Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Enantiomeric excess, asymmetric

Key Words Iminium, Oxaziridinium, Oxaziridine, Ketiminium, Oxone, Tetra-phenylphosphonium monoperoxysulphate, Isopinocampheylamine, Alkene, Epoxide, Enantiomeric excess. Asymmetric synthesis, Organocatalysis, 2-(2-Bromoethyl)benzaldehyde, Levcromakalim, Dihydroisoquinolinium, Spiro, Azepinium, Benzopyran, Dielectric constant, Binol. 2008 Elsevier B.v. [Pg.177]

Asymmetric hydrogenation has been achieved with dissolved Wilkinson type catalysts (A. J. Birch, 1976 D. Valentine, Jr., 1978 H.B. Kagan, 1978). The (R)- and (S)-[l,l -binaph-thalene]-2,2 -diylblsCdiphenylphosphine] (= binap ) complexes of ruthenium (A. Miyashita, 1980) and rhodium (A. Miyashita, 1984 R. Noyori, 1987) have been prepared as pure atrop-isomers and used for the stereoselective Noyori hydrogenation of a-(acylamino) acrylic acids and, more significantly, -keto carboxylic esters. In the latter reaction enantiomeric excesses of more than 99% are often achieved (see also M. Nakatsuka, 1990, p. 5586). [Pg.102]

The primary disadvantage of the conjugate addition approach is the necessity of performing two chiral operations (resolution or asymmetric synthesis) ia order to obtain exclusively the stereochemicaHy desired end product. However, the advent of enzymatic resolutions and stereoselective reduciag agents has resulted ia new methods to efficiently produce chiral enones and CO-chain synthons, respectively (see Enzymes, industrial Enzymes in ORGANIC synthesis). Eor example, treatment of the racemic hydroxy enone (70) with commercially available porciae pancreatic Hpase (PPL) ia vinyl acetate gave a separable mixture of (5)-hydroxyenone (71) and (R)-acetate (72) with enantiomeric excess (ee) of 90% or better (204). [Pg.162]

An asymmetric synthesis of estrone begins with an asymmetric Michael addition of lithium enolate (178) to the scalemic sulfoxide (179). Direct treatment of the cmde Michael adduct with y /i7-chloroperbenzoic acid to oxidize the sulfoxide to a sulfone, followed by reductive removal of the bromine affords (180, X = a and PH R = H) in over 90% yield. Similarly to the conversion of (175) to (176), base-catalyzed epimerization of (180) produces an 85% isolated yield of (181, X = /5H R = H). C8 and C14 of (181) have the same relative and absolute stereochemistry as that of the naturally occurring steroids. Methylation of (181) provides (182). A (CH2)2CuLi-induced reductive cleavage of sulfone (182) followed by stereoselective alkylation of the resultant enolate with an allyl bromide yields (183). Ozonolysis of (183) produces (184) (wherein the aldehydric oxygen is by isopropyUdene) in 68% yield. Compound (184) is the optically active form of Ziegler s intermediate (176), and is converted to (+)-estrone in 6.3% overall yield and >95% enantiomeric excess (200). [Pg.436]

Asymmetric epoxidation of racemic unsaturated fluoro alcohols by the chiral Sharpless reagent can be exploited for kmetic resolution of enantiomers The recovered stereoisomer has 14-98% enantiomeric excess [55] (equation 50)... [Pg.337]

Apart from tertiary amines, the reaction may be catalyzed by phosphines, e.g. tri- -butylphosphine or by diethylaluminium iodide." When a chiral catalyst, such as quinuclidin-3-ol 8 is used in enantiomerically enriched form, an asymmetric Baylis-Hillman reaction is possible. In the reaction of ethyl vinyl ketone with an aromatic aldehyde in the presence of one enantiomer of a chiral 3-(hydroxybenzyl)-pyrrolizidine as base, the coupling product has been obtained in enantiomeric excess of up to 70%, e.g. 11 from 9 - -10 ... [Pg.29]

The asymmetric epoxidation of an allylic alcohol 1 to yield a 2,3-epoxy alcohol 2 with high enantiomeric excess, has been developed by Sharpless and Katsuki. This enantioselective reaction is carried out in the presence of tetraisopropoxyti-tanium and an enantiomerically pure dialkyl tartrate—e.g. (-1-)- or (-)-diethyl tartrate (DET)—using tcrt-butyl hydroperoxide as the oxidizing agent. [Pg.254]

Although very efficient, the broad application of the direct preparation is restricted due to the limited number of pure starting enantiomers. The design of a multistep process that includes asymmetric synthesis is cumbersome and the development costs may be quite high. This approach is likely best suited for the multi-ton scale production of commodity enantiomers such as the drugs ibuprofen, naproxen, atenolol, and albuterol. However, even the best asymmetric syntheses do not lead to products in an enantiomerically pure state (100 % enantiomeric excess). Typically, the product is enriched to a certain degree with one enantiomer. Therefore, an additional purification step may be needed to achieve the required enantiopurity. [Pg.55]

