Alkylation, enolate ions

Damoun, S. Van de Woude, G. Choho, K. Geerlings, P. Influence of alkylating reagent softness on the regioselectivity in enolate ion alkylation a theoretical local hard and soft acids and bases study. J. Phys. Chem. A 1999, 303, 7861-7866. 

Alkylation occurs by an 8 2 mechanism m which the enolate ion acts as a nucleophile toward the alkyl halide... 

In practice this reaction is difficult to carry out with simple aldehydes and ketones because aldol condensation competes with alkylation Furthermore it is not always possi ble to limit the reaction to the introduction of a single alkyl group The most successful alkylation procedures use p diketones as starting materials Because they are relatively acidic p diketones can be converted quantitatively to their enolate ions by weak bases and do not self condense Ideally the alkyl halide should be a methyl or primary alkyl halide... 

Section 21 7 The malonic ester synthesis is related to the acetoacetic ester synthesis Alkyl halides (RX) are converted to carboxylic acids of the type RCH2COOH by reaction with the enolate ion derived from diethyl mal onate followed by saponification and decarboxylation... 

Section 21 9 Michael addition of the enolate ions derived from ethyl acetoacetate and diethyl malonate provides an alternative method for preparing their a alkyl derivatives... 

Mazur " obtained 2a-alkyl-5a-H (3) or 4 -alkyl-5 -H products (6) by direct alkylation of either 5a-H (1) or 5 -H-3-keto steroids (4) with alkyl halides under basic conditions. In general, formation and alkylation of the more stable enolate ion is observed in this procedure. 

In the presence of strong bases, carbonyl compounds form enolate ions, which may be employed as nucleophilic reagents to attack alkyl halides or other suitably electron-deficient substrates giving carbon-carbon bonds. (The aldol and Claisen condensations... 

The familiar alkylation of -ketoesters followed by decarboxylation is still a useful route to a-alkyl ketones, although the alkylation of enamines is frequently the preferred route. Given below are two examples of alkylation of 2-carbethoxycycloalkanones (prepared in Chapter 10, Section I). In the first case, sodium ethoxide is the base employed to generate the enolate ion of 2-carbethoxycyclohexanone. In the second case, the less acidic 2-carbethoxycyclooctanone requires sodium hydride for the generation of the enolate ion. 

Because they re negatively charged, enolate ions act as nucleophiles and undergo many of the reactions we ve already studied. For example, enolates react with primary alkyl halides in the SK2 reaction. The nucleophilic enolate ion displaces halide ion, and a new C-C bond forms ... 

The Sn2 alkylation reaction between an enolate ion and an alkyl halide is a powerful method for making C-C bonds, thereby building up larger molecules from smaller precursors. We ll study the alkylation of many kinds of carbonyl compounds in Chapter 22. 

Perhaps the single most important reaction of enolate ions is their alkylation by treatment with an alkyl halide or tosylate, thereby forming a new C-C bond and joining two smaller pieces into one larger molecule. Alkylation occurs when the nucleophilic enolate ion reacts with the electrophilic alkyl halide in an SN2 reaction and displaces the leaving group by backside attack. 

Ethyl 3-oxobutanoate, commonly called ethyl acetoacetate or ace tome tic ester, is much like malonic ester in that its ct hydrogens are flanked by two carbonyl groups. It is therefore readily converted into its enolate ion, which can be alkylated by reaction with an alkyl halide. A second alkylation can also be carried out if desired, since acetoacetic ester has two acidic a hydrogens. 

The three-step sequence of 0) enolate ion formation, (2) alkylation, and (3) hydrolvsis/decarboxylation is applicable to all /Tketo esters with acidic a hydrogens, not just to acetoacetic ester itself. For example, cyclic /3-keto esters such as ethyl 2-oxocycIohexanecarboxylate can be alkylated and decarboxy-lated to give 2-substituted cyclohexanones. 

Both the malonic ester synthesis and the acetoacetic ester synthesis are easy to cany out because they involve unusually acidic dicarbonyi compounds. As a result, relatively mild bases such as sodium ethoxide in ethanol as solvent can be used to prepare the necessary enolate ions. Alternatively, however, it s also possible in many cases to directly alkylate the a position of monocarbonyl compounds. A strong, stericaliy hindered base such as LDA is needed so that complete conversion to the enolate ion takes place rather than a nucleophilic addition, and a nonprotic solvent must be used. 

Ketones, esters, and nitriles can all be alkylated using LDA or related dialkyl-amide bases in THE. Aldehydes, however, rarely give high yields of pure products because their enolate ions undergo carbonyl condensation reactions instead of alkylation. (We ll study this condensation reaction in the next chapter.) Some specific examples of alkylation reactions are shown. 

Note in the ketone example that alkylation of 2-methylcyclohexanone leads to a mixture of products because both possible enolate ions are formed. In general, the major product in such cases occurs by alkylation at the less hindered, more accessible position. Thus, alkylation of 2-niethvTcyclohexanone occurs primarily at C6 (secondary) rather than C2 (tertiary). 

An alkylation reaction is used to introduce a methyl or primary alkyl group onto the a position of a ketone, ester, or nitrile by S 2 reaction of an enolate ion with an alkyl halide. Thus, we need to look at the target molecule and identify any methyl or primary alkyl groups attached to an a carbon. In the present instance, the target has an a methyl group, which might be introduced by alkylation of an ester enolate ion with iodomethane. 

Figure 22.7 The biosynthesis of indolmycin from indolylpyruvate occurs through a pathway that includes an alkylation reaction of a short-lived enolate ion intermediate.

Alpha hydrogen atoms of carbonyl compounds are weakly acidic and can be removed by strong bases, such as lithium diisopropylamide (LDA), to yield nucleophilic enolate ions. The most important reaction of enolate ions is their Sn2 alkylation with alkyl halides. The malonic ester synthesis converts an alkyl halide into a carboxylic acid with the addition of two carbon atoms. Similarly, the acetoacetic ester synthesis converts an alkyl halide into a methyl ketone. In addition, many carbonyl compounds, including ketones, esters, and nitriles, can be directly alkylated by treatment with LDA and an alkyl halide. 

There is no simple answer to this question, but the exact experimental conditions usually have much to do with the result. Alpha-substitution reactions require a full equivalent of strong base and are normally carried out so that the carbonyl compound is rapidly and completely converted into its enolate ion at a low temperature. An electrophile is then added rapidly to ensure that the reactive enolate ion is quenched quickly. In a ketone alkylation reaction, for instance, we might use 1 equivalent of lithium diisopropylamide (LDA) in lelrahydrofuran solution at -78 °C. Rapid and complete generation of the ketone enolate ion would occur, and no unreacled ketone would be left so that no condensation reaction could take place. We would then immediately add an alkyl halide to complete the alkylation reaction. 

Phenoxide Ions. These ions, which are analogous to enolate ions, can undergo C- or 0-alkylation ... 

The mechanism of these reactions is usually Sn2 with inversion taking place at a chiral RX, though there is strong evidence that an SET mechanism is involved in certain cases, ° especially where the nucleophile is an a-nitro carbanion and/or the substrate contains a nitro or cyano group. Tertiary alkyl groups can be introduced by an SnI mechanism if the ZCH2Z compound (not the enolate ion) is treated with a tertiary carbocation generated in situ from an alcohol or alkyl halide and BF3 or AlCla, or with a tertiary alkyl perchlorate. ... 

---