Cut threads

Rubber thread of circular section (see Cut Thread) made by extruding compounded latex through glass nozzles into a coagulating bath of acid. 

Although it often is cheaper to cut threads than to cast them, for many pieces cast threads usually are more economical. Male threads usually are made with a parting parallel to the axis this leaves a flash at the parting. The flash can be removed with a shaving tool in some instances, but in others a chasing operation is necessary. 

If the entry holes for the 1" pipe cap and 3" pipe cap are tight for the screw, start the screw in and then back it out. This will cut threads into the pipe. If the holes are not that tight the screw will push through without threading. Ideally, the screw should go in tightly. 

Taps having no flutes, known as cold-forming taps, produce the thread hy plastic deformation of the material and therefore no swarf is produced hy the action. This type of tap is used with ductile materials such as soft steels, aluminium and zinc alloys. Because the material is displaced, the tapping drill Is larger than that for taps which cut, e.g. an MIO cut thread has a tapping drill of 8.5mm, while an MIO cold-formed thread has a tapping drill of 9.3 mm. 

Threads can be cast on high-pressure machines but should be specified only where their use reduces cost over that for machine-cut threads. Cast internal threads under 20 mm in diameter are rarely economical. 

Gradient block copolymer in which there is a gradual change of composition at the junction between the two blocks from pure AAAAAAAA type to pure BBBBBBBB type. The tapered block copolymers are reported to be more efficient than pure AB block copolymers as compatibilizers of polymer blends. Tapping cutting threads in the walls of a circular hole. 

In cutting threads, either hy tapping with serial taps or threading with die and die stock, frequent stops should be made. The tap or die should be backed off occasionally to clear the thread and remove the chips. A coolant or lubricant is not essential, but, if available, its use is recommended to minimize heat and to flush away chips. 

Cut Threads Threads may be either cut or rolled. Cut threads are machined from a piece of bar stock by removal of material by machining. The distinctive feature being that the shank of the bolt is the same diameter as the OD of the threads. 

Moving away the cut thread ends manually behind the presser foot. 

Cut threads are produced by cutting away or otherwise physically removing steel from a round bar to form the threads. 

Several fault tree analysts have used the case of the desintegrating bit of an electrical drill to illustrate the fault tree process A steel worker is cutting threads in the steel with an electrical drill, when the drill breaks to the effect of the worker being hit in the eye by one of the flying bits. 

---