Critical points fields

This is the well known equal areas mle derived by Maxwell [3], who enthusiastically publicized van der Waal s equation (see figure A2.3.3. The critical exponents for van der Waals equation are typical mean-field exponents a 0, p = 1/2, y = 1 and 8 = 3. This follows from the assumption, connnon to van der Waals equation and other mean-field theories, that the critical point is an analytic point about which the free energy and other themiodynamic properties can be expanded in a Taylor series. 

An essential feature of mean-field theories is that the free energy is an analytical fiinction at the critical point. Landau [100] used this assumption, and the up-down symmetry of magnetic systems at zero field, to analyse their phase behaviour and detennine the mean-field critical exponents. It also suggests a way in which mean-field theory might be modified to confonn with experiment near the critical point, leading to a scaling law, first proposed by Widom [101], which has been experimentally verified. 

The assumption that the free energy is analytic at the critical point leads to classical exponents. Deviations from this require tiiat this assumption be abandoned. In mean-field theory. 

The integral under the heat capacity curve is an energy (or enthalpy as the case may be) and is more or less independent of the details of the model. The quasi-chemical treatment improved the heat capacity curve, making it sharper and narrower than the mean-field result, but it still remained finite at the critical point. Further improvements were made by Bethe with a second approximation, and by Kirkwood (1938). Figure A2.5.21 compares the various theoretical calculations [6]. These modifications lead to somewhat lower values of the critical temperature, which could be related to a flattening of the coexistence curve. Moreover, and perhaps more important, they show that a short-range order persists to higher temperatures, as it must because of the preference for unlike pairs the excess heat capacity shows a discontinuity, but it does not drop to zero as mean-field theories predict. Unfortunately these improvements are still analytic and in the vicinity of the critical point still yield a parabolic coexistence curve and a finite heat capacity just as the mean-field treatments do. 

That analyticity was the source of the problem should have been obvious from the work of Onsager (1944) [16] who obtained an exact solution for the two-dimensional Ising model in zero field and found that the heat capacity goes to infinity at the transition, a logarithmic singularity tiiat yields a = 0, but not the a = 0 of the analytic theory, which corresponds to a finite discontinuity. (Wliile diverging at the critical point, the heat capacity is synnnetrical without an actual discontinuity, so perhaps should be called third-order.)... 

The field-density concept is especially usefiil in recognizing the parallelism of path in different physical situations. The criterion is the number of densities held constant the number of fields is irrelevant. A path to the critical point that holds only fields constant produces a strong divergence a path with one density held constant yields a weak divergence a path with two or more densities held constant is nondivergent. Thus the compressibility Kj,oi a one-component fluid shows a strong divergence, while Cj in the one-component fluid is comparable to (constant pressure and composition) in the two-component fluid and shows a weak... 

However, for more complex fluids such as high-polymer solutions and concentrated ionic solutions, where the range of intemiolecular forces is much longer than that for simple fluids and Nq is much smaller, mean-field behaviour is observed much closer to the critical point. Thus the crossover is sharper, and it can also be nonmonotonic. 

Little is known about higher order critical points. Tetracritical points, at least imsynnnetrical ones, require four components. However for tetracritical points, the crossover dimension mean-field, or at least analytic. 

Figure A3.3.2 A schematic phase diagram for a typical binary mixture showmg stable, unstable and metastable regions according to a van der Waals mean field description. The coexistence curve (outer curve) and the spinodal curve (iimer curve) meet at the (upper) critical pomt. A critical quench corresponds to a sudden decrease in temperature along a constant order parameter (concentration) path passing through the critical point. Other constant order parameter paths ending within tire coexistence curve are called off-critical quenches.

Bruce A D and Wilding N B 1992 Scaling fields and universality of the liquid-gas critical point Phys. Rev.L 68 193-6... 

Vector quantities, such as a magnetic field or the gradient of electron density, can be plotted as a series of arrows. Another technique is to create an animation showing how the path is followed by a hypothetical test particle. A third technique is to show flow lines, which are the path of steepest descent starting from one point. The flow lines from the bond critical points are used to partition regions of the molecule in the AIM population analysis scheme. 

The calculations that have been carried out [56] indicate that the approximations discussed above lead to very good thermodynamic functions overall and a remarkably accurate critical point and coexistence curve. The critical density and temperature predicted by the theory agree with the simulation results to about 0.6%. Of course, dealing with the Yukawa potential allows certain analytical simplifications in implementing this approach. However, a similar approach can be applied to other similar potentials that consist of a hard core with an attractive tail. It should also be pointed out that the idea of using the requirement of self-consistency to yield a closed theory is pertinent not only to the realm of simple fluids, but also has proved to be a powerful tool in the study of a system of spins with continuous symmetry [57,58] and of a site-diluted or random-field Ising model [59,60]. 

The mean field treatment of such a model has been presented by Forgacs et al. [172]. They have considered the particular problem of the effects of surface heterogeneity on the order of wetting transition. Using the replica trick and assuming a Gaussian distribution of 8 Vq with the variance A (A/kT < 1), they found that the prewetting transition critical point is a function of A and... 

A single triplet has three resonant fields, two due to Amv= l transitions and one due to Ams 2 transitions. For amorphous or polycrystalline samples, two triplet powder patterns are formed due to contributions from all possible orientations of triplets with respect to the applied field. The full-field triplet powder pattern due to Ahia-= 1 transitions is centered about If and has the following critical points ... 

In the field of PI, the transposition of the chemical reaction operation from batch to continuous mode represents a critical point. In this chapter, some examples of HEX reactors, allowing this transposition, have been presented. 

Points on the zero-flux surfaces that are saddle points in the density are passes or pales. Should the critical point be located on a path between bonded atoms along which the density is a maximum with respect to lateral displacement, it is known as a pass. Nuclei behave topologically as peaks and all of the gradient paths of the density in the neighborhood of a particular peak terminate at that peak. Thus, the peaks act as attractors in the gradient vector field of the density. Passes are located between neighboring attractors which are linked by a unique pair of trajectories associated with the passes. Cao et al. [11] pointed out that it is through the attractor behavior of nuclei that distinct atomic forms are created in the density. In the theory of molecular structure, therefore, peaks and passes play a crucial role. 

Fig. 35 Phase diagrams AB miktoarm-star copolymers for n = 2, n = 3, n = 4 and n = 5. mean-field critical point through which system can transition from disordered state to Lam phase via continuous, second-order phase transition. All other phase transitions are first-order. From [112]. Copyright 2004 American Chemical Society...

---