Configuration record

Documentation (e.g., configuration records, test records, validation protocols, validation reports, etc.)... 

The business owner of a particular system is ultimately accountable for the electronic retention of business data. Support groups are often delegated responsibility for the electronic record retention of technical data such as operating systems, source code, configuration records, and any other software necessary to operate the application itself, including supporting documentation for these components. 

Servers should be subject to configuration management and change control procedures. Configuration records should be in place for server hardware and software. 

Installation qnalification Communications operating system configuration records Change control reports Parameter change control records Documentation change control records... 

Trajectories are initiated in the reactant region, collisions are evaluated classically on the interpolated surface, and the molecular configuration is recorded periodically during the simulation. The N, configurations recorded indicate the regions of the surface most often sampled by the trajectories, presumably regions of chemical importance. Each of the sampled trajectory points, R(y), y = l,...,A, are then allocated a weight, h[R( )] ... 

TABLE 2. Translocation Configurations Recorded after Irradiation of Spermato-... 

Lewis and Nyman applied a variant of the hysteresis method to study the fracture resistance of UHMWPE after sterilization by different techniques and accelerated aging [69]. In this study, a single specimen was loaded in a three-point bending configuration, recording the load, P, versus displacement, D, curve until the latter reached 8mm. The areas under the P-D curve up to six selected displacements, Dj were calculated and used to obtain the corresponding J values. The Ji-D pairs were plotted and a curve best fitted to the data points was also obtained. Then, the asymptotic crack extension line was drawn and its intersection... 

Anumber of defects with manual inspection indications clarified by AUGUR 4.2 records have been accepted for further operation in 1996 with prescription of next year AUGUR 4 2 inspection. Based on two consecutive inspections (1996-97 years) comparative analysis of AUGUR 4.2 data was executed. It was shown that the flaw configurations, reproduced by AUGUR 4.2 are stable and the small differences are conditioned only by system thresholds of linear coordinate and signal amplitude as well as variations in local conditions of in-site inspection. 

When used in the 3D inspection system PS-4 is configured only for recording of A-scan data with attached unambiguous 3D transducer position and orientation information, since the reeonstruction is done in the attached 3D UltraSIM/UlRecon reconstruction module. 

Eleven chirality centers may seem like a lot but it is nowhere close to a world record It is a modest number when compared with the more than 100 chirality centers typ ical for most small proteins and the thousands of chirality centers present m nucleic acids A molecule that contains both chirality centers and double bonds has additional opportunities for stereoisomerism For example the configuration of the chirality center m 3 penten 2 ol may be either R or S and the double bond may be either E or Z There fore 3 penten 2 ol has four stereoisomers even though it has only one chirality center... 

The amplitudes of oscillations will depend upon weight, stiffness and configuration. The record of these oscillations is known as free vibration record. The rate of oscillations will determine the natural frequency of the object. Figure 14.20 shows one such free vibration record. 

Figure 4.25. Experimental configuration for optical pyrometry of shock temperatures induced in transparent minerals. Upon impact of projectile with driver plate, a shock wave is driven into the driver plate and then into the sample. Optical radiation from the sample is detected via six lens/interference filter channels and an array of six photodiodes. Signals from photodiode circuits are recorded on oscilloscopes operating in single sweep model. (After Ahrens et al. (1982).)...

The configuration of the product in terms of its design standard, deviations, nonconformities, and design changes to be recorded prior to and subsequent to the tests... 

---