Drying recrystallization during

Apart from glassy hydrates, the evolution of crystalline freeze-drying products during their aging at low to moderate Pj o has little or no effect on the powder micromorphology. Significant recrystallization followed by phase... 

Bromination and Isolation Measure 5 mL of freshly prepared 1 M bromine in dichloromethane directly from the dispenser into the round-bottom flask. Swirl the flask gently during the addition to mix the contents. After the addition of the bromine solution is complete, stopper the reaction flask loosely and stir the mixture for 15 min. Isolate the product by vacuum filtration. Wash the product with one or two 1-mL portions of co/d dichloromethane until it is white. Transfer the product to a watchglass or a piece of filter or weighing paper and allow It to air-dry. Recrystallize the product from xylenes. 

Solute recrystallization during freeze-drying (sublimation stage) Td ( )... 

A suspension of lupuioxinic acid (2 g 2.86 x 10 moi) in toluene (15 ml) is boiled during 5 min. After cooling, the precipitate is removed and dried. Recrystallization from aqueous MeOH gives pure Iupuienoi (270 melting point 118°C 1.7 g 97%). Preparation of hexahvdroluouloxinic acid (271). 

In a 3-I. round-bottomed flask are placed 500 cc. (400 g., 8.7 moles) of absolute alcohol which has been saturated in the cold with hydrochloric acid gas (Note i), 870 cc. (6S0 g., 20 moles) of 96 per cent alcohol (Note 2) and 70 g. (1.03 moles) of methyleneaminoacetonitrile (Note 3). This mixture is refluxed on a steam bath for three hours (Note 4). During the refluxing, ammonium chloride separates. After the reaction is complete, the hot alcohol solution is filtered with suction and the filtrate cooled, thus allowing the glycine ester hydrochloride to separate out in fine white needles. The product is filtered with suction, sucked as dry as possible on the filter, and then allowed to dry in the air. The yield is about no g. The alcohol from the filtrate is distilled (Note 5) until about one-third of its volume is left and again cooled and a second crop of crystals is obtained. The total yield of product, m.p. 142-143, varies from 125 to 129 g. (89-91 per cent of the theoretical amount). If a very pure product is desired, it may be recrystallized from absolute alcohol. 

The dry tosylhydrazone (20 g, 45.5 mmol) is dissolved in 750 ml of 1,2-dimethoxyethane (freshly distilled from lithium aluminum hydride) in a flame-dried 1 liter round bottom flask fitted with a 240 ml addition funnel, a drierite tube and a magnetic stirrer. A 2.05 M ether solution of methyllithium (130 ml, Alfa Inorganics, Inc.—Caution to avoid the mineral oil impurity the methyllithium solution is decanted from a cold solution which contains a precipitate) is placed in the dropping funnel and added over a 60 min period. The temperature of the reaction mixture increases to ca. 35° during the addition however, no cooling precautions are required. The highly colored reaction mixture is stirred for 7 hr and then poured into 1.5 liters of ice water. The flocculent precipitate is digested for 12 hr at room temperature to speed the filtration. After filtration the filter cake is washed with 500 ml water and dried under vacuum at 50° for several hr. The androsta-5,16-dien-3l5-ol is obtained in ca. 70% yield after recrystallization from methanol mp 138-139°. 

Acetylene is passed for 1 hr through a mixture consisting of 0.5 g (72 mg-atoms) of lithium in 100 ml of ethylene-diamine. A solution prepared from 1 g (3.5 mmoles) of rac-3-methoxy-18-methylestra-l,3,5(10)-trien-I7-one and 30 ml of tetrahydrofuran is then added at room temperature with stirring over a period of 30 min. After an additional 2 hr during which time acetylene is passed through the solution the mixture is neutralized with 5 g of ammonium chloride, diluted with 50 ml water, and extracted with ether. The ether extracts are washed successively with 10% sulfuric acid, saturated sodium hydrogen carbonate and water. The extract is dried over sodium sulfate and concentrated to yield a solid crystalline material, which on recrystallization from methanol affords 0.95 g (87%) of rac-3-methoxy-18-methyl-17a-ethynyl-estra-l,3,5(10)-trien-17jB-ol as colorless needles mp 161°. 

The residue (12 g) which contains the 18-iodo-18,20-ether is dissolved in 200 ml of acetone, 5 g of silver chromate is added Note 3) and after cooling to 0°, 11.8 ml of a solution of 13.3 g of chromium trioxide and 11.5 ml of concentrated sulfuric acid, diluted to 50 ml with water is added during a period of 5 min. After an additional 60 min, a solution of 112 g of sodium acetate in 200 ml of water is added and the mixture diluted with benzene (400 ml), filtered and the benzene layer separated. The aqueous phase is reextracted with benzene, washed with half-saturated sodium chloride solution, dried and evaporated to yield 11.2 g of a crystalline residue. Recrystallization from ether gives 7.2 g (72%) of pure 3/5, 1 la, 20/5-trihydroxy-5a-pregnan-18-oic acid 18,20 lactone 3,11-diacetate mp 216-218°. 

A mixture of 2.0 g (0.064 mol) of 2-fluoromethyl-3-(o-tolyl)-6-nitro-4(3H)-qulnazolinone, Oi g of 5% palladium-carbon and 100 ml of acetic acid is shaken for 30 minutes in hydrogen gas. The initial pressure of hydrogen gas is adjusted to 46 lb and the mixture is heated with an infrared lamp during the reaction. After 30 minutes of this reaction, the pressure of hydrogen gas decreases to 6 lb. After the mixture is cooled, the mixture is filtered to remove the catalyst. The filtrate is evaporated to remove acetic acid, and the residue is dissolved in chloroform. The chloroform solution is washed with 5% aqueous sodium hydroxide and water, successively. Then, the solution is dried and evaporated to remove solvent. The oily residue thus obtained is dissolved in 2 ml of chloroform, and the chloroform solution is passed through a column of 200 g of silica gel. The silica gel column is eluted with ethyl acetate-benzene (1 1). Then, the eluate is evaporated to remove solvent. The crude crystal obtained is washed with isopropylether and recrystallized from isopropanol. 0.95 g of 2-fluoromethyl-3-(o-tolyl)-6-amino-4(3H)-quinazolinone Is obtained. Yield 52.5% MP 195°-196°C. 

---