Drinking water tanks

The pipelines and components which come into contact with drinking water on their inner surfaces can be briefly described as follows in the sequence following drinking water treatment by the water supply companies (WSC) drinking water tanks, long-distance lines, distribution lines, domestic service lines, domestic installation (consumer). 

The electrolytes are non-corrosive and the electrodes do not corrode with time. This feature is of special significance when compared with an ordinary liquid resistance starter used commonly for slip-ring motors. Electrolytes do not deteriorate and therefore do not require replacement. The evaporated liquid can be replenished with drinking water when the level of the electrolyte falls as a result of evaporation. In Europe such starters have been used for over 15-20 years. Electrolyte switching is a costlier proposition compared to direct on-line or star/delta switching due to additional shorting contactor and timer, and the cost of electrolyte, its tank and thermostatic control etc. The cost may. 

A proposal for a draft standard on the requirements for the internal cathodic protection of fuel tanks has been put forward by a working party entitled Internal cathodic protection of fuel tanks [18]. This contains the following information an electrolyte is produced by dissolving sodium bicarbonate in drinking water with a resistivity not greater than 2000 Q cm. The solution should completely cover the anodes in the tank. 

Electrochemical corrosion protection of the internal surfaces of reaction vessels, tanks, pipes and conveyor equipment in the chemical, power and petroleum industries is usually carried out in the presence of strongly corrosive media. The range stretches from drinking water through more or less contaminated river, brackish and seawater frequently used for cooling, to reactive solutions such as caustic soda, acids and salt solutions. 

PPO forms one of a group of rigid, heat-resistant, more-or-less selfextinguishing polymers with a good electrical and chemical resistance, low water absorption and very good dimensional stability. This has led to a number of applications in television such as tuner strips, microwave insulation components and transformer housings. The excellent hydrolytic stability has also led to applications in water distribution and water treatment applications such as in pumps, water meters, sprinkler systems and hot water tanks. It is also used in valves of drink vending machines. 

The tank, which was nearly full, contained 15.000 m of diesel oil, which surged out of the failed tank like a tsunami, washing over the dike walls. About 3,000 m3 eseaped from the site into a river that supplied drinking water for neighboring towns, disrupting supplies for a week. Fortunately no one was killed. 

The water supply authorities normally insist that (for uses other than drinking-water taps) their main should discharge into a break-pressure vessel, after which the water quality becomes the consumers responsibility. The water tank should be covered against tramp dirt and access by birds, etc., and it must be shielded from sunlight to avoid the growth of algae. Nevertheless, access must be maintained for easy inspection. The distribution pipework is preferably all plastic and lead must be avoided altogether. The use of copper is doubtful with some corrosive waters, and soldered joints in it can lead to unacceptable concentrations of lead in the water. 

During the 1960s, Americans lived in a lead-drenched society. They fueled their cars with leaded, antiknock gasoline. They ate food and their babies drank milk from lead-soldered cans. They stored drinking water in lead-lined tanks and transported it through lead or lead-soldered pipes. They squeezed toothpaste from lead-lined tubes and poured wine from bottles sealed with lead-covered corks. They picked fruit sprayed with lead arsenate pesticide and served it on lead-glazed dishes in houses painted and puttied with lead-based compounds. 

---