Chromium trioxide ethers

Steroidal 17-cyanohydrins are relatively stable towards chromium trioxide in acetic acid (thus permitting oxidation of a 3-hydroxyl group ) and towards ethyl orthoformate in ethanolic hydrogen chloride (thus permitting enol ether formation of a 3-keto-A system ). Sodium and K-propanol reduction produces the 17j -hydroxy steroid, presumably by formation of the 17-ketone prior to reduction. ... 

No systematic study of the minimal required amount of lead tetraacetate has been made. In cases where the product of the hypoiodite reaction is an iodo ether (20-hydroxy steroids) the reaction can be interrupted at the iodohydrin stage by reducing the amount of iodine to about 0.5 mole. For the oxidation of iodo ethers to lactones, chromium trioxide-sulfuric acid in acetone has been used. Silver chromate is often added to the reaction mixture but comparable yields are obtained without the addition of silver salt. 

The residue (12 g) which contains the 18-iodo-18,20-ether is dissolved in 200 ml of acetone, 5 g of silver chromate is added Note 3) and after cooling to 0°, 11.8 ml of a solution of 13.3 g of chromium trioxide and 11.5 ml of concentrated sulfuric acid, diluted to 50 ml with water is added during a period of 5 min. After an additional 60 min, a solution of 112 g of sodium acetate in 200 ml of water is added and the mixture diluted with benzene (400 ml), filtered and the benzene layer separated. The aqueous phase is reextracted with benzene, washed with half-saturated sodium chloride solution, dried and evaporated to yield 11.2 g of a crystalline residue. Recrystallization from ether gives 7.2 g (72%) of pure 3/5, 1 la, 20/5-trihydroxy-5a-pregnan-18-oic acid 18,20 lactone 3,11-diacetate mp 216-218°. 

To which a solution of manganese sulfate (15 g), 3.1 g of chromium trioxide, 72 ml of water and 3.5 ml of sulfuric acid was added. After stirring for 3.5 hours at 3°C, extracted with diethyl ether. The organic layer was washed with water, dried over sodium sulfate and concentrated under reduced pressure. The residue was purified by column chromatography on silica gel using ethyl acetate-benzene (1 1) as eluent to give 2.35 g of the title compound. 

CHROMIUM TRIOXIDE-PYRIDINE COMPLEX, preparation in situ, 55, 84 Chrysene, 58,15, 16 fzans-Cinnamaldehyde, 57, 85 Cinnamaldehyde dimethylacetal, 57, 84 Cinnamyl alcohol, 56,105 58, 9 2-Cinnamylthio-2-thiazoline, 56, 82 Citric acid, 58,43 Citronellal, 58, 107, 112 Cleavage of methyl ethers with iodotri-methylsilane, 59, 35 Cobalt(II) acetylacetonate, 57, 13 Conjugate addition of aryl aldehydes, 59, 53 Copper (I) bromide, 58, 52, 54, 56 59,123 COPPER CATALYZED ARYLATION OF /3-DlCARBONYL COMPOUNDS, 58, 52 Copper (I) chloride, 57, 34 Copper (II) chloride, 56, 10 Copper(I) iodide, 55, 105, 123, 124 Copper(I) oxide, 59, 206 Copper(ll) oxide, 56, 10 Copper salts of carboxylic acids, 59, 127 Copper(l) thiophenoxide, 55, 123 59, 210 Copper(l) trifluoromethanesulfonate, 59, 202... 

Oxidation of that compound with chromium trioxide in sulfuric acid leads cleanly to the desired ketone (67). Treatment with hydrobromic acid serves to demethylate the phenolic ether function (68). Direct... 

The oxidation of both linear and cyclic ethers to the corresponding acids and lactones by aqueous H202 as catalyzed by TS-1 and TS-2 was reported by Sasidharan et al. (241) (Scheme 17 and Table XXXV). The titanosilicates exhibited significantly better activity (about 55% conversion) and selectivity (98%) than chromium silicates, although vanadium silicates totally failed to catalyze the reaction. Such conversions are usually accomplished using either stoichiometric amounts of chromium trioxide, lead tetraacetate, or ruthenium tetroxide as oxidants (242) or catalytic amounts of Ru04 in the presence of... 

---