Dimeric structure

At first, the dimeric nature of the base isolated from 3-ethyl-2-methyl-4-phenylthiazolium was postulated via a chemical route. Indeed the adduct of ICH, on a similar 2-ethylidene base is a 2-isopropylthiazolium salt in the case of methylene base it is an anilinovinyl compound identified by its absorption spectrum and chemical reactivity (45-47). This dimeric structure of the molecule has been definitively established by its NMR spectrum. It is very similar to the base issued from 2.3-dimethyl-benzo thiazolium (48). It corresponds to 2-(3 -ethyl-4 -phenyl-2 -methylenethiazolinilydene)2-methyl-3-ethyl-4-phenylthiazoline (13). There is only one methyl signal (62 = 2.59), and two series of signals (63= 1.36-3.90, 63= 1.12-3.78) correspond to ethyl groups. Three protons attributed to positions T,5,5 are shifted to a lower field 5.93, 6.58, and 8.36 ppm. The bulk of the ten phenyl protons is at 7.3 ppm (Scheme 22). 

In the case of phenyllithium, it has been possible to demonstrate by NMR studies that the compound is tetrameric in 1 2 ether-cyclohexane but dimeric in 1 9 TMEDA-cyclohexane. X-ray crystal structure determinations have been done on both dimeric and tetrameric structures. A dimeric structure crystallizes from hexane containing TMEDA. This structure is shown in Fig. 7.1 A. A tetrameric structure incorporating four ether molecules forms from ether-hexane solution. This structure is shown in Fig. 7.IB. There is a good correspondence between the structures that crystallize and those indicated by the NMR studies. 

Fig. 7.1. Crystal structures of phertyllithium (A) dimeric structure incorporating tetra-methylethylenediamine (B) tetrameric structure incorporating dietl l ether., (Reproduced ftom Refs. 28 and 29 with permission of Wiley-VCH and the American Chemical Society.)...

The accessibility of the +4 and +6 oxidation states for sulfur and, to a lesser extent, selenium gives rise to both acyclic and cyclic molecules that have no parallels in N-O chemistry. Thus there is an extensive chemistry of chalcogen diimides RN=E=NR (E = S, Se, Te) (Section 10.4). In the case of Te these unsaturated molecules form dimeric structures reflecting the increasing reluctance for the heavier chalcogens to form multiple bonds to nitrogen. The acyclic molecule N=Sp3,... 

The dilithium triimidochalcogenites [Ei2 E(N Bu)3 ]2 form dimeric structures in which two pyramidal [E(N Bu)3] dianions are bridged by four lithium cations to form distorted, hexagonal prisms of the type 10.13. A fascinating feature of these cluster systems is the formation of intensely coloured [deep blue (E = S) or green (E = Se)] solutions upon contact with air. The EPR spectra of these solutions (Section 3.4), indicate that one-electron oxidation of 10.13a or 10.13b is accompanied by removal of one Ei" ion from the cluster to give neutral radicals in which the dianion [E(N Bu)3] and the radical monoanion [E(N Bu)3] are bridged by three ions. ... 

In view of the facile oxidation of 10.13a-c it is not surprising that some metathetical reactions with metal halides result in redox behaviour. Interestingly, lithium halides disrupt the dimeric structures of 10.13a or 10.13c to give distorted cubes of the type 10.14, in which a molecule of the lithium halide is entrapped by a Ei2[E(N Bu)3] monomer. Similar structures are found for the MeEi, EiN3 and EiOCH=CH2 adducts of 10.13a. In the EiN3 adduct, the terminal... 

In the reactions of 10.13a with alkali metal terr-butoxides cage expansion occurs to give the sixteen-atom cluster 10.15, in which two molecules of MO Bu (M = Na, K) are inserted into the dimeric structure. The cluster 10.13a also undergoes transmetallation reactions with coinage metals. For example, the reactions with silver(I) or copper(I) halides produces complexes in which three of the ions are replaced by Ag" or Cu" ions and a molecule of lithium halide is incorporated in the cluster. ... 

The solvated sulfenamides [Li2( BuNSC6H4Me-4)2(THF)n] (n = 2,4) have dimeric structures with a central Li2N2 ring. The coordination mode is determined by the extent of solvation of the Li" ions monosolvation allows for rj -N,S coordination whereas disolvation restricts the coordination mode to // -M Variable temperature NMR studies indicated that a dynamic exchange between these two structural types occurs in THF solution (Scheme 10.10). The dihapto coordination mode is observed exclusively in transition-metal complexes and the... 

