Hydrogenation cyclic alkenes, stereoselective

Epoxidation of cyclic alkenes is stereoselective, with reaction taking place on the less hindered face, or directed by hydrogen bonding to a hydroxyl group OAc OAc OH OH... 

The preferred stereochemistry of addition to cyclic alkenes is anti The additions are not as highly stereoselective as hydrogen bromide addition, however. 

Control over regioselectivity and stereoselectivity in the formation of new C-C a-bond is required to utilize the Heck reaction in complex molecule synthesis. For the intramolecular Heck reaction, the size of the ring formed in the insertion step controls the regiochemistry, with 5-exo and 6-exo cyclization favoured. A mixture of regioisomers is formed from Heck insertions of acyclic alkenes, whereas cyclic alkenes such as cycloalkenes as a Heck substrate produce a a-arkylpalladium(II) intermediate A, which has only one syn-P-hydrogen. Syn-elimination of the hydrogen provides only product B (Scheme 5.6). 

Thus far, chemists have been able to influence the stereoselectivity of macro-cyclic RCM through steric and electronic substrate features or by the choice of a catalyst with appropriate activity, but there still exists a lack of prediction over the stereochemistry of macrocyclic RCM. One of the most important extensions of the original metathesis reaction for the synthesis of stereochemi-cally defined (cyclo)alkenes is alkyne metathesis, followed by selective partial hydrogenation. 

If the carbanion has even a short lifetime, 6 and 7 will assume the most favorable conformation before the attack of W. This is of course the same for both, and when W attacks, the same product will result from each. This will be one of two possible diastereomers, so the reaction will be stereoselective but since the cis and trans isomers do not give rise to different isomers, it will not be stereospecific. Unfortunately, this prediction has not been tested on open-chain alkenes. Except for Michael-type substrates, the stereochemistry of nucleophilic addition to double bonds has been studied only in cyclic systems, where only the cis isomer exists. In these cases, the reaction has been shown to be stereoselective with syn addition reported in some cases and anti addition in others." When the reaction is performed on a Michael-type substrate, C=C—Z, the hydrogen does not arrive at the carbon directly but only through a tautomeric equilibrium. The product naturally assumes the most thermodynamically stable configuration, without relation to the direction of original attack of Y. In one such case (the addition of EtOD and of Me3CSD to tra -MeCH=CHCOOEt) predominant anti addition was found there is evidence that the stereoselectivity here results from the final protonation of the enolate, and not from the initial attack. For obvious reasons, additions to triple bonds cannot be stereospecific. As with electrophilic additions, nucleophilic additions to triple bonds are usually stereoselective and anti, though syn addition and nonstereoselective addition have also been reported. 

When the same substituents are at each end of the double or triple bond, it is called symmetrical. Unsymmetrical means different substituents are at each end of the double or triple bond. Electrophilic addition of unsymmetrical reagents to unsymmetrical double or triple bonds follows Markovnikov s rule. According to Markovnikov s rule, addition of unsymmetrical reagents, e.g. HX, H2O or ROH, to an unsymmetrical alkene proceeds in a way that the hydrogen atom adds to the carbon that already has the most hydrogen atoms. The reaction is not stereoselective since it proceeds via a planar carbocation intermediate. However, when reaction proceeds via a cyclic carbocation intermediate, it produces regiospecific and stereospecific product (see below). A regioselective reaction is a reaction that can potentially yield two or more constitutional isomers, but actually produces only one isomer. A reaction in which one stereoisomer is formed predominantly is called a stereoselective reaction. 

---