Magnetic balance

Yam] Magnetization measurements were carried out fi-om 4.2 to 300 K and up to 10.3 kOe by a torsion magnetic balance Magnetic phase diagram of flie Ti (CrJci Q2 system wifli x < 0.5... 

Som] Squid magnetometry and Faraday balance Magnetization and magnetoresistance... 

Electronic balances, magnetic stirrers, and sieves for screen analysis. 

Round bottomed flask (100 ml) with stirrer bar and septum (pressure balance ) Magnetic stirrer Silver foil Syringes... 

S. Hirose, "Wall Climbing Vehicle using Internally Balanced Magnetic Unit", Tokyo Institute of Technology, Japan, 1987. 

Sat] Magnetic measurements (magnetic balance) Magnetization, magnetic moments... 

Bur] Faraday type balance Magnetic phase transition... 

Gouy balance A balance for the determination of magnetic susceptibility. The sample is weighed in and out of a magnetic field and the susceptibility is calculated from the difference in weights. 

In 1961, enough einsteinium was produced to separate a macroscopic amount of 253Es. This sample weighted about O.OlMg and was measured using a special magnetic-type balance. 253Es so produced was used to produce mendelevium (Element 101). 

The resulting overall energy balance for the plant at nominal load conditions is shown in Table 3. The primary combustor operates at 760 kPa (7.5 atm) pressure the equivalence ratio is 0.9 the heat loss is about 3.5%. The channel operates in the subsonic mode, in a peak magnetic field of 6 T. AH critical electrical and gas dynamic operating parameters of the channel are within prescribed constraints the magnetic field and electrical loading are tailored to limit the maximum axial electrical field to 2 kV/m, the transverse current density to 0.9 A/cm , and the Hall parameter to 4. The diffuser pressure recovery factor is 0.6. 

Cementite, the term for iron carbide in steel, is the form in which carbon appears in steels. It has the formula Fe C, and thus consists of 6.67 wt % carbon and the balance iron. Cementite is very hard and britde. As the hardest constituent of plain carbon steel, it scratches glass and feldspar, but not quart2. It exhibits about two-thirds the induction of pure iron in a strong magnetic field, but has a much lower Curie temperature. 

Electrical Connections. Electric current is brought from the transformers by air-cooled copper busbars and close to the electrode by water-cooled bus tubes and flexible cables, connecting to water-cooled copper contact plates at the electrode. The plates are held against the electrode by hydraulic pressure. The connectors are as short and as balanced as possible to allow cancelling of magnetic fields associated with individual conductors. 

---