Charge repulsion

For example, van den Tempel [35] reports the results shown in Fig. XIV-9 on the effect of electrolyte concentration on flocculation rates of an O/W emulsion. Note that d ln)ldt (equal to k in the simple theory) increases rapidly with ionic strength, presumably due to the decrease in double-layer half-thickness and perhaps also due to some Stem layer adsorption of positive ions. The preexponential factor in Eq. XIV-7, ko = (8kr/3 ), should have the value of about 10 " cm, but at low electrolyte concentration, the values in the figure are smaller by tenfold or a hundredfold. This reduction may be qualitatively ascribed to charged repulsion. 

Charge-charge repulsion effects in protolytically activating charged electrophiles certainly play a significant role, which must be overcome. Despite these effeets multidentate protolytic interactions with superacids can take plaee, increasing the electrophilie nature of varied reagents. 

We found a way to overcome charge-charge repulsion when activating the nitronium ion when Tewis acids were used instead of strong Bronsted acids. The Friedel-Crafts nitration of deactivated aromatics and some aliphatic hydrocarbons was efficiently carried out with the NO2CI/3AICI3 system. In this case, the nitronium ion is coordinated to AICI3. 

Alternatively, ions moving toward a quadrupole can gain sufficient kinetic energy in the z-direction by space-charge repulsion from following ions. 

Approximately a minimum of 1 to 5,000 is required before complexation is no longer dependent on molecular weight for small anions such as KI and l-ariiLinonaphthaLine-8-sulfonate (ANS) (86,87). The latter anion is a fluorescent probe that, when bound in hydrophobic environments, will display increased fluorescence and, as expected, shows this effect in the presence of aqueous PVP. PVP, when complexed with Hl, shrinks in si2e as it loses hydrodynamic volume, possibly because of interchain complexation. ANS, on the other hand, causes the polymer to swell by charge repulsion because it behaves like a typical polyelectrolyte (88). 

Pigment dispersions are stabilized by charge repulsion and entropic, ie, steric or osmotic, repulsion. Although both types of stabilization force may be present in most cases, for pigment dispersions in solvent-bome coatings entropic repulsion is usually the most important mechanism for stabilization. 

Deviations from this generalization may have several sources, including charge repulsion, steric effects, statistical factors, intramolecular hydrogen bonding, and other structural effects that alter electron density at the reaction site. Hague - ° P has discussed these effects. 

FIGURE 16.6 Electrostatic destabilization of a substrate may arise from juxtaposition of like charges in the active site. If such charge repulsion is relieved in the course of the reaction, electrostatic destabilization can result in a rate increase. 

Figure 9.59 One of the first methods of preparing water-soluble QDs was to use thioacetic acid modification of the nanocrystal surface. This resulted in a negative charge on the surface of each dot that provides like charge repulsion of particles suspended in aqueous solution. The carboxylate group also could be used for conjugation with amine-containing molecules.

Figure 9.61 QDs containing carboxylate groups can be coupled to amine-containing proteins or other molecules using the EDC/sulfo-NHS reaction to form amide bond linkages. The intermediate sulfo-NHS ester is negatively charged and will help maintain particle stability due to like charge repulsion between particles.

---