Asymmetric transfer hydrogenation reducing agents react with 2-aryl azirines to give aziridines in good yields but with moderate enantiomeric excesses (Scheme 4.42) [62],... [Pg.136]

Asymmetric epoxidation of terminal olefins has remained problematic, despite the general success of the novel dioxirane-based catalysts. The enantiomeric excesses in these reactions do not usually exceed 85% (see Section 9.1.1.1). As recrystallization of epoxides can be complicated, enantiopure terminal epoxides are difficult to obtain. [Pg.328]

With the stcrically constrained /(-amino alcohols N-P asymmetric amplification phenomena were observed similar to the effects found with 3-e.Y0-(dimethylamino)isoborneol (vide supra). Thus, alkylation of benzaldehyde with diethylzinc, catalyzed by a partially resolved catalyst N-P, gives 1-phenyl-1-propanol with an enantiomeric excess, which impressively exceeds the optical purity of the catalyst employed12. [Pg.168]

Optically active (Z)-l-substituted-2-alkenylsilanes are also available by asymmetric cross coupling, and similarly react with aldehydes in the presence of titanium(IV) chloride by an SE process in which the electrophile attacks the allylsilane double bond unit with respect to the leaving silyl group to form ( )-s)vr-products. However the enantiomeric excesses of these (Z)-allylsilanes tend to be lower than those of their ( )-isomers, and their reactions with aldehydes tend to be less stereoselective with more of the (E)-anti products being obtained74. [Pg.353]

Trimethyl(l-phenyl-2-propenyl)silane of high enantiomeric excess has also been prepared by asymmetric cross coupling, and reacts with aldehydes to give optically active products in the presence of titanium(IV) chloride. The stereoselectivity of these reactions is consistent with the antiperiplanar process previously outlined75. [Pg.353]

Optically active 3-(trimethylsilyl)cyclopentene of moderate enantiomeric excess is available by asymmetric hydrosilation (see Section 1.3.3.3.5.1.5.) and reacts with aldehydes with reasonable stereoselectivity in the presence of titanium(IV) chloride36. [Pg.354]

Diallyldialkylstannanes with chiral alkyl substituents on the tin, show variable asymmetric induction in their Lewis acid catalyzed reactions with aldehydes. Using bis-(/f)-2-phenylbutyl-(di-2-propenyl)stannane, enantiomeric excesses of up to 54% were obtained via attack on the / e-face of the aldehyde96. [Pg.379]

Chiral imines derived from 1-phenylethanone and (I. Sj-exo-l, 7,7-trimethyIbicyclo-[2.2.1]heptan-2-amine [(S)-isobornylamine], (.S>1-phenylethanamine or (R)-l-(1-naphthyl) ethanamine are transformed into the corresponding (vinylamino)dichloroboranes (e.g., 3) by treatment with trichloroborane and triethylamine in dichloromethane. Reaction of the chiral boron azaenolates with aromatic aldehydes at 25 "C, and subsequent acidic hydrolysis, furnishes aldol adducts with enantiomeric excesses in the range of 2.5 to 47.7%. Significantly lower asymmetric inductions are obtained from additions of the corresponding lithium and magnesium azaenolates. Best results arc achieved using (.S )-isobornylamine as the chiral auxiliary 3. [Pg.599]

Asymmetric Michael additions using chiral auxiliary containing donors have attracted widespread attention and various methods are now available that give high enantiomeric excess. [Pg.972]

Enders and coworkers <96AG(E)1725> have developed an interesting general one-pot method for the asymmetric epoxidation of enones with oxygen in the presence of diethylzinc and (l ,/ )-N-methylpseudoephedrine (30), which provides a, P - epoxyketones in very high yield and high enantiomeric excess (e.g., 33 —> 34). The actual reactive species is believed to be the chirally modified alkoxy(ethylperoxy)zinc 31, which attacks the si face of the s-cis conformation of the (E) enones (cf. 32). [Pg.47]


See other pages where Enantiomeric excess, asymmetric is mentioned: [Pg.363]    [Pg.712]    [Pg.520]    [Pg.521]    [Pg.344]    [Pg.26]    [Pg.363]    [Pg.712]    [Pg.520]    [Pg.521]    [Pg.344]    [Pg.26]    [Pg.126]    [Pg.280]    [Pg.344]    [Pg.484]    [Pg.6]    [Pg.127]    [Pg.129]    [Pg.131]    [Pg.47]    [Pg.345]    [Pg.345]    [Pg.348]    [Pg.355]    [Pg.576]    [Pg.616]    [Pg.681]    [Pg.195]    [Pg.172]    [Pg.828]    [Pg.217]    [Pg.480]    [Pg.61]    [Pg.28]    [Pg.118]    [Pg.46]    [Pg.216]   


SEARCH



Enantiomeric excess

© 2024 chempedia.info