Cure times

Cure time is the time required for vulcanization of the rubber compound to reach the desired state of cure for the desired property. 

---

The volatile content of the treated paper is important because moisture acts as a temporary plasticizer to promote resin flow during early stages of pressing (9). Dynamic mechanical analysis of the treated paper is a very useful means to study the initial flow stages of a resin and the cure time required to complete cross-linking (10). 

Fig. 2. Cure curve from oscillating disk rheometer where A represents scorch safety B, cure rate C, state of cure D, optimum cure time and E, reversion.

In one experiment the effect of ppd assay was correlated to scorch safety. As the ppd degrades Hberate free amine, scorch time decreases and cure rate is faster. The degradation products apparentiy serve to activate the cure, since both the induction time, and cure time, decrease with decreasing ppd assay. However, the effect on unaged properties is minimal. 

A significant revision to the SMR scheme was introduced in 1991 in response to consumer desire for greater consistency in natural mbber (13). Other producing countries have similar specification schemes (14), as does the International Standards Organization (ISO) (15). An example of the specifications for TSR is given in Table 1 for the present Standard Malaysian scheme. Except for SMR 5, rheograph and cure test data (delta torque, optimum cure time, and scorch) are provided. 

Proof Casting of Dies and Molds. Low melting ahoys make the process of diemaking faster and easier. The low temperature ahoys can be cast into a mold pattern at virtuahy any point in the manufacturing process without long delays in production and without the possibhity of heat distortion. These ahoys produce a casting that is exact in detail, requires no curing time, and is completely reusable. 

Unsaturated polyester resins predominate among fiber-reinforced composite matrices for several reasons. A wide variety of polyesters is available and the composites fabricator must choose the best for a particular appHcation. The choice involves evaluation of fabrication techniques, temperatures at which the resin is to be handled, cure time and temperature desked, and requked cured properties (see Polyesters, unsaturated). 

Accelerators may be added to improve the physical properties of the polymer when needed. Where high modulus or low oil swell is required, thiocarbanihde is the preferred accelerator, with a cure time of 60 min at 100°C. Tetraethyl thiuram disulfide and sodium dibutyl dithiocarbamate are preferred for high tensile strength and cured at 121°C. 

Curing time will also depend upon the thickness of coat and the shape of the workpiece. 

The paint is then cured in an oven. The curing time will depend upon the thickness of coat, shape of the workpiece and type of oven and its effectiveness. Generally, a coat of up to 60-70 microns at a stoving temperature of 180-200 C (depending upon the type of powder) should take around 10-12 minutes to cure. Contact the manufacturers for exact details. 

Similar reactions also occur with organic peroxides, dioximes, paint driers such as cobalt naphthenate and furfural. It is interesting to note that the cure time is dependent on the humidity of the atmosphere. With lead peroxide the rate doubles by increasing the relative humidity from 40 to 70%. The most important... 

---