The selenium analogue [PhCNSeSeN] and cyano-functionalized diselenadiazolyl radicals adopt cofacial dimeric structures, e.g., 11.4 (E = Se), with unequal Se Se interactions of ca. 3.15 and 3.35 A. In the latter case the radical dimers are linked together by electrostatic CN Se contacts.Tellurium analogues of dithiadiazolyl radicals (or the corresponding cations) are unknown, but calculations predict that the radical dimers, e.g., 11.4 (E = Te), will be more strongly associated than the sulfur or selenium analogues. ... 

The structure of the UQ-cyt c reductase, also known as the cytochrome bc complex, has been determined by Johann Deisenhofer and his colleagues. (Deisenhofer was a co-recipient of the Nobel Prize in Chemistry for his work on the structure of a photosynthetic reaction center [see Chapter 22]). The complex is a dimer, with each monomer consisting of 11 protein subunits and 2165 amino acid residues (monomer mass, 248 kD). The dimeric structure is pear-shaped and consists of a large domain that extends 75 A into the mito-... 

Figure 22.4 Alternative representations of (a) infinite chains of vanadium atoms in VF5, (b) tetrameric structures of NbFs and TaFs, and (c) dimeric structure of MX5 (M = Mb, Ta X = Cl, Br).

The dimerization reactions of 2-vinylindoles and their alcohol precursors have also been explored, giving rise to the formation of several dimeric structures, such as the 6,12-dihydroindolo[3,2-h]carbazole derivative 160, which was obtained on dimerization of 2-(a-hydroxyethyl)indole under acidic conditions (71JOC1759). 

Again based on the failure of 2-methylindole to form a dimer, Schmitz-DuMont proposed structure (29) for skatole dimer. Structure (30) was, however, shown to be the correct one independently in three... 

The next step in the calculations involves consideration of the allylic alcohol-carbe-noid complexes (Fig. 3.28). The simple alkoxide is represented by RT3. Coordination of this zinc alkoxide with any number of other molecules can be envisioned. The complexation of ZnCl2 to the oxygen of the alkoxide yields RT4. Due to the Lewis acidic nature of the zinc atom, dimerization of the zinc alkoxide cannot be ruled out. Hence, a simplified dimeric structure is represented in RTS. The remaining structures, RT6 and RT7 (Fig. 3.29), represent alternative zinc chloride complexes of RT3 differing from RT4. Analysis of the energetics of the cyclopropanation from each of these encounter complexes should yield information regarding the structure of the methylene transfer transition state. 

Deprotonation of OsH4(PMe2Ph)3 with excess KH in thf at 70°C leads to lipophilic K+[/ac-OsH3(PMe2Ph)3]-. In the solid state, this has a dimeric structure with phenyl rings helping it present a hydrocarbon-like exterior to solvents (Os-H 1.66-1.69 A, Os-P 2.271-2.28 A) [166]. 

This has been shown to have an unusual dimeric structure (Figure 2.18) in which the two planar units are at an angle of 124° [56a],... 

Reaction under controlled conditions with tertiary phosphines leads to partial displacement of alkene retaining the dimeric structure [65]. 

In solution the compounds exhibit solvent-dependent colours in dilute solution in non-polar solvents, planar monomers are present but in more concentrated solutions oligomerization occurs. In the solid state a dimeric structure has been identified (X-ray, Figure 2.30) with R = Ph there is a staggered configuration (Rh-Rh 3.193 A) but with other isocyanides (R = 4-FC6H4) the configuration is eclipsed. 

Figure 2.30 The dimeric structure of [Rh2(PhNQ8]2+ in the solid state.

The methylisocyanide complex has a dimeric structure with a direct metal-metal bond (2.531 A) and only terminal isocyanides, in a staggered configuration (Figure 3.22). 

The aqua ion as a ligand is discussed in section 4.5. Silver forms a range of light-sensitive, insoluble carboxylates that find application in the synthesis of, for example, alkyl halides and esters. The benzoate, trifluoroacetate and perfluorobutyrate have dimeric structures others are polymers (Figure 4.6). 

Figure 4.6 The dimeric structure adopted by some silver carboxylates such as silver trifluoroacetate.

---