Cooling Crack

The best joins are those that are made without delay. Should any interruption occur in feeding the molten rod into the space between the ends, the whole join must be reheated to avoid cooling cracks. 

If the crystal does not survive cooling (cracks appear or intensity of the reflections is lost) or it cannot be transferred intact into the loop (or seems to react or decompose inside the oil, as happens occasionally), the crystal can be sealed into a capillary crystal holder (see Fig. 1). The advantages of this procedure are that the crystal is in contact only with the mother solvent (actually surrounded by it all the time) and that the data collection can be performed at room temperature. Disadvantages are the extreme care needed to seal and manipulate the fragile capillary crystal holder, which is unique for each crystal, and the possible movement of the crystal inside the capillary tube during data collection. 

Wide lamellae on belite, corroded alite, and cooling cracks Alkali in clinker (Gille and others, 1965)... 

The stress in the refractory itself should also be determined based on this analysis to ensure that the refractory material is not overstressed. In any refractory system, the hot face of the refractory expands at a greater rate then the cold wall steel. This keeps the refractory in compression when hot, and seals the cracks. When cooled, cracks will develop in the refractory due to the different temperatures and properties of the steel and refractory. 

A water-condenser can be used for any liquid the boiling-point of which does not exceed 140°. Above this temperature, an air-condenser (i.e., a straight glass tube having no jacket) should be used. If a water-condenser is used above 140°, there is always a risk of the condenser cracking at the point where the hot vapour first meets the water-cooled portion. 

Flexural modulus increases by a factor of five as crystallinity increases from 50 to 90% with a void content of 0.2% however, recovery decreases with increasing crystallinity. Therefore, the balance between stiffness and recovery depends on the appHcation requirements. Crystallinity is reduced by rapid cooling but increased by slow cooling. The stress—crack resistance of various PTFE insulations is correlated with the crystallinity and change in density due to thermal mechanical stress (118). 

Hydrogenation of the oxides of carbon to methane according to the above reactions is sometimes referred to as the Sabatier reactions. Because of the high exothermicity of the methanization reactions, adequate and precise cooling is necessary in order to avoid catalyst deactivation, sintering, and carbon deposition by thermal cracking. 

The flame-space walls are stainless steel and are water cooled. No mechanical coke scraper is required. A water quench cools the cracked gas stream rapidly at the poiat of maximum acetyleae and this is followed by a secondary water quench. The primary quench poiat can be adjusted for variation ia throughput, to accommodate the depeadeace of acetyleae yield oa resideace time ia the flame space. 

Stainless steel alloys show exceUent corrosion resistance to HCl gas up to a temperature of 400°C. However, these are normally not recommended for process equipment owing to stress corrosion cracking during periods of cooling and shut down. The corrosion rate of Monel is similar to that of mild steel. Pure (99.6%) nickel and high nickel alloys such as Inconel 600 can be used for operation at temperatures up to 525°C where the corrosion rate is reported to be about 0.08 cm/yr (see Nickel and nickel alloys). 

The success of the process results from the fact that nowhere inside the furnace is heat extracted from the copper-saturated blast furnace buUion through a soUd surface. The problem of accretion formation (metal buUd-up), which has plagued many other attempts to estabUsh a copper dtossing operation of this type, does not arise. In the cooling launder, lead-rich matte and slag accumulate on the water-cooled plates, but these ate designed so that when they ate lifted from the buUion stream, the dross cracks off and is swept into the furnace via the cooled lead pot. 

---