Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Determining need for

Determine need for health, safety, and environmental review. ... [Pg.142]

Dust concentration determines need for dry centrifugal plant location, product value determines need for final collectors. High temperatures are usual and corrosive gases not unusual. [Pg.233]

CD4 cell count advisable to assist with determining need for immediate therapy for situations such as pulmonary TBC and severe bacterial infections, which may occur at any CD4 level. [Pg.555]

The natural spin-orbitals, which were first introduced by Lowdin179 in 1955, were shown to produce the most rapidly convergent expansion of the first-order density matrix,180 Thus, the number of determinants needed for any required degree of accuracy in the wavefunction can be greatly reduced if the determinantal wave-functions are constructed from natural orbitals at each stage in the calculation. [Pg.40]

Determine need for and appropriately appoint Command Staff and Section Chiefs, or Branch/Unit/Team leaders and Medical/Technical Specialists as needed distribute corresponding Job Action Sheets and position identification. Assign or complete the Branch Assignment List (HICS Form 204), as appropriate. ... [Pg.151]

The scattering of the results depends upon the soft beta counting of which is sensitive to the self absorption of the source the spectro-photometric determination of unstable cerium (IV) and the great number of experimental determinations needed for calculating the potential. [Pg.306]

Determine need for coinvestigator(s) and outline their roles. [Pg.150]

Use end-of-course measures to determine needs for remediation and for improving fntnre iterations of conrse. [Pg.936]

Measuring techniques Used for OIL levels for determining need for protective actions Instruments Distance... [Pg.168]

With the introduction of electrical measurement methods and shipboard computers into oceanography in the 1960s, electrical conductivity replaced chlorinity as the third basic parameter. Two reasons were responsible for this change. Firstly, conductivity can be measured electrically in situ along with pressure and temperature, and salinity and density can be derived on-line once the fundamental determinations needed for such calculations have been made. Secondly, it turned out that based on electrical conductivity, the accuracy in density that could be achieved is an order of magnitude better than that based on chlorinity. [Pg.41]

Determine need for external relief or recycle to protect the pvimp from low flow and shutoff operation. [Pg.120]

Determine needs for emergency supphes such as water, food, and medical supplies. [Pg.373]


See other pages where Determining need for is mentioned: [Pg.384]    [Pg.403]    [Pg.9]    [Pg.116]    [Pg.130]    [Pg.138]    [Pg.384]    [Pg.150]    [Pg.2673]    [Pg.384]    [Pg.85]    [Pg.413]    [Pg.225]   
See also in sourсe #XX -- [ Pg.55 , Pg.56 ]




SEARCH



© 2024 chempedia.info