Charge transfer definition

Atomic Charges and the Charge Transfer Definition of Electronegativity... 

Electrocatalysis Again by definition, an electrocatalyst is a solid, in fact an electrode, which can accelerate a process involving a net charge transfer, such as e.g. the anodic oxidation of H2 or the cathodic reduction of 02 in solid electrolyte cells utilizing YSZ ... 

In our opinion, the interesting photoresponses described by Dvorak et al. were incorrectly interpreted by the spurious definition of the photoinduced charge transfer impedance [157]. Formally, the impedance under illumination is determined by the AC admittance under constant illumination associated with a sinusoidal potential perturbation, i.e., under short-circuit conditions. From a simple phenomenological model, the dynamics of photoinduced charge transfer affect the charge distribution across the interface, thus according to the frequency of potential perturbation, the time constants associated with the various rate constants can be obtained [156,159-163]. It can be concluded from the magnitude of the photoeffects observed in the systems studied by Dvorak et al., that the impedance of the system is mostly determined by the time constant. 

An HSAB analysis of singlet carbene reactivity based on B3LYP/6-31G computations has calculated the extent of charge transfer for substituted alkenes,122 and the results are summarized in Figure 10.3 The trends are as anticipated for changes in structure of both the carbene and alkene. The charge transfer interactions are consistent with HOMO-LUMO interactions between the carbene and alkene. Similarly, a correlation was found for the global electrophilicity parameter, co, and the ANmax parameters (see Topic 1.5, Part A for definition of these DFT-based parameters).123... 

Upon dimerization, electron charge is transferred from the base (the H-acceptor molecule) to the acid (the H-donor molecule), in agreement with Lewis generalized definition of an acid and a base as an electron acceptor and donor, respectively. The amount of such a charge transfer (CT) is reported in Table 4, for the two SCF models considered in this paper and as a function of the basis set size. The CTs are small and, for the SCF-SM method, are found to decrease as the basis set size increases. 

Parsons, R., Electrode reaction orders, charge transfer coefficients and rate constants. Extension of definitions and recommendations for publication of parameters. Pure Appl. Chem., 52, 233 (1979). 

This quantity represents the energy of the multiple-site charge-transfer interaction which will later play an important role in the theory of stereoselection. It is to be remarked that, although any MO may involve an arbitrary constant of which the absolute value is unity, the value of the numerator in each term of the right side of this equation is always definite. 

The model shown in Scheme 2 indicates that a change in the formal oxidation state of the metal is not necessarily required during the catalytic reaction. This raises a fundamental question. Does the metal ion have to possess specific redox properties in order to be an efficient catalyst A definite answer to this question cannot be given. Nevertheless, catalytic autoxidation reactions have been reported almost exclusively with metal ions which are susceptible to redox reactions under ambient conditions. This is a strong indication that intramolecular electron transfer occurs within the MS"+ and/or MS-O2 precursor complexes. Partial oxidation or reduction of the metal center obviously alters the electronic structure of the substrate and/or dioxygen. In a few cases, direct spectroscopic or other evidence was reported to prove such an internal charge transfer process. This electronic distortion is most likely necessary to activate the substrate and/or dioxygen before the actual electron transfer takes place. For a few systems where deviations from this pattern were found, the presence of trace amounts of catalytically active impurities are suspected to be the cause. In other words, the catalytic effect is due to the impurity and not to the bulk metal ion in these cases. 

Electrochemical reactions can be broken down into two groups outer-sphere electron-transfer reactions and inner-sphere electron transfer reactions. Outer-sphere reactions are reactions that only involve electron transfer. There is no adsorption and no breaking or forming of chemical bonds. Because of their simplicity, numerous studies have been performed, many entirely theoretical.18-25 By definition, though, electrode reactions are not outer-sphere reactions. However, if charge transfer is rate limiting for an electrode reaction, it typically takes a form similar to that of an outer-sphere reaction, which is described later in this section. 

Now, as in the case of the energy, up to this point, we have worked with the nonsmooth expression for the electronic density. However, in order to incorporate the second-order effects associated with the charge transfer processes, one can make use of a smooth quadratic interpolation. That is, with the two definitions given in Equations 2.23 and 2.24, the electronic density change Ap(r) due to the electron transfer AN, when the external potential v(r) is kept fixed, may be approximated through a second-order Taylor series expansion of the electronic density as a function of the number of electrons,... 

It was not until recently that Chen and Goodman probed the influence of the oxide support material on the intrinsic properties at the metal surface. By covering a titania support with one or two flat atomic layers of gold they eliminated, direct adsorbate-support interactions as well as particle size and shape effects. Their results definitively showed that the electronic properties at the metal surface changed due to charge transfer between the support and the metal. Furthermore, their comparison of one- and two-layer films highlighted the dependence of these effects on the thickness of the metal slab. 

Brown (1959) has presented a charge transfer model of the transition state for electrophilic reactions which differs appreciably from that proposed by Fukui and his collaborators and leads to the definition of a new reactivity index termed the Z value . The model is based on a more conventional formulation of the charge transfer mechanism, which avoids the complete transfer of electrons associated with v = 0,1,2 in Fukui s model. There is no dependence on the formation of a pseudo tt orbital in the transition state, nor is hyperconjugation invoked. A wave function for a charge transfer complex is written as a linear combination of a wave function < o describing the unperturbed ground state of the molecule under attack, and a function which differs from (Pq in the replacement... 

---