Lactones enantioselective separation

The highly ordered cyclic TS of the D-A reaction permits design of diastereo-or enantioselective reactions. (See Section 2.4 of Part A to review the principles of diastereoselectivity and enantioselectivity.) One way to achieve this is to install a chiral auxiliary.80 The cycloaddition proceeds to give two diastereomeric products that can be separated and purified. Because of the lower temperature required and the greater stereoselectivity observed in Lewis acid-catalyzed reactions, the best diastereoselectivity is observed in catalyzed reactions. Several chiral auxiliaries that are capable of high levels of diastereoselectivity have been developed. Chiral esters and amides of acrylic acid are particularly useful because the auxiliary can be recovered by hydrolysis of the purified adduct to give the enantiomerically pure carboxylic acid. Early examples involved acryloyl esters of chiral alcohols, including lactates and mandelates. Esters of the lactone of 2,4-dihydroxy-3,3-dimethylbutanoic acid (pantolactone) have also proven useful. 

CPDMO is a new bioreagent for the synthesis of optically pure lactones with excellent enantioselectivity. CPDMO is not only effective in desymmetrization of meso and prochiral compounds (Procedure 2, Section 11.8.2), but excellent in carrying out the kinetic resolution of racemates (Procedure 3, Section 11.8.3). Additional examples of optically pure lactones that can be obtained are summarized in Table 11.4. In the fermenter work (Procedure 4, Section 11.8.4), (R)-2-methyl cyclohexanone was not converted, but evaporated under aeration condition (1 wm). This led to the expected product (5)-7-methyl oxepanone at the end of the experiment. The optically pure lactone could be recovered without sdica-gel chromatography separation. However, the production yield may be improved by using a better condenser. 

Horse liver alcohol dehydrogenase (HLADH (E.C. 1.1.1.1), commercially available) is a well-documented enzyme capable of catalyzing the enantioselective oxidation of acyclic and cyclic meso-configurated dimethanol derivatives to chiral lactols and further to the corresponding chiral lactones with high enantioselectivity and in high yield (Table 11) 162 ,69. Incases where the two enantiomeric lactols are formed, a kinetic enantiomer separation can occur in the second oxidation step166. 

First success in enantioselective flavouring analysis was achieved by chromatographic separations of diastereomeric derivatives. In spite of limited sensitivity and frequently laborious work-up conditions, these methods revealed reliable insight into enantiomeric distribution of y(5) lactones and other chiral fruit flavouring compounds, as reviewed previously [55]. 

Reaction conditions lactone (4 mmol), BA (1 mmol), Novozym 435 (27 mg), 1,3,5-tri-t-butylbenzene (0.3 mmol, internal standard) in toluene (2 mL) reaction at 70 C. Could not be determined. Experiment performed with excess of 1-octanol (8 mmol) as initiator because of ring-chain equilibrium enzyme dried overnight at 50 °C over P2O5. No significant enantioselectivity was observed for the reaction. Determined in a separate experiment using 2 mmol of isolated (S)-7-MeHL. 2 mmol of 12-MeDDL. Source Reproduced from J. Am. Chem. Soc. 2004, 129, 7393. Copyright 2004 American Chemical Society. 

Scheme 7. Examples for Enantiomer Separations by Crystallization with TADDOLs. Besides the original TADDOL (from tartrate acetonide and PhMgX), Toda et al. [44] have often used the cyclopentanone- and cyclohexanone-derived analogs. The dynamic resolution (resolution with in-situ recychng) of 2-(2-methoxyethyl)cyclohexanone was reported by Tsunoda et al. The resolved compounds shown here are only a small selection from a large number of successful resolutions, which include alcohols, ethers, oxiranes, ketones, esters, lactones, anhydrides, imides, amines, aziridines, cyanohydrins, and sulfoxides. The yields given refer to the amount of guest compound isolated in the procedure given. Since we are not dealing with reactions (for which we use % es to indicate enantioselectivity with which the major enantiomer is formed), we use % ep (enantiomeric purity of the enantiomer isolated from the inclusion...

---