Carbonyl oxides existence

A marked difference exists between the ozonolysis of C=C or C=N double bonds and C=C triple bonds as indicated in the formulas in the latter case, the fragments remain attached, and the carbonyl oxide couples intra- or intermolecularly with another partner. 

Using modern analytical methods, a number of transient intermediates and byproducts could be verified [19, 20]. The first step in the mechanism of ozonolysis is the 1,3-dipolar cycloaddition of the dipole ozone to the double bond of OA. A 1,2,3-trioxolane is formed, the unstable primary ozonide or molozonide. The primary ozonide collapses in a 1,3 dipolar cycloreversion to a carbonyl compound and a carbonyl oxide, the so-called Criegee zwitterion. Since OA is substituted with two diverse groups at the double bond, two different opportunities exist for the formation of carbonyl compound and carbonyl oxide. Again, a 1,3-dipolar cycloaddition of these intermediates leads to three different pairs of 1,2,4-trioxolane derivatives (cisltram), the secondary ozonides, which are more stable than the primary ones. Their oxidative cleavage results in AA and PA. 

Extensive spectroscopic and other evidences are available for all the three catalytic cycles. For the Co-based catalytic cycle, good kinetic, spectroscopic, and structural data on model complexes exist. For rhodium-catalyzed carbonylation, oxidative addition is found to be the rate-determining step. In contrast, for iridium-catalyzed carbonylation, insertion of CO is the rate-determining step. Thus kinetic measurements show that for 4.13 the insertion reaction is about 700 times faster than that for 4.11. Computational studies, as mentioned earlier (see 3.5), are also in agreement with the kinetic data. 

The most general methods for the syntheses of 1,2-difunctional molecules are based on the oxidation of carbon-carbon multiple bonds (p. 117) and the opening of oxiranes by hetero atoms (p. 123fl.). There exist, however, also a few useful reactions in which an a - and a d -synthon or two r -synthons are combined. The classical polar reaction is the addition of cyanide anion to carbonyl groups, which leads to a-hydroxynitriles (cyanohydrins). It is used, for example, in Strecker s synthesis of amino acids and in the homologization of monosaccharides. The ff-hydroxy group of a nitrile can be easily substituted by various nucleophiles, the nitrile can be solvolyzed or reduced. Therefore a large variety of terminal difunctional molecules with one additional carbon atom can be made. Equally versatile are a-methylsulfinyl ketones (H.G. Hauthal, 1971 T. Durst, 1979 O. DeLucchi, 1991), which are available from acid chlorides or esters and the dimsyl anion. Carbanions of these compounds can also be used for the synthesis of 1,4-dicarbonyl compounds (p. 65f.). 

Many variants of this procedure exist. Thus, Kano and coworkers have carried out the condensation of /3-keto sulfoxides with diaminomaleonitrile (Scheme 36) (78S372). This reaction probably yields an intermediate dihydropyrazine which is oxidized under the reaction conditions, and it seems likely that the condensation of the carbonyl group and the amine is the first step. 

The coordination chemistry of NO is often compared to that of CO but, whereas carbonyls are frequently prepared by reactions involving CO at high pressures and temperatures, this route is less viable for nitrosyls because of the thermodynamic instability of NO and its propensity to disproportionate or decompose under such conditions (p. 446). Nitrosyl complexes can sometimes be made by transformations involving pre-existing NO complexes, e.g. by ligand replacement, oxidative addition, reductive elimination or condensation reactions (reductive, thermal or photolytic). Typical examples are ... 

Perhaps because of inadequate or non-existent back-bonding (p. 923), the only neutral, binary carbonyl so far reported is Ti(CO)g which has been produced by condensation of titanium metal vapour with CO in a matrix of inert gases at 10-15 K, and identified spectroscopically. By contrast, if MCI4 (M = Ti, Zr) in dimethoxy-ethane is reduced with potassium naphthalenide in the presence of a crown ether (to complex the K+) under an atmosphere of CO, [M(CO)g] salts are produced. These not only involve the metals in the exceptionally low formal oxidation state of —2 but are thermally stable up to 200 and 130°C respectively. However, the majority of their carbonyl compounds are stabilized by n-bonded ligands, usually cyclopentadienyl, as in [M(/j5-C5H5)2(CO)2] (Fig. 21.8). 

---