Critical micellar density

Several impressive applications of SAFT has been reported, such as the critical micellar densities for the PVAC-PTAN (a block copolymer)-C02 system and systems including telechelic polymers. 

Experiments have shown that no polyelectrolyte-micelle complexation occurs when the micellar surface charge density is below the critical charge density I(TcI. Above this density, the turbidimetric titration curves reveal a dramatic increase in turbidity that indicates complexation, because the average molecular mass of the complexes is much larger than that of polyelectrolytes alone. The complexes may... 

Studies of the adsorption of surface active electrolytes at the oil-water interface provide a convenient method for testing electrical double layer theory and for determining the state of water and ions in the neighborhood of an interface. The change in the surface amount of the large ions modifies the surface charge density. For instance, the surface ionic area of 100 per ion corresponds to 16, /rC/cm. The measurement of the concentration dependence of the changes of surface potential were also applied to find the critical concentration of formation of the micellar solution [18]. 

The characteristic effect of surfactants is their ability to adsorb onto surfaces and to modify the surface properties. Both at gas/liquid and at liquid/liquid interfaces, this leads to a reduction of the surface tension and the interfacial tension, respectively. Generally, nonionic surfactants have a lower surface tension than ionic surfactants for the same alkyl chain length and concentration. The reason for this is the repulsive interaction of ionic surfactants within the charged adsorption layer which leads to a lower surface coverage than for the non-ionic surfactants. In detergent formulations, this repulsive interaction can be reduced by the presence of electrolytes which compress the electrical double layer and therefore increase the adsorption density of the anionic surfactants. Beyond a certain concentration, termed the critical micelle concentration (cmc), the formation of thermodynamically stable micellar aggregates can be observed in the bulk phase. These micelles are thermodynamically stable and in equilibrium with the monomers in the solution. They are characteristic of the ability of surfactants to solubilise hydrophobic substances. 

For a pure supercritical fluid, the relationships between pressure, temperature and density are easily estimated (except very near the critical point) with reasonable precision from equations of state and conform quite closely to that given in Figure 1. The phase behavior of binary fluid systems is highly varied and much more complex than in single-component systems and has been well-described for selected binary systems (see, for example, reference 13 and references therein). A detailed discussion of the different types of binary fluid mixtures and the phase behavior of these systems can be found elsewhere (X2). Cubic ecjuations of state have been used successfully to describe the properties and phase behavior of multicomponent systems, particularly fot hydrocarbon mixtures (14.) The use of conventional ecjuations of state to describe properties of surfactant-supercritical fluid mixtures is not appropriate since they do not account for the formation of aggregates (the micellar pseudophase) or their solubilization in a supercritical fluid phase. A complete thermodynamic description of micelle and microemulsion formation in liquids remains a challenging problem, and no attempts have been made to extend these models to supercritical fluid phases. 

---