Ceramic materials properties

Common approaches for the tailoring of nonmetallic (ceramic) materials properties involve topochemical methods (those where the crystal structure remains largely unaffected) and the preparation of phases in which one or more sublattices are alloyed. In principle, such materials are within the realm of CALPHAD. On the other hand, as has already been stated, extrapolation does not really aid the discovery of new or novel phases, with unique crystal structures. Furthermore, assessed thermochemical data for the vast majority of ceramic systems, particularly transition metal compounds, are presently not available in commercial databases for use with phase diagram software. This does not necessarily preclude the use of the CALPHAD method on these systems However, it does require the user to carry out their own thermodynamic assessments of the (n — 1 )th-order subsystems and to import that data into a database for extrapolation to nth-order systems, which is not a trivial task. 

Special aspects concerning the special treatment of ceramic material properties in modern CFD (Computational Fluid Dynamics) codes will conclude this small general survey on simulation in ceramic extrusion. 

This formulation stems from the microscopic assumption that inside the low-viscosity boundary layer the velocity increases linearly up to Us. Both parameters, and hjrj, depend on the specific ceramic material properties and must be determined, e.g. by rheometer measurement, prior to any calculation. Firma Braun (also authors in this book) determine the so called k-factor... 

Properties. Properties of stmctural siHcon nitride ceramics are given in Table 2. These values represent available, weU-tested materials. However, test methodology and the quaHty of the specimens, particularly their surface finish, can affect the measured values. Another important material property is tensile strength. Values obtained on Norton s NT154 material are 750 MPa at RT, 500 MPa at 1200°C, and 350 MPa (50,000 psi) at 1400°C (62). 

Ceramics. The properties of ferroelectrics, basically deterrnined by composition, are also affected by the microstmcture of the densifted body which depends on the fabrication method and condition. The ferroelectric ceramic process is comprised of the following steps (10,24,25) (/) selection of raw oxide materials, (2) preparation of a powder composition, (J) shaping, (4) densification, and (5) finishing. 

Certain glass-ceramic materials also exhibit potentially useful electro-optic effects. These include glasses with microcrystaUites of Cd-sulfoselenides, which show a strong nonlinear response to an electric field (9), as well as glass-ceramics based on ferroelectric perovskite crystals such as niobates, titanates, or zkconates (10—12). Such crystals permit electric control of scattering and other optical properties. 

R. Morrek, Handbook of Properties of Technical and Engineering Ceramics, Part 1 An Introduction for the Engineer and Designer, HMSO, London, 1985. Z. Stmad, Glass-Ceramic Materials, Glass Science and Technology, Vol. 8, Elsevier, Amsterdam, 1986. 

Tetraethylene glycol may be used direcdy as a plasticizer or modified by esterification with fatty acids to produce plasticizers (qv). Tetraethylene glycol is used directly to plasticize separation membranes, such as siHcone mbber, poly(vinyl acetate), and ceUulose triacetate. Ceramic materials utilize tetraethylene glycol as plasticizing agents in resistant refractory plastics and molded ceramics. It is also employed to improve the physical properties of cyanoacrylate and polyacrylonitrile adhesives, and is chemically modified to form polyisocyanate, polymethacrylate, and to contain siHcone compounds used for adhesives. 

---