Concentration oxygen, stationary

The instrumental analyzer procedure, EPA Method 3A, is commonly used for the determination of oxygen and carbon dioxide concentrations in emissions from stationary sources. An integrated continuous gas sample is extracted from the test location and a portion of the sample is conveyed to one or more instrumental analyzers for determination of O9 and CO9 gas concentrations (see Fig. 25-30). The sample gas is conditioned prior to introduction to the gas analyzer by removing particulate matter and moisture. Sampling is conducted at a constant rate for the entire test run. Performance specifications and test procedures are provided in the method to ensure reliable data. 

We used polycrystalline films of ZnO and Sn02 as adsorbents. The films were deposited from the water suspension of respective oxides on quartz substrates. These substrates contained initially sintered contacts made of platinum paste. The gap between contacts was of about lO" cm. All samples were initially heated in air during one hour at T 500 C. We used purified molecular oxygen an acceptor particle gas. H and Zn atoms as well as molecules of CO were used as donor particles. We monitored both the kinetics of the change of ohmic electric conductivity and the tangent of inclination angle of pre-relaxation VAC caused by adsorption of above gases and the dependence of stationary values of characteristics in question as functions of concentrations of active particles. 

It should be noted however that the method related to the measurements of equilibrium or stationary oxygen concentrations by means of sensors is not always applicable and convenient even in this particular case. Sometimes too much time is required to conduct these measure-... 

It was first shown in study [37] that adsorption of N-atoms on films of zinc oxide reduces its conductivity to a certain stationary value which depends, as with oxygen atoms, both on the stationary concentration of particles in the volume adjacent to the sensor s film and on the temperature. 

In order to find the relationship between the stationary concentration of current carriers in semiconductor film and concentration of dissolved oxygen in polar liquid, it is essential to examine the expression for rate of chemisorbtion of dissolved oxygen molecules on ZnO film and its chemical desorbtion from the surface under effect of solvent... 

Kds are the constants of rates of chemical reactions of oxygen adsorption and desorbtion from ZnO film and Aq are electron work function from ZnO before oxygen gets adsorbed and its variation caused by dipole moment of adsorbed complexes being formed U is the adsorption activation energy of non-electrostatic nature [ M] is the concentration of solvent molecules. Apparently we can write down the following expression for the stationary system ... 

Therefore, the kinetics of generation of defects in surface-adjacent layers is similar to kinetics of emission of O-atoms. (The estimates indicate that the maximum concentration of vacancies in this case may attain the value of 10 for a sample with area 1 cm ). If one assumes that the emission of oxygen atoms is caused by processes of annihilation of vacancies in the sample, then the coincidence in time dependence of stationary concentration of defects can be indicative that these processes are limited by generation of defects, which, in its turn, is controlled by processes of formation of oxide phase in surface-adjacent silver layers. Oxidation, especially at initial stage, is characterized by intensive formation of defects [54]. 

DR. ENDICOTT In fact, the cobalt-eyelam-oxygen adduct can have a very short lifetime depending on the competition reactions. If the cobalt dioxygen adduct is generated in the presence of greater concentrations of CoAA([l4]aneN ), the intermediate lifetime is clearly shortened. The classical studies made by Ralph Wilkins, for instance, were carried out under conditions in which intermediates only achieved small stationary state concentrations. 

---