Conventional combinations

Meanwhile, the A convention combined with replacement nomenclature may be used to indicate the changed bonding number of the anionic site, and the suffix -ide appended, as shown in (202) and (203). Proposals for an anionic replacement prefix, analogous to the cationic -onia prefixes, are under consideration. 

Conventional combinations Salts of strong acids and alkalis are, of course, almost completely ionised in dilute solutions. For some purposes, however, it is convenient to regard the ions as being in combination, and various systems of conventional combinations have been developed. In Britain, the system most used takes the metals and acid radicals in the order shown in Table 2.13 (after Thresh, Beale and Suckling). For example, if the amount... 

If potassium is present in significant quantities and is determined it is usually inserted in the conventional combination table after magnesium and before sodium (78 K ... 

The significance of conventional combinations arises largely in two classes of supply (ff) those in which the method indicates sodium bicarbonate to be present and ib) those similarly found to contain magnesium chloride or calcium chloride. 

OOAlthough pyrazinamide is a part of conventional combination therapy for children with tuberculosis, as in adults (11), there is little published information on its safety. In those with raised transaminases before the start of therapy there was no increase during therapy, and the activities normalized in all patients after its conclusion. 

International Convention for the prevention of pollution from ships (Marpol 73/78). The convention combines 2 treaties adopted in 1973 and 1978 respectively. The agreements include all aspects of pollution from ships - harmful substances, chemicals, garbage, sewage, oil, with the exception of the disposal of waste into sea by dumping. 

Co-cyprindiol is a mixture of the anti-androgenic progestogen, cyproter-one acetate 2 mg, with ethinylestradiol 35 micrograms. It is used for the treatment of acne and moderately severe hirsutism in women who may also wish to use it as an oral contraceptive, and its contraceptive efficacy is expected to be reduced by the same hepatic enzyme inducers (see Table 28. r, (p.975)) that interact with conventional combined oral contraceptives. The precautions described in this section for the combined hormonal contraceptives with the various drugs listed in Table 28.1 , (p.975), should therefore be followed, see Hormonal contraceptives + Antiepileptics Barbiturates or Phenytoin , p.985. 

Additional advantages are obtainable regarding environmental compatibility and electronics waste-disposal regulations. MID technology allows the material mixture of a (conventional) combination of PCB and mechanical parts, which usually consist of a great number of materials, to be replaced by a metallized plastic part (MID). MIDs are made of thermoplastics, which can be recycled and are noncritical in disposal (Franke 1995). 

Conventional Combination Pressure Head and Die Assembly for Soft Extrusion of Common Bricks... 

Fig. 18 Some typical split tiles Fig. 19 Conventional combination pressnre...

Does not have any restrictions precluding use by conventional combination vehicles ... 

The GT-off design performance has also been investigated by Naqvi et al [76], The use of C02-rich stream gas turbine is also included in the analysis, which accounts for 14% of the electric gross power produced. The net electric efficiency is around 52% in the case of maximum solid temperature of 1200°C (Figure 5.26), and the electric efficiency decay due to the part-load operation is lower than that in the conventional combined cycle (higher than 94% of the nominal electrical efficiency in the case of 54% of full load) if an advanced control strategy is adopted. 

The MARS concept is largely based on proven technical features however, the reactor is rated as innovative because it uses a non-conventional combination of such technical features, incorporates a strong reliance on inherent and passive safety features, and provides for a longlife core operation without on-site refuelling. 

About 50 concepts and designs of the innovative SMRs are under development in more than 15 IAEA Member States representing both industrialized and developing countries. SMRs are under development for all principle reactor lines, i.e., water cooled, liquid metal cooled, gas cooled, and molten salt cooled reactors, as well as for some non-conventional combinations... 

---