Enantioselectivity Sharpless asymmetric

The first enantioselective total synthesis of (- -)-l 1,12-epoxycembrene C (28) has been accomplished via a macro-olefination strategy by employing titanium-mediated McMurry coupling as a key step and the Sharpless asymmetric epoxidation for the introduction of chiral epoxide. Based on the enantioselective Sharpless asymmetric epoxidation, Li et al. assumed the configuration of natural 28 to be (115,125) (Scheme 6-21). ... 

The development of Sharpless asymmetric epoxidation (SAE) of allylic alcohols in 1980 constitutes a breakthrough in asymmetric synthesis, and to date this method remains the most widely applied asymmetric epoxidation technique [34, 44]. A wide range of substrates can be used in the reaction ( ) -allylic alcohols generally give high enantioselectivity, whereas the reaction is more substrate-dependent with (Z)-allylic alcohols [34]. 

Allylic alcohols can be converted to epoxy-alcohols with tert-butylhydroperoxide on molecular sieves, or with peroxy acids. Epoxidation of allylic alcohols can also be done with high enantioselectivity. In the Sharpless asymmetric epoxidation,allylic alcohols are converted to optically active epoxides in better than 90% ee, by treatment with r-BuOOH, titanium tetraisopropoxide and optically active diethyl tartrate. The Ti(OCHMe2)4 and diethyl tartrate can be present in catalytic amounts (15-lOmol %) if molecular sieves are present. Polymer-supported catalysts have also been reported. Since both (-t-) and ( —) diethyl tartrate are readily available, and the reaction is stereospecific, either enantiomer of the product can be prepared. The method has been successful for a wide range of primary allylic alcohols, where the double bond is mono-, di-, tri-, and tetrasubstituted. This procedure, in which an optically active catalyst is used to induce asymmetry, has proved to be one of the most important methods of asymmetric synthesis, and has been used to prepare a large number of optically active natural products and other compounds. The mechanism of the Sharpless epoxidation is believed to involve attack on the substrate by a compound formed from the titanium alkoxide and the diethyl tartrate to produce a complex that also contains the substrate and the r-BuOOH. ... 

The epoxidation of allylic alcohols can also be effected by /-butyl hydroperoxide and titanium tetraisopropoxide. When enantiomerically pure tartrate ligands are included, the reaction is highly enantioselective. This reaction is called the Sharpless asymmetric epoxidation.55 Either the (+) or (—) tartrate ester can be used, so either enantiomer of the desired product can be obtained. 

The synthetic utility of chiral epoxy alcohol synthons produced by the Sharpless asymmetric epoxidation has been demonstrated in enantioselective syntheses of many important compounds. 

Sharpless "asymmetric epoxidation" has been used in the enantioselective synthesis of several natural products, including the kinetic resolution of allylic alcohols [11] and the creation of ... 

As an example of the usefulness of the Sharpless asymmetric epoxidation the enantioselective synthesis of (-)-swainsonine and an early note by Nicolaou on the stereocontrolled synthesis of 1, 3, 5...(2n + 1) polyols, undertaken in connection with a programme directed towards the total synthesis of polyene macrolide antibiotics, such as amphotericin B and nystatin Aj, will be discussed. 

Reactions where NLE have been discovered include Sharpless asymmetric epoxi-dation of allylic alcohols, enantioselective oxidation of sulfides to sulfoxides, Diels-Alder and hetero-Diels-Alder reactions, carbonyl-ene reactions, addition of MesSiCN or organometallics on aldehydes, conjugated additions of organometal-lics on enones, enantioselective hydrogenations, copolymerization, and the Henry reaction. Because of the diversity of the reactions, it is more convenient to classify the examples according to the types of catalyst involved. 

The use of tartrate esters was an obvious place to start, especially since both enantiomers are readily available commercially and had already found widespread application in asymmetric synthesis (Figure 11) (e.g.. Sharpless asymmetric epoxidation).23.24 Reagents 36-38 are easily prepared and are reasonably enantioselective in reactions with achiral, unhindered aliphatic aldehydes (82-86% ee) typical results are given in Figure 12.3c,h Aromatic and a,p-unsaturated aldehydes, unfortunately, give lower levels of enantioselection (55-70% e.e.). It is also interesting to note that all other C2 symmetric diols that we have examined (2,3-butanediol, 2,4-pentanediol, 1,2-diisopropylethanediol, hydrobenzoin, and mannitol diacetonide, among others) are relatively ineffective in comparison to the tartrate esters (see Table ll).25... 

Sharpless Asymmetric Epoxidation This is a method of converting allylic alcohols to chiral epoxy alcohols with very high enantioselectivity (i.e., with preference for one enantiomer rather than formation of racemic mixture). It involves treating the allylic alcohol with tert-butyl hydroperoxide, titanium(IV) tetra isopropoxide [Ti(0—/Pr)4] and a specific stereoisomer of tartaric ester. For example,... 

Sharpless asymmetric dihydroxylation of simple allylsilanes yields the corresponding diols 182 with moderate enantioselectivity (equation 154)273. However, when 183 is treated under similar conditions, substituted /-lactones 184a and 184b are obtained in high diastereo- and enantioselectivities (equation 155)274-277. 

The highest enantioselectivity (up to >99%) yet achieved in the addition of S-nucleophiles to enones was reported in 2002 by Deng et al. [59]. By systematic screening of monomeric and dimeric cinchona alkaloid derivatives they identified the dihydroquinidine-pyrimidine conjugate (DHQD PYR (72, Scheme 4.35) as the most effective catalyst. This material is frequently used in the Sharpless asymmetric dihydroxylation and is commercially available. Screening of several aromatic thiols resulted in the identification of 2-thionaphthol as the nucleophile giving best yields and enantioselectivity. Examples for the (DHQD PYR-catalyzed addition of 2-thionaphthol to enones are summarized in Scheme 4.35. 

