Cyclohexenones preparation

Chiral cyclohexanones obtained by the Ferrier carbocyclization reaction are useful precursors for the synthesis of cyclitols and aminocyclitols, some of which are found in clinically important aminoglycoside antibiotics. Additionally, highly substituted cyclohexenones, prepared by the Ferrier carbocyclization followed by (3-elimination, can undergo various further transformations, also making these compounds potential chiral building blocks for the preparation of structurally complex compounds having cyclohexane unit(s). This section provides an overview of the reported synthetic strategies toward various types of natural products based on utilization of the Ferrier carbocyclization reaction. 

The optically active 1,4-cyclohexenediol monoacetate 525, prepared by hydrolysis of the me.so-diacetate with lipase, was converted into the optically pure cyclohexenone 526 by an elimination reaction in the presence of ammonium formate. Optically active carvone (527) was prepared from 526[343],... 

The preparation of 3-ethoxy-2-cyclohexenone is described elsewhere in this volume. ... 

The purity of the 2-cyclohexenone may be assayed by gas chromatography on an 8 mm. x 215 cm. column heated to 125° and packed with di-(2-ethylhexyl) sebacate suspended on ground firebrick. This method of analysis indicates that the 3-cyclo-hexenone in the product amounts to no more than 3%. The fore-run from this fractional distillation contains substantial amounts of 2-cyclohexenone accompanied by ether, ethanol, and minor amounts of other lower-boiling impurities. Additional quantities of pure 2-cyclohexenone can be recovered by redistillation of this fore-run. The preparation of 2-cyclohexenone has been run on twice the scale described with no loss in yield. The ultraviolet spectrum of an ethanol solution of the 2-cyclohexenone obtained has a maximum at 226 m/i (s = 10,400). 

Cyclohexenone has been prepared by dehydrohalogenation of 2-bromocyclohexanone, by the hydrolysis and oxidation of 3-chlorocyclohexene, by the dehydration of a-hydroxycyclohexa- ione, by the oxidation of cyclohexene with chromic acid or hydrogen peroxide in the presence of a vanadium catalyst, by I lie addition of acroleiti to ethyl acetoacctate followed by cycliza-lion, hydroly.sis, and decar])oxylation, by the reduction of N,N-dimelliyliiniline with sodium and ethanol itt liquid ammonia... 

Ethoxy-2-cyclohexenone has been prepared by reaction of the silver salt of dihydroresorcinol with ethyl iodide and by the reaction of dihydroresorcinol with ethyl orthoformate, ethanol and sulfuric acid." The acid-catalyzed reaction of dihydroresorcinol with ethanol in benzene solution utilized in this preparation is patterned after the procedure of Frank and Hall. ... 

Displacement of Vinyl fluorine or chloride by secondary amines has given some unusual enamines as illustrated for the preparation of 1,1-difluoro-2-piperidino-3-phenyl-2-cyclobutene (151) (US), l,l-difluoro-2,4-dipiperidino-3-phenyl-2-cyclobutene (152) (114), and 2-phenyl-3-(l -aziridinyl)-2-cyclohexenone (153) (115). 

How would you prepare the following substances from 2-cyclohexenone More than one step may be required. 

The conjugate addition of Grignard reagents to 2-cyclohexenone was promoted by catalytic amounts (2-4 mol %) of alkylcopper(I) complexes of the lithium amide prepared from N- (R)-1 -phenylethyl]-2-[(/ )-l-phenylethyliminojcycloheptatrienamine, Li[CuR(CHIRAMT)]52,11. However, 3-substituted cyclohexanones were obtained in very low ee (4-14%). 

In contrast, a-alkoxycuprate 10, prepared from the corresponding stannane, gave the conjugate addition product with only 0-20% ee upon treatment with 2-cyclohexenone in the presence ofchlorotrimethylsilane67. However, the conjugate addition of 10 to ethyl propynoatc in the presence of chlorotrimethylsilane provided 11 in 85% yield with nearly 96% ee67. 

The starting materials for annulative cyclization are cycloalkenones that contain the allylsilane side chain in the 4-position. Such starting materials can easily be prepared from vinylogous esters40. Furthermore, reactions of 3-alkoxy-2-cyclohexenones with functionalized iodides in the presence of lithium diisopropylamide provides an excellent route to such precursors41 34 35. 

Protected cyanohydrins may be employed as acyl anion equivalents in 1,4-additions in the presence of HMPA129. For instance cyanohydrins prepared from arylaldehydes add in a 1,4-fashion under thermodynamic control (THF or THF/HMPA) to cyclohexenone, isophorone and decalone systems in the latter case c/.s-octahydro-2(l/f)-naphthalenones are exclusively obtained 130-131. 

Conjugated cyclohexenones [6] have also been easily prepared by combining the cycloaddition of dimethylaminobutadiene 4 and several cyclic and acyclic dienophiles followed by the elimination of the amino group from the cycloadducts under acidic conditions. Scheme 2.3 summarizes some of these results. 

Table 10 Result of one-pot preparation method of optically active epoxides (67a-d) by a combination of epoxidation of cyclohexenone and enantiomer resolution in a water suspension medium... 

