Cyclopentane complexes

Comparable results are known for the decomposition of nickela-cyclopentane complexes wMch lead, depending on the ligand-to-metal ratio to cyclobutane, 1-butene and ethylene... 

The reactivity of a number of alkane complexes has been examined and this field has been reviewed through 1996 by Hall and Perutz. Flash photolysis of Cr(CO)6 in cyclohexane showed that solvation occurs within the first picosecond after photolysis, a fact that appears to rule out spin crossing as an important component in the dissociation of CO from Cr(CO)6. The stability of CpRe(CO)2(alkane) is particularly striking. Comparison of the rate constants for heptane solvated metal complexes with CO, Table 1, reveals that the rate constant for CpRe(CO)2(heptane) is five orders of magnitude slower than that of CpV(CO)3 (heptane). In fact, the stability of the CpRe(CO)2(alkane) complexes is so high that it has been possible to carry out low-temperature NMR on the cyclopentane complex generated by continuous photolysis of... 

The rhoda- and irida-cyclopentane complexes[M(CH2CH2CH2CH2)-(CgMOg)(PPh3)] (M=Rh, Ir) undergo p-H abstraction on treatment with the trityl cation to give a o-3-butenyl intermediate which is... 

Pallada(iv)cyclopentane complexes can be obtained from oxidative addition of organic halides to known pallada(ii)cyclopentanes at —20°C in acetone. In this way, [PdX(R)(C4H8)(bpy)] for R = Me, Et, PhCH , GH2=CH-CH2 164-167 have been isolated and were fully characterized. For all cases reported, stereospecific trans-2idd x on took place, except for Mel 164a and 164b were obtained in a 1 4 ratio. Complexes 166 and 167 are stable at 20 °C, but 164 and 165 are unstable these may be stored at —20°C for a few days. A similar complex with R = CF3 168 was too unstable to permit isolation, but was identified by Decomposition of the compounds... 

The term naphthenic acid, as commonly used in the petroleum industry, refers collectively to all of the carboxyUc acids present in cmde oil. Naphthenic acids [1338-24-5] are classified as monobasic carboxyUc acids of the general formula RCOOH, where R represents the naphthene moiety consisting of cyclopentane and cyclohexane derivatives. Naphthenic acids are composed predorninandy of aLkyl-substituted cycloaUphatic carboxyUc acids, with smaller amounts of acycHc aUphatic (paraffinic or fatty) acids. Aromatic, olefinic, hydroxy, and dibasic acids are considered to be minor components. Commercial naphthenic acids also contain varying amounts of unsaponifiable hydrocarbons, phenoHc compounds, sulfur compounds, and water. The complex mixture of acids is derived from straight-mn distillates of petroleum, mosdy from kerosene and diesel fractions (see Petroleum). 

Oxygen compounds in crude oils are more complex than the sulfur types. However, their presence in petroleum streams is not poisonous to processing catalysts. Many of the oxygen compounds found in crude oils are weakly acidic. They are carboxylic acids, cresylic acid, phenol, and naphthenic acid. Naphthenic acids are mainly cyclopentane and cyclohexane derivatives having a carboxyalkyl side chain. 

The retrosynthetic maneuvers that we have addressed thus far have only resulted in simplification of the vicinal side-chain substituents appended to carbons 8 and 12 we have yet to address the marked stereochemical complexity of the cyclopentane nucleus of... 

PGF2a- The cyclopentane ring of the Corey lactone (9) is the host of four contiguous stereogenic centers. Retrosynthetic simplification of 9 provides 10, a construct which is more complex than 9 Nevertheless, intermediate 10 possesses structural features that satisfy the requirement for the iodolactonization transform. The iodolactone in 10 constitutes the retron for the iodolactonization transform.11 Cleavage of the indicated bonds in 10 sacrifices two of the five stereocenters and provides unsaturated carboxylic acid... 

A direct application of the ring-opening reaction of an epoxide by a metal enolate amide for the synthesis of a complex molecule can be found in the synthesis of the trisubstituted cyclopentane core of brefeldin A (Scheme 8.35) [68a]. For this purpose, treatment of epoxy amide 137 with excess KH in THF gave a smooth cyclization to amide 138, which was subsequently converted into the natural product. No base/solvent combination that would effect cyclization of the corresponding aldehyde or ester could be found. 

