Boron hydrides reactions with

A series of divalent lanthanide metal metaHaborane derivatives have been prepared by the redox reaction of metallic lanthanides and boron hydrides and by the metathesis reaction of boron hydride salts with LnCl2 where Ln = Sm, Eu, Yb (181,182). The species (CH3CN)3Yb[(p.-H)2B2QH22],... 

The properties of some boron hydrides along with those of other volatile hydrides are shown in Table 13.2. A very interesting reaction that diborane undergoes is one in which it reacts with double bonds in hydrocarbons. The reaction can be shown as... 

The adduct decomposed in about an hour at room temperature to a mixture of known boron hydrides. Reaction of the adduct with BF3 at —16° yielded a somewhat different mixture of boron hydrides. It is of interest that hydrogen gas was not formed in either case. 

It has been involved in many industrial explosions. Explodes on contact with aluminum + barium nitrate + potassium nitrate + water. Forms explosive mixtures with aluminum powder + titanium dioxide, ethylene glycol (240°C), cotton lint (245°C), furfural (270°C), lactose, metal powders (e.g., aluminum, iron, magnesium, molybdenum, nickel, tantalum, titanium), sulfur, titanium hydride. Reaction with ethanol + heat forms the explosive ethyl perchlorate. Violent reaction or ignition under the proper conditions with aluminum + aluminum fluoride, barium chromate + mngsten or titanium, boron + magnesium + silicone rubber, ferrocenium diammine-tetrakis(thiocyanato-N) chromate(l —), potassium hexacyanocobaltate(3—), A1 +... 

Dunbar 44,152,203) has studied the ion-molecule reactions of several boron hydrides BaHa, B4H10, BsHg, B5H11, and BeHio and the gas-phase reactions of diborane with the same higher boron hydrides and with... 

Polyhedral boron hydride derivatives with primary amino group were prepared by the reaction of cyclic oxonium derivatives with potassium phthalimide followed by removal of the phthalimide protection group with hydrazine hydrate (Figure 24.8) [31,51]. 

Boron trifluoride is used for the preparation of boranes (see Boron compounds). Diborane is obtained from reaction with alkafl metal hydrides organoboranes are obtained with a suitable Grignard reagent. 

The chain-growth catalyst is prepared by dissolving two moles of nickel chloride per mole of bidentate ligand (BDL) (diphenylphosphinobenzoic acid in 1,4-butanediol). The mixture is pressurized with ethylene to 8.8 MPa (87 atm) at 40°C. Boron hydride, probably in the form of sodium borohydride, is added at a molar ratio of two borohydrides per one atom of nickel. The nickel concentration is 0.001—0.005%. The 1,4-butanediol is used to solvent-extract the nickel catalyst after the reaction. 

Ethyl-2-methyl-3-(10,11) -dihydro-5H-dibenzo [a,d] cycloheptene-5-ylidene)-1 -pyrrolinium iodide (4.7 g) was dissolved in 7 cc of methanol. To this solution there were added 1.4 g of sodium boron hydride within about 80 minutes with stirring and stirring of the solution was continued for two hours to complete the reaction. The reaction mixture was acidified with 10% aqueous hydrochloric acid solution and then the methanol was distilled off. The residual solution was alkalized with 20% aqueous sodium hydroxide solution and extracted with ether. The ether layer was dried over magnesium sulfate and the ether was distilled off. The resulting residue was further distilled under reduced pressure to yield 2.0 g of 1-ethyl-2-methyl-3-(10,11 ) dihydro-5H-dibenzo[a,d]cycloheptene-5-ylidene)pyrrolidine (boiling point 167°C/4 mm Hg.). 

Azo coupling reactions with the polyhedral boron hydride decahydrodecaborate dianion B10Hio"" (12.164, Fig. 12-9) were discovered by Hawthorne and Olsen (1964, 1965). 

---