Carbide relative rate requirements

Primary alkanolamine solutions require a relatively high heat of regeneration. Also excessive temperatures or localized overheating in reboilers cause the MEA to decompose and form corrosive compounds. An inhibitor system, such as the Amine Guard system developed by Union Carbide, is an effective method of corrosion control (52). Inhibitors permit the use of higher (25—35%) concentration MEA solutions, thus allowing lower circulation rates and subsequendy lower regeneration duty. 

Arrhenius parameters for nickel carbide hydrogenation 162) is close to both lines on Fig. 3. Compensation behavior for reactions on the carbide phase must include an additional feature in the postulated equilibria, to explain the removal of excess deposited carbon, if the active surface is not to be poisoned completely. The relative reduction in the effective active area of the catalyst accounts for the lower rates of reaction on nickel carbide, and the difference in the compensation line from that of the metal (Fig. 3) is identified as a consequence of the poisoning-regeneration process. After any change in reaction conditions, a period of reestablishment of surface equilibria was required before a new constant reaction rate was attained (22). 

We may also use the method of tint etching to produce color contrast in microstructure. Tint etchants, usually acidic, are able to deposit a thin (40-500 nm) film such as an oxide or sulfide on specimen surfaces. Tint etching require a very high-quality polished surface for best results. Tint etching can also be done by heat tinting, a process by which a specimen is heated to a relatively low temperature in air. As it warms, the polished surface is oxidized. The oxidation rate varies with the phase and chemical composition of the specimen. Thus, differences in the thickness of oxidation films on surfaces generate variations in color. Interference colors are obtained once the film reaches a certain thickness. Effectiveness of heat tinting depends on the material of specimens it is effective for alloy steels and other non-ferrous metals and carbides, but not for carbon or low alloy steels. 

---