Deng et al. later found that dimeric cinchona alkaloids such as (DHQ AQN (8, Scheme 6.6) and (DHQD PHAL (9, Scheme 6.7) - both well known as ligands in the Sharpless asymmetric dihydroxylation and commercially available - also catalyze the highly enantioselective cyanosilylation of acetal ketones with TMSCN... 

Whereas these solid catalysts tolerate water to some extent, or even use aqueous H2O2 as the oxidant, the use of homogeneous Ti catalysts in epoxi-dation reactions often demands strictly anhydrous conditions. The homogeneous catalysts are often titanium alkoxides, possibly in combination with chiral modifiers, as in the Sharpless asymmetric epoxidation of allylic alcohols (15). There has recently been an increase in interest in supporting this enantioselective Ti catalyst. 

The importance of the enantioselective chemical oxidation of sulfides has long been known. Nevertheless, it was not until the early 1980s that various approaches began to be developed simultaneously. Until very recently, two methods were used in the oxidation of sulfides46,47 those based on the modified Sharpless asymmetric epoxidation,48 and those based on chiral oxaziridines.49 While these methods lead... 

R,R-diphenyl ethylene carbonate CR,R-DPEC)) with a racemic zirconaaziridine. (C2-symmetric, cyclic carbonates are attractive as optically active synthons for C02 because optically active diols are readily available through Sharpless asymmetric dihydroxylations [67].) Reaction through diastereomeric transition states affords the two diastereomers of the spirocyclic insertion product protonolysis and Zr-mediated transesterification in methanol yield a-amino acid esters. As above, the stereochemistry of the new chiral center is determined by the competition between the rate of interconversion of the zirconaaziridine enantiomers and the rate of insertion of the carbonate. As the ratio of zirconaaziridine enantiomers (S)-2/(R)-2 is initially 1 1, a kinetic quench of their equilibrium will result in no selectivity (see Eq. 32). Maximum diastereoselec-tivity (and, therefore, maximum enantioselectivity for the preparation of the... 

This is mainly due to the fact that by means of chiral ligands it is comparatively facile to transfer absolute stereochemical information to a cat-alytically active metal center. However, the success of some of these reactions (e.g. the Sharpless asymmetric epoxidation or the Noyori hydrogenation) must not hide the fact that the number of powerful transition metal-catalyzed C-C coupling reactions, which proceed reliably with high enantioselectivity, is still rather small. 

The first enantioselective total synthesis of ( )-7,8-epoxycembrene C (33) was achieved via a general approach by employing an intramolecular McMurry coupling and Sharpless asymmetric epoxidation as key steps from readily available starting material. The syntheses presented here verified the absolute stereochemistry assignment of the epoxy configuration of 33 as assumed (1R,8R) (Scheme 6-20). °... 

Starting from the chiral pool (/f-(+)-hmonene), the total synthesis of natural (-f)-3,4-epoxycembrene A (56) has been achieved by Liu et al. with the low-valent titanium-mediated intramolecular pinacol couphng of the corresponding sec-keto aldehyde precursor 171 (Scheme 6-25). A more general and efficient enantioselective synthesis of (+)-3,4-epoxy-cembrene A (56) with a chiral pool protocol and Sharpless asymmetric epoxidation for the introduction of three chiral centers has also been reported by the same authors in 2001 (Scheme 6-26). ... 

Sharpless asymmetric epoxidation ° is an enantioselective epoxidation of an allylic alcohol with ferf-butyl hydroperoxide (f-BuOOH), titanium tetraisopropoxide [Ti(0-fPr)4] and (-b)- or (—)-diethyl tartrate [(-b)- or (—)-DET] to produce optically active epoxide from achiral allylic alcohol. The reaction is diastereoselective for a-substituted allylic alcohols. Formation of chiral epoxides is an important step in the synthesis of natural products because epoxides can be easily converted into diols and ethers. 

Asymmetric epoxidation The catalytic asymmetric epoxidation of alkenes has been the focus of many research efforts over the past two decades. The non-racemic epoxides are prepared either by enantioselective oxidation of a prochiral carbon-carbon double bond or by enantioselective alkylidenation of a prochiral C=0 bond (e.g. via a ylide, carbene or the Darzen reaction). The Sharpless asymmetric epoxidation (SAE) requires allylic alcohols. The Jacobsen epoxidation (using manganese-salen complex and NaOCl) works well with ds-alkenes and dioxirane method is good for some trans-alkenes (see Chapter 1, section 1.5.3). 

Aminohydroxylation of unsymmetrically substituted alkenes, in contrast to dihydroxylation, may give two possible regioisomers of aminoalcohol derivatives but asymmetric aminohydroxylation, by using the same catalytic system as that used for Sharpless asymmetric dihydroxylation, can be highly regioselective as well as enantioselective. 

Oxidation of chroman-4-one and its thio analogue with Mn(OAc)3 gives the 3-acetates and subsequent basic hydrolysis yields the 3-hydroxychroman-4-one. Enzymatic hydrolysis of the 0-heterocycle using Amano PS lipase in a phosphate buffer selectively cleaved the (+)-isomer <03TA1489>. Enol ethers derived from chroman-4-one are converted into the 3-hydroxy-chromanone with high enantioselectivity, optimal with the pentyl ether, using a modified Sharpless asymmetric dihydroxylation reaction <03JOC8088>. 

---