CONTENTS 4 Polymer Compatibility

Glues chosen for use in bonding material with low absorbency and permeability should not have high carrier (especially water) content. High-carrier glues require suflScient assembly time ( preferably open assembly) to allow for dissipation of most of their carrier. A better option would probably be to use solvent solutions of polymer compatible with the consolidant. 

Of special interest are the systems obtained in the course of polymerization of monomers in which another polymer is dissolved but is not compatible with the polymers obtained from these monomers. In such a case, at certain degrees of polymerization the dissolved polymer precipitates in form of the dispersed phase owing to the appearance of incompatibility the content and size of the particles of the dispersed phase can be controlled by changing the polymers compatibility, their weight ratio, the system viscosity, and the rate of pol3rmerization. 

Unlike most crystalline polymers, PVDF exhibits thermodynamic compatibiUty with other polymers (133). Blends of PVDF and poly(methyl methacrylate) (PMMA) are compatible over a wide range of blend composition (134,135). SoHd-state nmr studies showed that isotactic PMMA is more miscible with PVDF than atactic and syndiotactic PMMA (136). MiscibiUty of PVDF and poly(alkyl acrylates) depends on a specific interaction between PVDF and oxygen within the acrylate and the effect of this interaction is diminished as the hydrocarbon content of the ester is increased (137). Strong dipolar interactions are important to achieve miscibility with poly(vinyhdene fluoride) (138). PVDF blends are the object of many papers and patents specific blends of PVDF and acryflc copolymers have seen large commercial use. 

Carbopol is widely used in cosmetic and pharmaceutical practice as a gel-former. Carbopol resins are hydrophilic polymers which swell in water solutions and transform into the gel form at neutralization. At the elaboration of special cosmetic preparations in which carbopol is used, the problem of raw materials compatibility appears. For example, some extracts of aromatic pectin containing materials destroy the gel structure of carbopol. High contents of bivalent metal ions, in particular calcium ions, destructively influence onto the gel-making ability of the system too. 

The main classes of plasticizers for polymeric ISEs are defined by now and comprise lipophilic esters and ethers [90], The regular plasticizer content in polymeric membranes is up to 66% and its influence on the membrane properties cannot be neglected. Compatibility with the membrane polymer is an obvious prerequisite, but other plasticizer parameters must be taken into account, with polarity and lipophilicity as the most important ones. The nature of the plasticizer influences sensor selectivity and detection limits, but often the reasons are not straightforward. The specific solvation of ions by the plasticizer may influence the apparent ion-ionophore complex formation constants, as these may vary in different matrices. Ion-pair formation constants also depend on the solvent polarity, but in polymeric membranes such correlations are rather qualitative. Insufficient plasticizer lipophilicity may cause its leaching, which is especially undesired for in-vivo measurements, for microelectrodes and sensors working under flow conditions. Extension of plasticizer alkyl chains in order to enhance lipophilicity is only a partial problem solution, as it may lead to membrane component incompatibility. The concept of plasticizer-free membranes with active compounds, covalently attached to the polymer, has been intensively studied in recent years [91]. 

---