Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Enhancer absence

In contrast to the situation in the absence of catalytically active Lewis acids, micelles of Cu(DS)2 induce rate enhancements up to a factor 1.8710 compared to the uncatalysed reaction in acetonitrile. These enzyme-like accelerations result from a very efficient complexation of the dienophile to the catalytically active copper ions, both species being concentrated at the micellar surface. Moreover, the higher affinity of 5.2 for Cu(DS)2 compared to SDS and CTAB (Psj = 96 versus 61 and 68, respectively) will diminish the inhibitory effect due to spatial separation of 5.1 and 5.2 as observed for SDS and CTAB. [Pg.154]

Success of the reactions depends considerably on the substrates and reaction Conditions. Rate enhancement in the coupling reaction was observed under high pressure (10 kbar)[l 1[. The oxidative addition of aryl halides to Pd(0) is a highly disfavored step when powerful electron donors such as OH and NHt reside on aromatic rings. Iodides react smoothly even in the absence of a... [Pg.127]

With the exception of diamond coloring and the turning of topa2 blue, the source of the irradiation is immaterial. Gamma rays are the preferred source because of uniformity of coloration and the absence of heating and induced radioactivity. The most commonly seen gemstones enhanced by irradiation are summari2ed in Table 4. [Pg.222]

An alternative approach to stimulate cholinergic function is to enhance the release of acetylcholine (ACh). Compounds such as the aminopyridines increase the release of neurotransmitters (148). The mechanism by which these compounds modulate the release of acetylcholine is likely the blockade of potassium channels. However, these agents increase both basal (release in the absence of a stimulus) and stimulus-evoked release (148). 4-Aminopyridine [504-24-5] was evaluated in a pilot study for its effects in AD and found to be mildly effective (149). [Pg.100]

The variable that has the most significant impact on the economics of an extractive distillation is the solvent-to-feed (S/F) ratio. For closeboiling or pinched nonazeotropic mixtures, no minimum-solvent flow rate is required to effect the separation, as the separation is always theoretically possible (if not economical) in the absence of the solvent. However, the extent of enhancement of the relative volatihty is largely determined by the solvent concentration and hence the S/F ratio. The relative volatility tends to increase as the S/F ratio increases. Thus, a given separation can be accomplished in fewer equihbrium stages. As an illustration, the total number of theoretical stages required as a function of S/F ratio is plotted in Fig. 13-75 7 for the separation of the nonazeotropic mixture of vinyl acetate and ethyl acetate using phenol as the solvent. [Pg.1316]

On top of this alloy development, turbine blades for the past two decades have been routinely made from single crystals of predetermined orientation the absence of grain boundaries greatly enhances creep resistance. Metallic monocrystals have come a long way since the early research-centred uses described in Section 4.2.1. [Pg.355]

In the absence of die polyether, potassium fluoride is insoluble in benzene and unreactive toward alkyl halides. Similar enhancement of solubility and reactivity of other salts is observed in the presence of crown ethers The solubility and reactivity enhancement result because the ionic compound is dissociated to a tightly complexed cation and a naked anion. Figure 4.13 shows the tight coordination that can be achieved with a typical crown ether. The complexed cation, because it is surrounded by the nonpolar crown ether, has high solubility in the nonpolar media. To maintain electroneutrality, the anion is also transported into the solvent. The cation is shielded from interaction with the anion as a... [Pg.241]

A deflagration can best be described as a combustion mode in which the propagation rate is dominated by both molecular and turbulent transport processes. In the absence of turbulence (i.e., under laminar or near-laminar conditions), flame speeds for normal hydrocarbons are in the order of 5 to 30 meters per second. Such speeds are too low to produce any significant blast overpressure. Thus, under near-laminar-flow conditions, the vapor cloud will merely bum, and the event would simply be described as a large fiash fire. Therefore, turbulence is always present in vapor cloud explosions. Research tests have shown that turbulence will significantly enhance the combustion rate in defiagrations. [Pg.4]

The formation of a-dithiopyrone by-products during the reaction of an enamine with elemental sulfur and carbon disulfide is enhanced by one or a combination of the following the carbon disulfide is allowed to stand for a long period of time with the enamine in the absence of sulfur, a high reaction temperature, and the use of a relatively nonpolar solvent (135). [Pg.238]


See other pages where Enhancer absence is mentioned: [Pg.908]    [Pg.22]    [Pg.125]    [Pg.153]    [Pg.178]    [Pg.85]    [Pg.5]    [Pg.283]    [Pg.378]    [Pg.318]    [Pg.535]    [Pg.536]    [Pg.536]    [Pg.268]    [Pg.92]    [Pg.548]    [Pg.407]    [Pg.487]    [Pg.252]    [Pg.355]    [Pg.479]    [Pg.529]    [Pg.176]    [Pg.145]    [Pg.450]    [Pg.536]    [Pg.332]    [Pg.389]    [Pg.402]    [Pg.226]    [Pg.490]    [Pg.30]    [Pg.2013]    [Pg.98]    [Pg.114]    [Pg.115]    [Pg.152]    [Pg.245]    [Pg.125]    [Pg.69]    [Pg.5]    [Pg.554]   


SEARCH



Absences

© 2024 chempedia.info