Another class of new ligands was prepared in quantitative yields by Feringa et al., in 1997, by reaction between a-mercapto acids, aniline and 2-pyridine-carboxaldehyde." These pyridyl-substituted thiazolin-4-one ligands were further involved in the copper-catalysed conjugate addition of ZnEt2 to 2-cyclohexenone,... 

An useful intermediate for the preparation of 1,4-cyclohexanediones is obtained by cycloaddition of 6-isopropyl-3-methyl-2-cyclohexenone to a cyclobutanediol derivative (4.59) 470>. 

The solvent is removed by distillation through a 15-cm. Vigreux column, first at atmospheric pressure and finally at reduced pressure (water aspirator). The residue is satisfactory for the preparation of 2-methyl-2-cyclohexenone described below (part B). Distillation through the column gives, after a small fore-run, 243-248 g. (83-85%) of colorless 2-chloro-2-methylcyclohexanone, b.p. 94 96°/27 mm., tin 1.4672, 1.088 (Note 3). 

Methyl-2-cyclohexenone has been prepared (a) by the action of ni-t rosyl chloride on 1-methylcydohexene, followed by dehydrohalogena-I ion with sodium methoxide4 or sodium acetate,6 and hydrolysis of the resulting oxime (b) in an impure condition by several methods 6-12... 

Scheme 5.20) To a solution of n-nonanoylzirconocene chloride (1.5 mmol) in diethyl ether (10 mL)/THF (5 mL), prepared as described above, were added cyclohexenone (1.0 mmol), BF3 OEt2 (1.0 mmol), and Pd(OAc)2 (10 mol%) at 0°C, and the resulting mixture was stirred at this temperature for 12 h. After extractive work-up as described above, purification by chromatography on silica gel gave 3 -w-nonanoylcyclohexanone in 60% yield. 

The reaction itself is rather attractive and useful as a synthetic tool, because of its practical simplicity. Indeed, 1,5-dicarbonyl compounds can be readily prepared from olefin and 1,3-dicarbonyl compound in a one-pot reaction. Subsequent aldolization of the resulting 1,5-dicarbonyl compounds would furnish cyclohexenones. The reaction mechanism and stereochemistry of the de Mayo reaction has been comprehensively reviewed7), and the basic strategy of which has also been developed and extended. The following examples would demonstrate some applications and variations of the de Mayo reaction. 

Moreover, these rare earth heterobimetallic complexes can be utilized for a variety of efficient catalytic asymmetric reactions as shown in Scheme 7 Next we began with the development of an amphoteric asymmetric catalyst assembled from aluminum and an alkali metal.1171 The new asymmetric catalyst could be prepared efficiently from LiAlH4 and 2 mol equiv of (R)-BINOL, and the structure was unequivocally determined by X-ray crystallographic analysis (Scheme 8). This aluminum-lithium-BINOL complex (ALB) was highly effective in the Michael reaction of cyclohexenone 75 with dibenzyl malonate 77, giving 82 with 99% ee and 88 % yield at room temperature. Although LLB and... 

Organobis(cupratesY, spiroannelation.16 1,4-Dilithiobutane, prepared from 1,4-dichlorobutane and lithium in ether at 0°, on reaction with copper thiophenoxide (2 equiv.) forms a biscuprate, formulated as 1 for convenience. This dimetallic reagent adds to 3-halo-5,5-dimethyl-2-cyclohexenones (2) to form the spiro-[4.5]decanone 3 in yields as high as 96%. Cuprates prepared from other Cu(I) sources are less efficient, as is the cuprate prepared from di-Grignard reagents... 

On the other hand, doubly deprotonated nitroalkenes are reagents with a double reactivity inversion (Scheme 5.30) provided they are used to prepare normal 0-, A-derivatives [1]. For instance, the 1-nitrobutadiene dianion 43 reacts with electrophiles to give a mixture of a- and y-isomers, 44a and 44b. Addition of the dianion 43 to 2-cyclohexenone gives only the y-adduct 45 which was transfomed into the 1,7-ketoaldehyde 46 by a Nef-type reaction with TiCl3 [38]. As shown in Scheme 5.30, although the resulting product is a "consonant system" (1,7-C), the... 

In order to arrive at optically pure (+)-luciduline, first of all it was necessary to prepare the starting cyclohexenone 31 with the correct absolute configuration. The natural and easily available monoterpene (+)-pulegone 32 was choosen as the source of optically pure (+)-(f )-5-methyl-2-cyclohexenone 31. 

Acylation reactions can also be greatly improved in this way, with t-alkyl- or sec-alkyl-manganese reagents reacting with acid chlorides in excellent yields [123]. The related addition-elimination to 3-ethoxy-2-cyclohexenone is also improved, resulting after acidic aqueous workup in 3-methyl-2-cyclohexenone [125]. The perilla-ketone 126 was prepared in an improved yield using copper(I) catalysis (Scheme 2.58) [129]. 

Finally, spiro-compounds such as 138 can be prepared by treatment of zircona-cylopentadienes such as 139 with 3-iodo-2-cyclohexenone in the presence of CuCl (2 equiv.) (Scheme 2.67) [144]. 

---