The reaction of methyl acrylate and acrylonitrile with pentacarbonyl[(iV,iV -di-methylamino)methylene] chromium generates trisubstituted cyclopentanes through a formal [2S+2S+1C] cycloaddition reaction, where two molecules of the olefin and one molecule of the carbene complex have been incorporated into the structure of the cyclopentane [17b] (Scheme 73). The mechanism of this reaction implies a double insertion of two molecules of the olefin into the carbene complex followed by a reductive elimination. 

Cyclopropyl ketones 32 and cyclopropyl imines 33 can also undergo [3+2] cycloaddition reactions with enones 34 in presence of NHC-Ni complexes to afford the corresponding cyclopentane compounds 35 (Scheme 5.9) [11]. The catalytic system is prepared in situ from the use of [Ni(COD),], SIPr HCl salt and KOBu, the reaction also required the use of Ti(O Bu) as an additive to improve yields and increase reactions rates. In most of the cases, th products 35 were obtained in good to excellent diastereoselectivities. 

An enantioselective variant of the diene cydization reaction has been developed by application of chiral zirconocene derivatives, such as Brintzinger s catalyst (12) [10]. Mori and co-workers demonstrated that substituted dial-lylbenzylamine 25 could be cyclized to pyrrolidines 26 and 27 in a 2 1 ratio using chiral complex 12 in up to 79% yield with up to 95% ee (Eq. 4) [ 17,18]. This reaction was similarly applied to 2-substituted 1,6-dienes, which provided the analogous cyclopentane derivatives in up to 99% ee with similar diastereoselectivities [19]. When cyclic, internal olefins were used, spirocyclic compounds were isolated. The enantioselection in these reactions is thought to derive from either the ate or the transmetallation step. The stereoselectivity of this reaction has been extended to the selective reaction of enantiotopic olefin compounds to form bicyclic products such as 28, in 24% yield and 59% ee after deprotection (Eq. 5) [20]. 

The mechanism for the reaction catalyzed by cationic palladium complexes (Scheme 24) differs from that proposed for early transition metal complexes, as well as from that suggested for the reaction shown in Eq. 17. For this catalyst system, the alkene substrate inserts into a Pd - Si bond a rather than a Pd-H bond [63]. Hydrosilylation of methylpalladium complex 100 then provides methane and palladium silyl species 112 (Scheme 24). Complex 112 coordinates to and inserts into the least substituted olefin regioselectively and irreversibly to provide 113 after coordination of the second alkene. Insertion into the second alkene through a boat-like transition state leads to trans cyclopentane 114, and o-bond metathesis (or oxidative addition/reductive elimination) leads to the observed trans stereochemistry of product 101a with regeneration of 112 [69]. 

Palladium complexes are effective catalysts for the reductive cydization of enyne substrates [53,54], The first report of catalytic cydization of 1,6- and 1,7-enynes 115a,b to cyclopentane 116a and cyclohexane 116b derivatives appeared in 1987 (Eq. 19) [70]. The authors proposed that the Pd(II) species 117 forms by oxidative addition of acetic acid to Pd(0) (Scheme 25). Complex 117 hydrometallates the alkyne to give 118, which cyclizes to provide... 

C-Chiral diphosphinites based on cyclohexane and cyclopentane rings (31) (cf. structure 17) have been used in 1 1 rhodium complexes at 50 atm H2 in unspecified solvents (259, 260). 

The CpFe(C0)2 2 hy adduct exhibits no catalytic activity in the temperature range studied (200-300°C). However cyclo-pentene and cyclopentane are detected through GC monitoring of the gas-phase. A redox reaction Fe(0)/H+ is still occurring as for the Fe3(C0)12"HY adduct the evolved hydrogen allows the reduction of the cyclopentadienyl ligands. This behaviour already provides evidence for the location of the Fe(l) complexes within the large cavities of the zeolite. 

Heptadiene and zirconocene, generated from zirconocene dichloride and butyllithium, form an intermediate, presumably the metallocycle 222, which is transformed into fraws-l,2-di(bromomethyl)cyclopentane (223) by the action of bromine at —78°C. In contrast, a similar reaction of 1,6-heptadene with Cp ZrCl (Cp = pentamethylcyclopentadienyl) (from Cp ZrCl3 and sodium amalgam) gives solely the c -isomer 225 via the complex 224 (equation 114)117. 

---