymers. Organic esters are widely used as plasticizers in polymers (97,98). These esters include the benzoats, phthalates, terephthalates, and trimeUitates, and aUphatic dibasic acid esters. Eor example, triethylene glycol bis(2-ethylbutyrate) [95-08-9] is a plasticizer for poly(vinyl butyral) [63148-65-2] which is used in laminated safety glass (see Vinyl POLYMERS, poly(vinyl acetals)). Di(2-ethyUiexyl)phthalate [117-81-7] (DOP) is a preeminent plasticizer. Variation of acid and/or alcohol component(s) modifies the efficacy of the resultant ester as a plasticizer. In phthalate plasticizers, molecular sizes of the alcohol moiety can be varied from methyl to tridecyl to control permanence, compatibiUty, and efficiency branched (eg, 2-ethylhexyl, isodecyl) for rapid absorption and fusion linear (C6—Cll) for low temperature flexibiUty and low volatility and aromatic (benzyl) for solvating. Terephthalates are recognized for their migration resistance, and trimeUitates for their low volatility in plasticizer appHcations. 

In general, aliphatic diacyl peroxide initiators should be considered as sources of alkyl, rather than of aeyloxy radicals. With few exceptions, aliphatic acyloxy radicals have a transient existence at best. For certain diacyl peroxides (36) where R is a secondary or tertiary alkyl group there is controversy as to whether loss of carbon dioxide occurs in concert with 0-0 bond cleavage. Thus, ester end groups observed in polymers prepared with aliphatic diaeyl peroxides are unlikely to arise directly from initiation, but rather from transfer to initiator (see 3.3,2.1.4),... 

In semi-cristalline polymers, rate-enhancement under stress has been frequently observed, e.g. in UV-photooxidation of Kapron, natural silk [80], polycaprolactam and polyethylene terephthalate [81]. Quantitative interpretation is, however, difficult in these systems although the overall rate is determined by the level of applied stress, other stress-dependent factors like the rate of oxygen diffusion or change in polymer morphology could occur concurrently and supersede the elementary molecular steps [82, 83], Similar experiments in the fluid state showed unequivocally that flow-induced stresses can accelerate several types of reactions, the best studied being the hydrolysis of DNA [84] and of polyacrylamide [85]. In these examples, hydrolysis involves breaking of the ester O —PO and the amide N —CO bonds. The tensile stress stretches the chain, and therefore, facilitates the... 

It must finally be kept in mind that it is extremely easy to adjust the properties of polyesters to desired values by adding small quantities (usually less than 10%) of comonomers in starting monomer feed. Isophthalic, adipic, dodecanedioic, p-hydroxybenzoic acids or esters and diethylene glycol, cyclohexanedimethanol, or bisphenol-A are often used for this purpose. Examples of property adjustment are the modification of solvent diffusivity of PET membranes by the addition of low levels of isophthalate or naphthalene dicarboxylate units in polymer chains139... 

Tractable polymers can be prepared when amino and anhydride functions are not located on the same aromatic ring, and different strategies were employed to obtain soluble polymer. AB benzhydrol imide was prepared by polycondensation of 4-(3-amino-l-hydroxymethylene) phtlialic acid monomethyl ester in NMP. The polymer soluble in NMP has been used as adhesive and coating.56 A second approach was based on an ether imide structure. AB aminophenylether phthalic acids (Fig. 5.34) were prepared by a multistep synthesis from bisphenols.155 The products are stable as hydrochloride, and the polycondensation takes place by activation with triphenylphosphite. The polymers are soluble in an aprotic polar... 

There are some applications for a-sulfo fatty acid esters in the production and processing of synthetic materials or natural rubber. Emulsifiers are needed for the emulsion polymerization, antistatic agents improve the properties of polymers, and wetting agents are needed as parting components for elastomers. 

The polymer stability upon storage was tested by keeping samples of pure, powdered poly(N-palmitoylhydroxyproline ester) in... 

The protocol offers a direct and efficient method for the synthesis of the boronic ester in the solid phase, which hitherto met with little success using classical methodology (Scheme 1-42). A solid-phase boronate (113 [155], 114 [156]) is quantitatively obtained by treating a polymer-bound iodoarene with the diboron (82). The subsequent coupling with haloarenes furnishes various biaryls. The robot synthesis or the parallel synthesis on the surface of resin is the topic of further accounts of the research. 

---